Find a reliable appliance technician in NSW

I need someone to fix my Nespresso Vertuo Pop. It keeps dispensing too much water with the pods and I keep wasting them. I think it may need descaling (I don’t have the descaling stuff nor do I know how to do it for this machine). But I am unsure if that is the issue

I’m looking for an experienced coffee machine technician to set up and calibrate a commercial espresso machine at my small shop. Machine: Bezzera B2016 (Otto Woody) Location: Rooty Hill Flexible with date but would like it done ASAP.

Connect new dishwasher to water source in kitchen

From last two days my fridge upper part is not doing cool i don’t know what happened

I'm getting an F1 error on my dishwasher, and it's making an unusually loud noise. The noise continues even after I turn the dishwasher off and only stops when I switch off the power at the main switch. Could you please advise what might be causing this and how it can be fixed?

The freezer and ice maker on my LG fridge (Model: GF-L570MBL) seem to have an issue. The freezer intermittently fails to keep the contents frozen, causing the food to thaw, and the ice maker stops producing ice. The only way to get them working again is to turn the fridge off and on and reset the ice maker. This has now been happening every couple of days, so it appears there is an underlying fault that requires inspection and repair.

I have not used my brand new dishwasher for past few years. I have recently started to use it and noticed that after wash cycle, some water is staying on bottom of dishwasher- water level is slightly above filter. I cleaned cylindrical filters and tried as well. Need licensed person to fix the problem.

Install IKEA integrated dishwasher

We installed a washing machine but I think we did it wrong as it’s coming up with e3, error code which is a drainage issue so I think the hose is kinked or possibly where it goes into s bend needs a hole drilled in it probably a 5 minute job for someone who knows what they’re doing. Ideally today or tomorrow.

Hi there, I need a licensed NSW gas fitter to rectify a gas installation defect identified by Jemena on my property in Eastwood. The defect noted on the certificate is: "Earth stake & weep holes in exclusion zone". Scope of work: Relocate/extend the gas regulator vent line or pipework to ensure it is clear of the electrical earth stake and building weep holes (per AS/NZS 5601.1 standards). Perform a pressure/leak test upon completion. Issue a formal Certificate of Compliance and a Leak Test Certificate as required by Jemena. Please refer to the attached photo of the Jemena Non-Compliance notice for exact details. Must be fully licensed and insured in NSW. Please provide your license number when offering. Flexible with timing but needs to be completed within the next few days. Thanks!

uninstalling the old oven and replacing it with new oven on 3 July between 7AM - 8AM

Gas isn’t coming through to our heater. Need a professional to repair it.

Finally giving in - need to install plugin range hood within existing cutouts and reattach cupboard doors + remove old induction stove top and install nose one (hardwired) stripped screws up top of range hood through cupboard will need removing

Remove of kickboard/ plinth below dishwasher, appears to be siliconed in place

Need freestanding cooktop replaced. I am planning to order Chef 540mm electric cooktop .Please quote for installation cost. It's like to like.

Need a hole cut through the side panel of my laundry cabinet so the washing machine/dryer drainage hose can pass through to the waste pipe. # Cut a neat hole in the laminated cabinet panel # ring suitable hole saw/tools # Ensure a clean finish with no damage to cabinetry # Photos attached for reference Looking for a handyman, carpenter, or cabinet maker. Flexible timing. Location: KELLYVILLE

Mr Coffee machine F11 fix maintaince , pressure in machine issue

Gas stove , my nephew installed it but I have fear it might leak or not installed properly!! Its a 15 min job so dont send quotes costing hundreds

Range Hood Installation Looking for an experienced installer to replace my existing kitchen range hood with a new one. Job details: * Remove the old range hood. * Install the new range hood in the same location. * Connect to the existing power and ducting (if compatible). * Test the unit to ensure everything is working properly. * Please bring your own tools.

Need someone to fix my washing machine. Can’t open the bottom to clean it, I’ve tired pliers. It still washes fine