Hire a reliable appliance service in Manchester

Power cable ok (USB and buttons light up) but no response when buttons pressed. Chair stuck in fully extended position.

Take out old cooker hood and install new. Will need to cutout 3cm wood from front and about 3cm each side to allow the vent of the hood to fit.

Filter broken / dishwasher not working

CDA dishwasher lights up but lights up saying it needs salt in it. ive tried it, replaced the little door but pressing other buttons does nothing. ive tried a bunch of combination of buttons. Might be a PCB needs replacing or salt tank looking at. Thing doesn't do anything, wont start at all. Been like that since been in the flat

i need someone who can cheak if there is any gas connection in the room and if there is any gas connection then install the gas heater for us

Samsung fridge freezer rb37j5330sa need to be checked and repaired

Still electric chainsaw not used for 18 months. Now not working.

I need someone to disconnect a gas/electric cooker then come back shortly afterwards to reconnect a new duel fuel cooker

The handle of my oven needs a replacement.

I need a Gas Safe engineer to repair a hob ignition issue, carry out a gas safety check, and PAT test a fridge and washing machine - ideally all in one visit

Fix a toddlers ride on electric powered quad brand new fully charged not working

Balanced flue gas fire. The ignition has stopped working

I need an Ikea oven replaced that has blown a fuse(basically not working at all but there’s power to the cable we have checked). Ikea are sending a new one out so I will need the old one removing and a new one fitting. I may also need the plug behind the oven changed (based on your opinion it just looks like the wiring wasn’t done properly/it doesn’t look great.

as they are battery powered there is no need for wiring to be done we need the fittings drilled and screwed to brick

I need an existing gas pipe cut down and capped off. It was previously cut and capped. The work must be carried out safely and in line with gas regulations to ensure no gas leaks. Details: * Gas pipe to be shortened and securely capped * Must be done by a Gas Safe registered engineer * Safety is a priority

I want to fit a integrated dishwasher where there used to be an under counter freezer. There's electric but no plumbing there. The mains water pipe rings through that cupboard towards the kitchen sink so there's cold water there. Waste water pipe will need to be drilled out through exterior wall. (Brick cavity wall). There's a drain directly on the other side of the wall for a gutter down pipe. The freezer will already be removed. Prefer messages rather than phone calls thanks. Can send a video if you want but won't let me attach here. I have no idea how much this should cost but I had to put something in the budget to place the advert, certainly open to negotiation.

There are 4 rubber plugs in the back of the washer dryer that have screws in. They need to be pulled out but I’m unable to get them to budge and I don’t want to damage the machine. Please only enquire if you have done this before. Ideally you will be able to do this without opening up the machine / voiding the warranty.

was sparking now doesnt the key switch is broken but can be bypassed its at a garage so cant give exact model apart from honda 3kw about 6 years old

Need washer plumbed in and electric cooker connected.

To replace and install a new smoke alarm (Brand - Deta )