Find experienced local tradies in North West Melbourne

Finish off a incomplete render job to a facade of a shopfront. Involves rendering around framing and general blending in in readiness for painting.

Plaster for a double brick wall and 18 ceiling tiles . 10 sqm of plaster and 18 ceiling tiles

Need a power point installed in the laundry cabinet for washing machine, Nearest power point is pretty close, happy to send you a photo

I have 2 frames about 12m wide and 3m in height required some plastering. It is a commercial proper so would like a built that will be firstly removable.

Looking for a roof plumber to install flashings, side cappings, guttering, and a small downpipe on our newly built verandah. The frame and Laserlite roof are already completed — this task is for finishing off the roofing edges and water management. ⸻ Details: • Verandah size: 4.5m wide x 2m deep • Roofing: Laserlite sheets already installed Materials supplied by us: • Rear flashings to seal Laserlite roof to house fascia (there are 3 seperate flashings due to a small section of verandah roof running past the eave - see photo) all cut to size and rough length • Capping for exposed side edge (cut to size) • Gutter for front edge and brackets (cut to size) • Pop fitting You’ll need to supply: • Short section of 90mm downpipe (approx. 1–1.2m) to connect gutter to nearby water tank • Fixings, sealant, and tools Scope of work: • Install rear flashings between verandah and house fascia • Fit side capping neatly along exposed edge of roof • Install front gutter with pop hole (next to tank side) • Fit short downpipe section into water tank inlet ⸻ Timing: ASAP ⸻ Please only apply if you have experience with roofing/flashings/guttering. Photos of similar work appreciated. Let me know if you have any questions or need to inspect first.

1. Outside Works a) Install supplied bulkhead to carry power from house to main pergola support post. b) Install two 90mm single GPOs on the support post and one double power point at approximately 1800mm along main pergola support beam. c) Install 1 x double power point on brick wall opposite bbq d) Install 2 x 2000 watt electric heaters, one to new bulkhead, one to wall e) Install 2 x LED Batten lights under pergola wired to existing switch f) Install new flood light wired to existing switch 2. Install New GPO behind Television in Lounge.

I need a standard double power point installed in my living room. I've attached a photo showing the exact location where I'd like it to be placed.

Fit kings 270 awning to kings hard-shell roof top tent on 4x4

Photos attached, silicon needs to be removed and render repair needs to be in certain areas. 4 x pillars in the alfresco. Thank you

Need to fix the chipped and scratched render on a rendered mailbox. Colour to be colour matched

See photo Removed an existing wall. Cables will be relocated tomorrow morning. Need plastering re done. Please quote

Minor repairs done throughout house due to kids, cracks etc. No huge holes, just minor repairs. Bonus if can paint over too please

Bought a house - plaster few spots

Replace power point with new and adjust shower screen to operate properly

I need two ceiling repairs following some water damage. One is underneath an outside balcony that leaked near the front door entry. The other is inside the house under a shower that leaked. Pictures of both are included. Looking for repair of both, possibly with any mould treatment/inhibitor required, and plastering/gap filling and painting to match existing areas. Looking for someone with experience.

We have rollers, brushes and paint. Basic white with 2 coats. Easily done in a day. 1/4 of verandah complete.

Need 2x power points installed outside Ones used for spa Brick house single story tiled roof and back to back power points so both spots I want them installed have PowerPoints directly behind them on the inside

Need a sauna picked up in dissembled from Mickleham and delivered to waterways and will need it assembled again please. “will just need to deassemble it with an electric screw driver my ex can show them when they get there takes 2 seconds and then it can be flat packed and reassembled same way there is just a few screws and then it all clips together”

May need angle grinder. I need someone to cut my awning bracket so it’s not sticking so high. Happy to help uninstall and reinstall the awning if required

Install (extend from existing) power point and hang a 65 inch TV to the wall. I can provide the mount