Find experienced local tradies in NSW

Gyprock plasterboard patching of about 25 ceiling holes from old down lights, installation of one ceiling access panel, patching of one ceiling opening about 600mm square and fixing and setting of board around 3 skylights

Small patching and creating a small box around a frame 300 by 300 mm

2 power points need replacing, buttons gone in

Set, tape, sand and finish a 4 x 3 metre room that already has already been sheeted.

Obviously $10 is not our budget but our task requires a figure entered. Please quote per job description. I said which will be available after April 14. Pls quote to fit and supply: Take out existing X 2 pocket doors in a bedroom, replace with gyprock ~2.5 m wall ann match skirting, supply and fit 1 x solid core door with handle (to be supplied) on rhs of wall. Paint. Remove waste and dispose. Wall not supporting.

I need to enclose a room. Which is 3 walls and also need to add a door. Cover the ceiling as well. Measurements are 10m x5.4m

Plastering carefully over what I suspect is 1960s asbestos popcorn ceiling. All rooms, except the bathroom are needed (approx. 30sqm).

Wanting a gyprock to remove window and open up to fit roller shutter width dimensions is 145cm so need opening of 120cm

I need these two concrete ends rendered / concreted that have been broken off when the gutter was replaced. See last photo for what it should look like.

There is a small area on the ceiling which needs a light patch-up and paint

Need small hole in plasterboard wall repaired (photo attached). Require patch, sanding and paint match. It’s a rental property so needs clean professional finish. Flexible with time — can be done anytime this week. Budget around $150 but open to reasonable offers.

Install 2 solar lights & 1 solar camera on brick/render wall must have tools and experience Tidy work is appreciated

Please provide the quote I need a licensed electrician for the following: 1. Replace a burnt/damaged 10A wall socket (GPO) • See attached photo • Check wiring behind wall for any damage 2. Install a new dedicated 15A outlet for EV charging • Run directly from switchboard (located on the other side of the wall) • Include RCBO / safety protection • Suitable for continuous EV charging load Notes: • No adapters will be used — proper EV setup required • Easy access, short cable run (same wall as switchboard) • Please include materials + compliance certificate

4 bedroom house need: Deep Clean-Up and handy man work Two toilet seats and shower room need to be repaired (the toilet seats are loose, and one shower head is missing). Fix broken glass, front window is broken

Looking for a licensed electrician to replace a faulty power point connecting to my fridge. The outlet works for low-power devices (e.g. phone charger)It does not work for higher load appliances like a kettle or fridge.Other outlets in the apartment are working fine. Fridge works when plugged into a different outlet Seems like a loose connection or faulty socket that needs repair or replacement. Location: Rosebery, Sydney Timing: ASAP Parking: Available nearby

I have enclosed a outside cabana creating a teenage retreat room. It has an outdoor power point and I want to convert that into an internal one and reconnect the outdoor powerpoint about a metre outside the room. I also want a new powerpoint installed onto a new wall. Access is easy through an open roof cavity and existing ceiling powerpoint about a metre away from where I would like the new powerpoint.

Looking for an experienced handyman or insulation installer to replace damaged ceiling gyprock and install foil insulation under the roof (as per attached photo). Scope of work: • Remove damaged ceiling gyprock • Supply and install new gyprock/plasterboard • Tape, set, and sand joints (ready for paint) • Install foil board / sarking insulation under roof rafters (like existing in photo) • Secure insulation neatly between timber framing • Re-inforce the rest of ceiling and set finish. Clean up and dispose of waste

I need a power point put in in my hallway! There is one on the other side of the wall so it should just be a matter of connecting through to that one

Hi, I have a double power point in my kitchen that is broken. Looking for a licensed electrician to replace it with a new double GPO. I am located in Epping (near Rawson St). Preferably looking for Alan T. if available! Thanks.

I need to fit a double power point to the wall of the lounge room, I have removed the skirting board so all you will need to do is drill through the masonry wall and connect to the wiring shown in the photo on the exterior side of the wall, I will supply the power point and connectors.