Find experienced local roofers in Canberra

Needing gutters cleaned. One side of house

Buying like 100sqm of R4 insulation, i just need someone to put it in place. i did the other 100sqm. No need to remove old insulation. Need to cut around downlights. Pretty huge cavity so it's pretty comfy up there (as far as insulating goes). I'm 6'2ish and my back wasn't too sore after first load

Cleaning rooftop solar panel x20. Freestanding single story house in Harrison ACT

I need someone to go into the roof and help me install a wifi module into the AC unit. I can provide instructions for my AC unit

Need gutters cleaned on small single story house

I’m seeking an experienced roofing professional to complete insurance-related roof repairs at a residential property in Canberra (ACT). The work relates to hail-affected roof tiles and associated safety access requirements and must be completed in accordance with ACT building standards, WHS obligations, and insurer expectations. Roof Tiling • Allowance for roof harness and anchor setup (approx. 2 items) • Remove and replace hail-affected roof tiles (approx. 6 tiles) • Bedding and pointing repairs where tiles have been replaced (approx. 6 linear metres) Scaffolding / Access Equipment • Supply and install temporary safety rail to enable safe harness connection (approx. 10 linear metres) By making an offer, you confirm that you: • Are legally permitted to carry out this work in the ACT • Have appropriate trade qualifications and experience for roofing and work at heights • Will perform the work in line with WHS, fall-prevention, and building requirements • Are familiar with insurance repair standards and completing work suitable for insurer review Evidence of relevant licensing, qualifications, and insurance can be provided after task acceptance and prior to commencement. • Residential, owner-occupied property • Works relate to an insurance claim (scope already defined) • site details can be provided after acceptance • Please include your relevant insurance repair experience, estimated timeframe, and availability in your offer • Fixed-price offers preferred

Need Stratco shed installed 5° Skillion Roof, 9.199 x 3.103 x 2.4m high. Shed slab has been completed. Will need to be water/air tight.

I have a polycarbonate pergola on the north side of the house that gets really hot. I would like some sort of ventilation installed to let the hot air out but will keep rain out still

I need a handyman to access my fan-coil unit which i believe is in the roof and install a faikin unit into the Daikin AC. https://www.faikin.au/pages/faikin-origins I have contacted the faikin creator to confirm it is compatible with my AC Unit. I need help with installing the unit and then I will confirm connectivity. Instructions from Faikin to me below: FDYA160AV1 is a ducted “indoor unit”. That means the air you feel at the vents is coming from ducts connected to a separate fan-coil unit that’s usually in the ceiling space (roof) or under the house, not a wall-mounted head in the room. So yes, installation is done at the indoor unit itself, which typically means getting access in the roof/underfloor. Have attached some pictures for guidance. You'll need a Faikin and Type C cable combo for your unit. The FDYA series are common here in Oz, and I've send dozens of unit out without issue. Where you’ll be installing it (ducted setup) You’re looking for a big metal box roughly the size of a large suitcase, with ductwork coming off it. Commonly you’ll see: the indoor unit (FDYA160AV1) in roof space/underfloor a zone controller somewhere accessible (often near the return air grille, in a cupboard, or mounted near the unit) multiple ducts feeding different rooms Faikin connects to the indoor unit control circuit board, not the wall controller or the vents. Basic install Isolate power to the system at the breaker (important). Access the indoor unit in the roof/underfloor. Open the electrical/control cover. Plug Faikin into the correct connector on the control board. The Type C cable has three ends, one goes to the Faikin, and two to the A/C circuit board (sockets are labelled X35A and X50A). Mount the module so the antenna isn’t pressed against metal. Restore power, join it to Wi-Fi, then integrate with Home Assistant (MQTT or the standard Daikin integration).

Looking for an experienced worker to install underfloor insulation beneath a 1970s red brick duplex in Hughes, ACT. The job covers roughly 40 sqm, including the living area, kitchen, entry, and laundry. Key details: • Low crawl space: limited clearance under the house — must be comfortable working in a tight area. 55cm height clearance under house to work 30cm access height clearance from under deck to under house 46 x 46 access through trap hole in deck • Materials supplied by me (see below). • Tools and fastening equipment supplied by you. • Seeking someone experienced with underfloor installation or confined-space work. Materials I’ll supply: • Polyester or foil-backed underfloor insulation batts/rolls (pre-cut to joist width). • Fixing straps or insulation strapping tape (depending on material type). • Protective face mask and coveralls (optional, if you prefer your own gear, that’s fine). You’ll need to bring: Staples and fasteners (if required for your preferred installation method). Staple gun, cordless drill, or fastening tools suited for subfloor work. • Torch or lighting for underfloor space. • Drop sheet or kneeling pad (optional, depending on comfort).

Hi, I want to replace my current cloth pergola roof ideally with a polycarbonate or similar structure (not cloth). I need advice on what roof to buy (reasonable options) that will go on the existing metal structure. I will then buy the roof and will require assistance in installing it (after removing the current roof). Please provide a quote for this end to end process (I have just put a random "budget" for the purpose of the task). Thank you

Gutter cleaning service for single storey house with gutter guards

Tiling and waterproofing Shower base and walls 900 x 900

I need someone to instal a small hook in my veranda ceiling and help me string some fairy lights up. The ceiling of the veranda is about 3 metres high. I have a small step ladder but you may prefer to bring your own. The ceiling has 3 hooks already, it's only the 4th that needs installing.

Small house one level- clean gutters before sale.

2 storey town house but only half the gutters are mine

I am looking for someone professional and experienced to help with cleaning the gutters and downpipes at my two-storey townhouse. I have gutter guards installed, so hopefully the gutter cleaning part would be fairly straightforward.

I need insulation installed under the house floor. The house is raised, there is a door that you can enter from, there light that comes through some vents under the house. Refer to photos. Person can crouch in certain areas and crawl in others. I’ve installed about 25 matts already but I’m inexperienced and therefore its time consuming for me, I also work full time during weekdays and my weekends are quite full.

Roof ridge capping repair (10cm piece)and reseal exhaust fan outlet

Two plastic panels on shed roof have disintegrated over time and left holes in roof. I am not sure how much this usually costs so am open to offers