Find experienced local tradies in Canberra

Render small house 98 square meters

This is a 2 person job. Awning was taken down to install new windows. Now needs o be put back.

I need help to unpack and move Sauna parts for Sauna assemblies in Downer and Casey - expect from 7.30-1pm on Wednesday 26th - your own transport is preferable

We need someone to install a 250V AC, 32A single-phase power point, and a sensor light in our garage. Pic of main switchboard, and garage switchboard attached.

Looking for two existing power points in our living room to be converted from two to four outlets. Seeking a qualified electrician to provide new faceplates/materials and labour for combined fixed price.

I’m installing a new bathroom exhaust fan myself and need someone experienced with plasterboard to adjust the existing ceiling opening. The current cavity/opening is approximately 3 inches larger in diameter than the required opening for the new fan. I need the existing opening reduced and the plasterboard finished neatly so that I can install the new fan afterward. Scope of work: Reduce/modify the existing ceiling opening to suit the smaller fan Add any necessary plasterboard support/backing Patch and finish the plasterboard neatly around the new opening Leave the area ready for me to install the fan Please note: Fan installation, electrical work and ducting are not required. I only need the plasterboard/cavity adjustment and finishing work.

Hi there, found you through exact the same task you completed. I need double power point installed in living room ( apartment building), there is existing power point outside on the balcony just on the other side of the wall which you may use as a starting point. Thank you

Renders around the house needs to be patched and repaired

Verandah around 4m by 4m to lay the slate tiles.

Need to replace the Gyprock on the ceiling.

I'd like someone to install my new Soundbar underneath the tv (picture refers). I've managed to hide the power cord behind the tv and want to keep the same look for the soundbar, which will mean having someone poke a hole in the wall and going under the house to feed the power cord back in, behind the tv. It's also likely we'll need another power point behind the TV too, as currently it's just a one plug power point OR an adapter* I have the correct mount, as well as the sound bar. I'd need someone to bring two brush plates to keep the wall in good shape. Note there's only about 2cm gap behind the TV and we may also need to think about a recessed wall box behind the TV OR an ultra-thin flat plug/extension cord for side entry*. *If the latter easier fixes then I'd want to negotiate price down.

Removing several power points from 2 walls in a office.

Proven professional gyprocker/plasterer to: 1. Gyprock sheet both sides of a sliding door cavity that has been removed and replaced with studs/noggins ready for sheeting. 2. A non-load bearing wall has been removed (4.5m wide *2.7m high) and gyprock sheet required to lhs and rhs and ceiling where wall removed, including adding cornice to both ceiling sides. 3. Replace gyprock sheets to several ceiling holes that were cut out as inspection ports prior to the wall being removed. Gyprock to be left to a very high standard ready for me to paint. Ignore the far wall in the photo with the insulation batts. That won’t be gyprocked as part of this work. Job can be done in 2 parts: Part 1 to be done ASAP sheet old sliding door cavity and lhs of wall where wall removed. To make way for cabinetry install along that wall. Part 2 : remainder of work over next 4 weeks.

Give us a quote for adding crown moulding to recently renovated kitchen and patch hole from wall heater that has been removed

Need a plasterer to patch up two small marks

I need a sparky to do a small job for me, check that this PowerPoint is safe (something fell on it) and put a new face plate on. I can sort out the rest (patching and painting)

Trying to hang a sensory hammock for the kids that needs to be fixed into a joist with 2 bolts. Looking for you to also chuck some spackfiller or w/e in the holes I've drilled. I’ve used a stud finder to find what I thought were the ceiling joists, but driving a nail/drill bit through hits air. The roof has a bedroom above it if that provides any useful info.

Hi all, Looking for someone to help with a small job: Replace a cracked power point cover (GPO), outlet is working fine Location: Ngunnawal ACT 2913 Happy to share more pictures Let me know your availability and experience. Thanks!

Patch 3 x ceiling gaps near ac grilles 1 x wall hole patch

Need to change or fix the window awning fabric curtain Feel free to provide quote or offer