Find experienced insulation contractors near you

An area of the loft needs boarding up so can be used as a wardrobe. The door needs moving back and a new partition wall added. The roof has old insulation that needs replacing. Some wooden floor we have left needs putting down in a v small area to match.

I live in a ground floor flat and my living room is by the front door. The neighbours above make a lot of noise when entering and leaving the house.

Hi AirTaskers We have built a timber frame garage, have purchased 55 sheets of 150mm Celotex PIR installation - was planning to fit ourselves but struggling for time. Simply a job of cutting and taping = previous experience required as important its done to a high standard

Install lost insulation and fill holes

Help a carpenter for a day installing insulation and plasterboard to walls and ceilings.

1.a) to check if the roof felt is good condition or needs repair. if no repair then 1.b ) need the widths & length of gaps between roof trusses. to be noted down and label eg 7,a,b,c then 8 a, b , to do about 6-8 pieces at a time 2) To go to insulation downstair, and cut with saw to precise or near precise size to mark with pen and keep fairly straight saw cuts along lengths. to then label 7 a, b ,c and the top to be mark ' top' 3) then to go back up and trim with saw so that the piece fits in between roof trusses. regularly there will be wood that will not allow the insulation to sit in correctly the indentation will need to be sawn out , this process to be repeated. 4.) use of thin bits insert in gaps on the side and create corner pieces eg trianglar pieces for top of roof. Once the heat gun arrives, eg by saturday then repairs can be made on roof felt. Repair process, view splits in felts, dust down with brush or glove, then cut flash bands to size , use heat gun, to melt tar material in order to stick over 6/7 split. Then the insulation can be inputted in. Some of this process has been already done.

I need someone to look at why dark patches appear on edges/corner of the ceiling. I suspect it may be about insulation at the edge of the eves but would like someone to take a look. - Due date: Flexible

I need 2, 1.2 m blinds put up on my wall over the windows it is URGENT this is done as soon as possible as it is getting extremely hot and my room is sun facing so my room is hot. Preferably someone with their own drill and tools it’s IKEA blinds so everything comes in a pack.

I need someone to come and advise me on what insulation my house has and what the ideal insulation should be, bearing cost in mind. A plan to be created. Thank you!

Hi there, I started renovating my summer house myself but unfortunately don’t have the time to complete the project, so I’m looking for someone to come in and finish it properly. Work required includes: * Roof insulation to be completed (walls have already been partially insulated) * Internal cladding of the walls/ceiling with plywood * Lino flooring supplied/fitted * Installation of a proper secure lock on the door * Window beading to be fitted/finished * General touch-ups to the existing paintwork using barn paint to make everything look tidy and finished The structure is already in place and some of the prep work has been started, so it’s mainly a case of completing and tidying the project to a good standard.

The sides of the loft have already been insulated. However, the front section has been made into a triangular room, and there are boards down. They've been nailed down.Which is the big problem. The loft insulation either has to go over the time of the existing boards, which i'm not sure would meet installation standards. Alternatively, the boards need to come up. And the insulation run straight across under the walls which might need to be cut away.

Remove old insulation from loft and put in a new one

Need a cat flap insulated

Hi, I’ve got a timber garden shed in my back garden in Luton that I want to turn into a proper usable workspace. I want to hear your recommendations. I want this converted into warm, dry, well-lit shed we can use comfortably year round. About 6 metres long, 2.5 metres wide, apex roof. Timber frame walls already built inside. Windows down one side. Wooden floor. One existing electrical socket already installed. What I’m looking to get done: The shed needs insulating throughout — walls, roof and floor. Once insulated it needs lining so it looks clean and finished inside. All gaps and draughts need sorting properly. The electrics need upgrading — I want more sockets, lighting, so I’m not relying on an extension lead. I want it done safely and correctly. Please tell me what you’d recommend for insulation — type, thickness, brand. Tell me what you’d use to line the walls and ceiling. Tell me what you’d do with the floor. Tell me what you’d do with the electrics and whether I need a separate consumer unit or can work off what’s there. Give me a full product list with your recommended quantities and where you’d source them. Then give me your total price for labour and a separate estimate if you can also supply the materials.

Loft clearance (insulation, ) disposal, cleaning (vacuuming)

Remove loft insulation Fit ceiling fan

* Light cleaning (dust/debris only) * Remove old insulation * Supply and install new loft insulation * Please include waste disposal in your quote * Confirmation if insulation material is included

I just need the insulation and walls up so I can get the electric set up. I need this done ASAP

New wardrobe installation.

1) Carefully remove all floorboards downstairs and set aside. 2) install timber battens between joists 3) install rigid insulation minimum 50mm thick between floor joist, above battens. 4) underfloor heating pipework installed between joists (materials supplied by us). Joists to be notched where required to allow pipework to pass through 5) dry sand a cement mix screed to the placed between joists above underfloor heating pipework and levelled flat. 6) fix down floorboards over the top of all, fixing floorboards into the joists.