Find experienced insulation contractors near you

Insulation of a pergola with 3 sides 3x3

Removal of large foam insulation panels, bricks and garden debris

Looking for a self employed labourer with a valid cscs card to start work on site installing loft insulation alongside an experienced team, candidate must be fit and eager to learn with a full driving license. Competitive rates of pay to be discussed.

I’m looking for a professional and experienced contractor to carry out a complete bathroom renovation. The work includes: * Removing the existing bathroom suite * Plumbing work * Wall and floor tiling * Installing a new toilet, sink, bath/shower, and fixtures * General finishing work, including sealing and making good The ideal contractor should be reliable, experienced, and able to deliver high-quality workmanship. Relevant qualifications and previous experience are preferred. Request a quote after business and property

I need a 40ft shipping container insulated.

2 tasks for a competent carpenter: 1. Create a narrow hallway console table with 2 legs like the 3rd image below from a solid beech wood table top 200cm length x 20cm wide x 3cm depth and solid beech legs 85cm high. (we have the table leg connectors and brackets to hold in place on the wall). We need the table top to be routed at the ends to softly rounding the 2 front corners (around a 15–20 mm radius) and taper the underside in a gentle 45° chamfer for about 15 mm. Task 2, to cut and fit x 2 60cm wide x 240cm high oak insulation panels to a wall.

'Quick Garden office Pod' 2m x2m structure 1 to 2 days work - budget to be discussed Have already done one quarter of it. Base and wall structure etc https://www.quick-garden.co.uk/garden-office-pod-premium-l-34mm-cladding-2x2m-66x66-4m2.html?_gl=1*1em4j4w*_up*MQ..*_gs*MQ..&gclid=EAIaIQobChMImb7p-oaElgMVUppQBh3GLQiREAAYAiAAEgJwivD_BwE

I’m looking for someone experienced in automotive upholstery, vehicle interiors, or camper conversions to complete the following work on my Land Rover Discovery 3. I will supply all materials. Job Required * Remove the headliner. * Remove all existing headliner fabric and old foam backing. * Prepare and clean the headliner board. * Install new black 2mm foam-backed automotive headliner fabric. * Install butyl sound deadening sheets to the roof (approximately 30–40% coverage). * Install 6mm self-adhesive closed-cell foam insulation where appropriate. * Remove all three sunroof blind cassettes. * Attach blackout fabric to the existing mesh sunroof blinds (by sewing or another professional method that allows them to retract and operate correctly). * Reinstall and test all three sunroof blinds. * Refit the headliner and all interior trim. * Ensure everything is clean, secure and functioning correctly before completion. Materials Supplied by Me * Black automotive headliner fabric * High-temperature headliner adhesive * Butyl sound deadening sheets * 6mm self-adhesive closed-cell foam insulation * Blackout fabric for the sunroof blinds

I’m looking for someone experienced in automotive upholstery, vehicle interiors, or camper conversions to complete the following work on my Land Rover Discovery 3 I will supply all materials. Job Required * Remove the headliner. * Remove all existing headliner fabric and old foam backing. * Prepare and clean the headliner board. * Install new black 2mm foam-backed automotive headliner fabric. * Install butyl sound deadening sheets to the roof (approximately 30–40% coverage). * Install 6mm self-adhesive closed-cell foam insulation where appropriate. * Remove all three sunroof blind cassettes. * Attach blackout fabric to the existing mesh sunroof blinds (by sewing or another professional method that allows them to retract and operate correctly). * Reinstall and test all three sunroof blinds. * Refit the headliner and all interior trim. * Ensure everything is clean, secure and functioning correctly before completion. Materials Supplied by Me * Black automotive headliner fabric * High-temperature headliner adhesive * Butyl sound deadening sheets * 6mm self-adhesive closed-cell foam insulation * Blackout fabric for the sunroof blinds

Mixed of wood, glass, insultation and felt

Labour only, I will supply materials, skip etc Remove carpet and floorboards and clear debris from underneath. Install membrane like this one. Rhinovent Ultra Breathable Membrane Install 100mm mineral wool insulation, like - Knauf floor insulation Install vapour control layer like - Damplas Vapour Control Layer. Then put floorboards back. If a few break and need replacing then so be it. But id like to keep as many as we can. Skirting will remain, I dont want to take it off and reveal a bad state of walls. There are air bricks on either side of the living room. Needs clearing out underneath to open up air flow. Also insulate under the stairs where the cupboards are. One houses the electrics and gas so need someone experienced with this. Need someone experienced with insulation View the area here https://youtube.com/shorts/2fqVo_3iu-M?is=_A5OsYyQpks_tRoz

Insulate the extension walls and install plasterboard, ready for plastering. Remove the existing foam layer from the ceiling, then fit new plasterboard throughout the ceiling, leaving all surfaces prepared and ready for skimming. Ensure all boards are securely fixed, joints are properly finished, and the area is left clean and ready for the plasterer. Supply amd fit

Looking for a handyman/carpenter to insulate and internally finish a 15ft x 8ft timber garden shed/summer house. Scope of work: Install insulation to walls and roof (foil/multifoil or equivalent). Tape and seal insulation joints where required. Fit thin plywood (approx. 3–6mm) or similar boarding over the insulation to provide a neat finish suitable for occasional home office use. Floor does NOT require insulation or covering. Shed dimensions: approximately 15ft x 8ft. Please note: This is not a full garden office conversion. No plasterboard, plastering, skimming, decorating, electrics or floor works are required. I am simply looking for the walls and roof to be insulated and neatly covered with thin plywood (or similar sheet material) to provide a clean, practical finish suitable for occasional use as a home office. Looking for a tidy finish and completion within a day - can extend into second day for final touches if needed, Please quote for labour ONLY and share material cost estimations

we have removed our carpets already. I need the existing floorboards/subfloor inspected, damaged areas repaired with new chipboard where needed, and insulation installed between/under the floorboards. This is the floorboards in 4 bedrooms and a hallway.

Install lost insulation and fill holes

Installing insulation wallpaper bought online on E-mosaictile.com on all walls of my daughter's bedroom. It involves mobing furniture (included some anchored to the wall) and making gaps for switches and window. Would need to be completed outside before 5.30pm ideally. Can provide more details upon request.

Hi AirTaskers We have built a timber frame garage, have purchased 55 sheets of 150mm Celotex PIR installation - was planning to fit ourselves but struggling for time. Simply a job of cutting and taping = previous experience required as important its done to a high standard

6mx3m garage needs to be converted to office/gym space. Weatherproofing and insulation required

I need someone to look at why dark patches appear on edges/corner of the ceiling. I suspect it may be about insulation at the edge of the eves but would like someone to take a look. - Due date: Flexible

I need someone to come and advise me on what insulation my house has and what the ideal insulation should be, bearing cost in mind. A plan to be created. Thank you!