Find experienced local roofers in Inner South West Sydney

Must have their own ladder, safety gear and insurance. Don’t have pictures as I can’t get up there. Gutters were cleaned 3 years ago. I can’t see any overhanging branches, leaves etc. No gutter guards. Terracotta tiles No solar panels

I’m looking for a licensed electrician (NSW licence required) to install a small rooftop ADS-B antenna at my home in Blakehurst and earth it properly. The job: Mount a fibreglass or PVC mast, 1–1.5 m, on a gable end or fascia. It must go on a roof face without solar panels and stay at least 1–2 m from the panels and DC cabling. No fixings into the solar rails. Run the supplied 10 m coax cable from the antenna into the house, weatherproofed with a drip loop. Install a DC-pass N-type coax surge arrestor where the cable enters the house. Earth the arrestor with a short 6 mm² green/yellow lead to the main earth at the meter box. If the entry point is too far from the meter box, drive a new earth stake and bond it to the main earth per AS/NZS 3000. Do not bond anything to the solar array frame earth. Provide a Certificate of Compliance for the earthing work. I’ll supply the antenna, the 10 m coax cable and the receiver. Please say in your offer whether you’ll supply the mast, bracket and arrestor, or want me to buy them. Timing: Flexible, weekday or Saturday.

Looking for a quote from water proofing specialist to waterproof a concrete roof from the installation of solar panels mounting brackets for 22 solar panels. - A total of approx. 46-50 holes will be drilled into the concrete roof for installing the aluminum L brackets for holding the tracks. - Chemset epoxy with Ramset Anchor studs will be used to mount the L brackets - Solar panels will be installed in the following configuration o Two rows of 10 panels per row o And one row of 2 panels - Six aluminum tracks will be installed on the L brackets, Four with length of approx. 11.5m; and two with length of 2.5m. - Solar panel dimension 1.143m by 1.762m each - Total areas covered by solar panel approx. 48 sq. m Solar installer will first install the L brackets. Water proofing specialist will perform the water proofing of the works. Solar installer will only return to complete the solar panel installation when water proofing has been completed. Specialist will need to certify the works and provide relevant certificate.

I need an experienced builder or handyman to help assemble a 3m x 3m freestanding pergola with an insulated sandwich-panel roof on an existing concrete slab. I'll be working alongside you as the second pair of hands, so only one worker is needed. Supplied: all kit parts (steel posts, beams, roof panels, brackets, fixings) You bring: a cold-cut or abrasive metal circular/drop saw, a hammer drill with masonry bits, and a level

Metal roof erosion & leaking - Need restoration and potentially re-paint the whole roof by Monday

Guttering needs to be replaced and also minor ridge cap repairs

Roof inspection and. Identify and repair opens

Waterproofing bathroom area. Bathroom will be demolished.

Antenna to be installed on small granny flat roof. No need to get on the roof as it’s an old shipping container The Ariel wire is there and I have the antenna already

Help team to remove tiles from rooftop and throw into bin below. Throw any other junk into the bins. 3hrs work

Need help replacing two broken gutter down pipe connector as shown in pictures.

Roofer to install colourbond drip groove. I have all materials to use, just need you, your ladder and your comfort at working at heights. The height is 6.2m from ground to where I need the drip groove installed.

Change sun tunnel cover on roof to a clearer cover maybe glass

New shop front has been. Cleared just need to paint before new shop gets started

Need gutters cleaned, double storey duplex

Professional to clean my roof gutters please

Looking for an experienced handyman or roof installer to supply and fit polycarbonate/pergola roofing sheets over our existing open pergola frame. Job Details & Scope: Frame Dimensions: 3.9m wide x 3.0m deep x 2.87m high. Current Setup: Existing steel/metal open frame attached to the alfresco area. The top beams are currently flat. Core Requirements: - Supply and install quality clear or tinted polycarbonate roofing sheets (e.g., Laserlite or similar) - Build a slight pitch/angle onto the flat frame so water and debris can drain off effectively. - Supply and fit any necessary battens, timber/steel risers, flashings, fixings, and basic guttering/drainage setup required to keep the area waterproof.

I have a standard shower, after a while water starts to seep out from the shower area and on to the bathroom. I think sealing issue of door or borders?

Looking for a handyman/ Painter to apply liquid membrane sealant to a residential metal awning roof. Size/Height: The awning is 24m² and approximately 3 metres high. Materials: All sealant is completely supplied on-site. Scope: Give the metal a quick sweep with a broom, then roll on the sealant coat. Requirements: Please bring your own ladder/Broom and roller/extension pole. Must be an independent contractor carrying your OWN PERSONAL ACCIDENT and LIABILITY INSURANCE. Flexible days ( between 15/7/26—23/7/26)Please send through your offers! ***Worker must rely on their own professional expertise and site inspection before commencing work***

Please clean gutters around the roof without blasting the leaves and dirt too much on the house itself. The back will need a ladder , please bring one. Thanks.