Find a professional heating and cooling technician near you

Current boiler failed due to water damage. I have purchased a brand new electric boiler exactly the same and need qualified engineer to remove old one and install new one to benefit of the warranty that comes with it. It's a SlimJim by Electrical Heating Company Additionally, the whole system includes a water tank that needs servicing as part of new boiler installation.

Urgent boiler service, water pressure low in boiler.

The ensuite shower has a leaking and stiff concealed thermostatic mixer valve. There’s visible staining below the trim plate, suggesting the internal valve has failed. There’s no access behind the tiled wall, so the replacement will need to be completed through the existing opening without removing tiles. Scope of Works: • Isolate water supply and remove existing trims and controls • Supply and install a new dual-control concealed thermostatic mixer valve (chrome finish) compatible with existing pipe centres • Reseat and reseal trims and faceplate • Test the shower for correct function, temperature regulation, and leaks • Clean away any visible staining and leave the shower in full working order Budget: £200 (labour, materials, and parts included)

I need the hole for boiler pipes expanded. I also need a small hatch in laundry room Ceiling made so plumber can access other end of pipe when necessary. This should Be closable so will need a hinge and closing . It needs to be about 300mm square.

I suspect there is something wrong with my underfloor heating as it doesn’t get warm enough. If someone knows about the control valves I think they’re showing an error.

Loft insulation needs putting back after new roof was fitted. Loft contents clearing and tidying.

Downstairs heating is only underfloor. Seems like a technical issue as upstairs heating is working

Install 6 sq m electrical underfloor heating mesh on 2 rooms. Carpet install and removal to be done by owner.

Heating pressure drop. Heating engineer confirmed it could be a leak in the system and thermal imaging can confirm the leak

The Problem: Hot water stopped working recently after a circuit trip Hot water runs for ~1 minute then goes lukewarm/cold System pressure is fine (topped up to 1.5 bar) ViewSmart controller is on and set to Comfort mode Heat meter shows good inlet temp (65°C) but poor output temp What I've Already Done: Checked and adjusted system pressure Confirmed KWF mode is set to Comfort Attempted power reset Likely Issues (to save you time): Based on troubleshooting, the problem is most likely: Failed/stuck PICV actuator (Item #2) - not opening properly after power cut Clogged Y-strainer on primary circuit (visible corrosion from an old leak present) Scaled/fouled plate heat exchanger What I Need: Gas Safe registered heating engineer with HIU/district heating experience Diagnosis and repair of the faulty component(s) Service/clean the corroded Y-strainer while accessing the system Test to ensure hot water is restored Access: Easy access to HIU in utility cupboard Flat is in a managed building with district heating Please include in your offer: Your experience with HIU systems (especially Evinox ModuSat) Estimated time to complete Whether parts (actuator, strainer seals) are included or extra Your Gas Safe registration number Looking for a professional who can get this sorted quickly. Happy to provide more photos or details if needed.

Looking fir a certified plumber to service my boiler

I just need a diagnosis of what parts thwn i can order them for the handyman who gives me the list to fit them

Small three radiator system in my flat, 5 years old, needs flush because low flow through the system.

I need a certified technician to service my boiler and fix the timer as it gets stuck during the schedule time range. This work request is to do both service and timer fix.

I’m looking for a qualified heating engineer or someone experienced with Wiser radiator thermostats to check all existing thermostats in property at W13 9JZ. The system is already set up and controlled through the Wiser app. One of the thermostats has lost connection and needs to be reconnected. The job includes: • Checking all thermostats to ensure they’re connected to the main system • Replacing batteries if needed • Reconnecting any devices that have lost connection

Remove broken 3rd gen Google Nest thermostat, replace with new 3rd gen Google Nest thermostat. Placement is wall mounted.

My radiators are not working with my usual settings on the thermostat panel. The hot water and Towel rail are working very well. It might be a problem of boiler setting/connection.

I need to get an annual service and certification of my Vaillant gas boiler - ecotec plus 832

Hello there, We need help replacing the radiator valve. The current radiator is constantly heating and won’t turn off, the valve seems to be stuck or faulty. It’s essential to stop the radiator from blasting heat, so this needs to be fixed as soon as possible. Please include your availability and offer on this task. Thanks, Victoria

Top heating element is stuck and wont unscrew i have tried but not moving, the tank has been drained down as far as the top element, only contact if you are 100%, you can remove, boiler is a pulsa coil model, drain valve also broke at the bottom, new elements are on site, if you can replace both that would be great