Find a reliable appliance technician in Windsor VIC

Remove existing hard wired oven and install PowerPoint to enable installation of replacement plug-in electric oven. Oven supplied is a Standard 600mm wall oven. Photo of existing oven and space attached

My janome sewing machine has just decided to shut itself out of nowhere. It works just bobbin/bobbin case issues that I cannot rectify myself. I do not drive and there seems to be NO REPAIR places anywhere near the Southside of Melbourne… I would like someone to come have a look at it and fix it thanks :)

My fridge and freezer is not cooling/freezing properly and am wanting to get it fixed

Wine fridge needs the compressor replaced

Looking for a qualified electrician who is familiar with security cameras we have an existing electrical fit out but are looking to expand our cameras from 8 to 16 channel. Job is $50 a camera there’s a lot of wiring already done too. Should be 4-6 hours of work .

Washing machine not spinning, I can't open drain filter, clothes coming out wet. Front loader Bosch clasixx

Need a dishwasher installed, and plumbed into the sink in next cabinet (I’ll be creating the cavity for freestanding d/w to the left ready for you to install) Registered plumber only. Needs compliance cert. on completion

I have a large Ramalhos deck oven that the 3 decks need to be dismantled for removal off the premises. I can arrange the removal, but need the 3 decks and stand dismantled.

Replace old seal on front loader machine with a new one, and provide new hot and cold hoses. LG Inverter Direct Drive Model number: wd14022d6

install a dryer onto the wall in an aprtment

Check spring of threading system on old Janome L-352-L353 has snapped and needs to be replaced

Small job: Need x2 holes in ceiling for x2 ducted heating vents clipped and installed in 3.3m high ceiling. Ducts are connected and in ceiling ready to be clipped in/installed

Hello! We have an issue with a washing machine flashing on water inlet / drain NOVOTRONIC NB945

Range hood not operational. Fuse has been previously replaced (in 2019) — further inspection required to determine if a faulty component is causing repeated fuse failure.

The Fisher & Paykel DD60S17 dishwasher emits a light burnt smell and continuously beeps with the last two LEDs on. Note - There is no water in the base tray.

Belt broken dangling. Motor working fine. Looking for solutions. NO to onsite extra proposals.

THE TASK IS SITUATED IN WINDSOR, VICTORIA I just need help adjusting some of my taps/ hoses to get my washing machine working again. The hose is situated into the drainage hole so that’s all fine. It’s just there’s no water being released into the washing machine so I’m unsure if the taps are not connected properly to the washing machine.

Climb up a ladder 2/3m high, screw in (with your own electric drill) 2 ring security camera (battery powered) & clip them into place. Ensuring the video is accurately positioned.

The washing machine won’t drain and appears to be stuck on the same cycle. It won’t change cycles when adjusted

I have an electric 4 burner stove top and needs to be replaced with 4 burner gas top. Gas line is available underneath. Plumber will need to get gas fitting pipe approx 1.5 mtrs to connect the burner to gas outlet. The cut out is fit to size and the gas burner should slot it (already checked)