Find experienced local roofers in Inner South West Sydney

Van damage from reversing into lowered roof, want to prevent rust damage and bring shape roughly back to original. Does not have to be perfect but want to prevent further rust damage. The top reverse tail light does not fit into hole due to deformed metal at the top of rear door. Would like to get that fixed to allow the tail light to sit flush and have an intact seal around it to prevent water ingress

Need replacing capping tiles. And gutter cleaning. Small roof 1 storey house.

I want to cover the top of this opening - the build cannot be a permanent kind of build, I need something that I can easily remove etc. I have attached some images of what I mean, I hope it helps. The opening width is 3m wide, and I want around 2m covered interms of length

Flexi flashing between roof & wall

I have the insulation, glasswool insulation so you must wear full overalls to avoid getting itchy. Nails removed from Timbers in the house and glue removed of certain Timbers. 1 days work

The ceiling insulation bats in the ceiling in my daughter's bedroom are not spread out correctly and it's causing the room to overheat. I need them repositioned. The access point is at the top of the landing next to the bedroom.

To replace 14-15 broken tiles on single storey house and move a tile capping to prevent rain entering premises. Grout cleaning optional

Roofer to install colourbond drip groove. I have all materials to use, just need you, your ladder and your comfort at working at heights. The height is 6.2m from ground to where I need the drip groove installed.

Pool solar heating matting/tubing on tiled roof has developed a leak. Water sprays from one section when the solar heating is running. Looking for someone to repair the leak.

New shop front has been. Cleared just need to paint before new shop gets started

Need gutters cleaned, double storey duplex

Professional to clean my roof gutters please

Looking for an experienced handyman or roof installer to supply and fit polycarbonate/pergola roofing sheets over our existing open pergola frame. Job Details & Scope: Frame Dimensions: 3.9m wide x 3.0m deep x 2.87m high. Current Setup: Existing steel/metal open frame attached to the alfresco area. The top beams are currently flat. Core Requirements: - Supply and install quality clear or tinted polycarbonate roofing sheets (e.g., Laserlite or similar) - Build a slight pitch/angle onto the flat frame so water and debris can drain off effectively. - Supply and fit any necessary battens, timber/steel risers, flashings, fixings, and basic guttering/drainage setup required to keep the area waterproof.

I have a standard shower, after a while water starts to seep out from the shower area and on to the bathroom. I think sealing issue of door or borders?

Looking for a handyman/ Painter to apply liquid membrane sealant to a residential metal awning roof. Size/Height: The awning is 24m² and approximately 3 metres high. Materials: All sealant is completely supplied on-site. Scope: Give the metal a quick sweep with a broom, then roll on the sealant coat. Requirements: Please bring your own ladder/Broom and roller/extension pole. Must be an independent contractor carrying your OWN PERSONAL ACCIDENT and LIABILITY INSURANCE. Flexible days ( between 15/7/26—23/7/26)Please send through your offers! ***Worker must rely on their own professional expertise and site inspection before commencing work***

Please clean gutters around the roof without blasting the leaves and dirt too much on the house itself. The back will need a ladder , please bring one. Thanks.

I need someone who can do minor repairs on roof tiles to rebed the caps and clean and reseal the corner gutter joints to make it waterproof again.

Looking to remove the old polycarbonate roofing and replace with new sheeting. Will have the sheets ready and all the bits to attach to the timber roofing. Looking for a skilled person in this to ensure no leaks etc.

Looking for an experienced renovator/builder/handyman to convert two small office rooms into one podcast/video studio. Location: Milperra, first-floor office. No lift, but staircase access should be okay. Layout attached with approximate measurements; final measurements to be checked on site. Work required: * Remove non-load-bearing gyprock wall between the two rooms * Move existing front/door gyprock wall out by approx. 60cm * Build new wall with one side entry door, not centred * Soundproof walls, ceiling and door to reduce office chatter/phone noise coming in * Keep existing carpet; no floor soundproofing needed; no windows * Plaster and sand ready for finish; no painting required * Include rubbish removal, clean-up and dust control as office will still be operating Please quote options for: * Standard door vs solid-core/acoustic door with seals/drop seal * With and without relocating affected electrical/data points * Optional supply/install of acoustic decorative wall panels on approx. half the wall area * Any lighting advice if ceiling work affects existing lights or better video lighting is recommended Existing movable aircon/ventilation to be considered when planning sealing/layout. Budget listed is a placeholder only. On-site inspection welcome before final itemised quote. Preferred timeframe: within the next couple of months. Please include your recommended soundproofing approach, estimated timeframe and whether materials are included.

supply and instal 1.5M guttering to cement slab to divert rainwater into garden