Hire a reliable appliance service in West Midlands

Fresstanding old washing machine needs to be installed. Hole needs ti be drilled in cabinet so can be connected to the pipes under the kitchen sink. Plumbing there already. And an extra plug socket needs to be added cos currently there is onky a single plug socket nearby for the fridge

So basically I need someone to put my fridge filter on for my Samsung fridge

the flex hair styler only worked for a few seconds and then stopped not sure what's happened if it needs a new plug or fuse....I don't know how to do this so I need help

Reebok One GT40s Treadmill, the walking and speed works fine but the incline does not activate or work.

I need someone to install my gas stove and remove electric stove

I have a new shark flex hair styler but it works for a few seconds and then stops not sure if something is wrong with the plug or something wrong with the actual appliances

I want to fit my washing machine in my extention area it has connections of tap and electricity i need plumber to do this job i believe . please note it is fully covered now . These aree images before contruction completed .

I have an integrated cooker hood already installed in my kitchen. It is currently on recirculation and I want to switch it to ducted extraction. I need someone to: • Core drill a 150mm hole through the external wall for the ducting, plus a hole through the top of the wall cupboard above the hood if the ducting needs to pass through it • Fit the ducting from the hood outlet to the outside • Fit an external wall vent/grille with a backdraft flap and seal around it

The catch on our woodburning stove has come loose and needs fixing/replacing. Also, the rope seal may need replacing.

Our Hoover H-Wash 300 washing machine is stuck in a corrupted software loop (Demo Mode). Interestingly, the Start/Pause touch button works perfectly fine when the dial is turned to Wi-Fi mode, but it goes completely unresponsive on manual wash cycles. It looks like the main electronic control board (PCB) needs to be factory reset, reflashed, or replaced. Hoover corporate wants an absolute fortune to look at it. Seeking a great local independent trade expert who can handle appliance electronics/PCBs at a fair price? Based in Birmingham.

I need my new washing machine installing. We don’t have another one to recycle

I need a Gas Safe registered engineer experienced in gas hob repairs to inspect and fix my five-burner hob. Only the back-left burner works. The other four do not light. There are also damaged or missing control knobs, as shown in the photo. Please identify the fault, explain what needs repairing or replacing, and confirm the total cost before carrying out repairs.

Washing machine gasket door seal replacement

Downstairs radiator not heating up as used to be

A gas hob needs to be removed and another hob needs to be put on. We then need the gas to be turned back on at the mains.

I have a Siemens EQ 500 at home and the brewing unit got jammed and stuck in an incorrect position. Is this something you can help me with? And if so, what are your fees? I'm based in Birmingham City Centre. Thanks a lot Nadime

New hard wired cooker hood need to be connected to power . There’s a nearby socket not sure if this can be used via fused spur

Provision for drainage and water supply plumbing for new dishwasher. Was hoping this can be connected through tap and sink on the adjacent toilet The dishwasher will be placed in the space currently occupied by the pantry (this will be removed beforehand) Electric is already supplied

One of my heaters is not turning off and this continue to create unnecessary heat in the house during this summer. I need someone to fix it

Water is draining from the soap compactment instead of the drainage hose