Find an experienced plumber in Lane Cove

Replacement 1) Supply & Install a new Rheem 80L (stainless steel) Replacement includes: - Full Supply & Install with all material included - 1 workmanship warranty and 2 years material warranty - 12 year water heater warranty - FREE Delivery & removal - Plumbing & Electrical at HWS 2) Supply and Install a Tempering Valve (if required) 3) Relocate hot water system to outside Kitchen including plumbing and electrical, and all material 4) 2 slabs to elevate it

Need to fit a bidet in bathroom by a licensed plumber.

Looking for a licensed gas plumber experienced with Rinnai Infinity continuous flow hot water systems. I have two independent Rinnai Infinity 32 units (installed around 2010) that I’d like serviced. Unit 1 (Faulty): * Recently became completely unresponsive until power was reset. * Now ignites and provides hot water for around 45–70 seconds, then the burner appears to shut off and the water goes cold. * Will produce hot water again after stopping and restarting the tap. Unit 2: * Operating normally but would also like it serviced as preventative maintenance. Please include: * Full service of both units * Diagnose the fault with Unit 1 * Clean inlet water filters * Check burner, ignition and flame sensor * Check gas pressure and operation * Inspect heat exchanger and advise if scaling or overheating is present * Provide recommendations and a quote before carrying out any additional repairs Please quote your call-out fee and service cost for both units. Licensed gas fitter only.

Fix Billie water system. Hot and cold system lights flashing yellow

Looking for a quote for a licenced plumber to replace Outdoor Gas Hot Water System. Current system is Bosch and will need to be replaced with Rheem (will be supplied). Task is for labour and for any other parts needed to complete the job. The heater itself will be supplied. thanks Rheem 26L 50° Gas Continuous Flow Hot Water 876A26NF-LF

The existing kitchen tap had the aerator/sprayer removed some time ago after it was damaged. The tap now splashes excessively when used at normal pressure. Install a new kitchen mixer tap with the one I supply. Example tap https://www.bunnings.com.au/estilo-35mm-matte-black-side-lever-gooseneck-sink-mixer_p1018106

Multi-skilled Tradie: Plumber & Electrician required： 1 change new tape and cold and hot flexible braided hoses,I bought a Kitchen Mixer Swanneck &Flexible braided cold and hot hoses already please change for me.2 decommission an old switch and install a blanking plate. please provide your plumbing and electrical license numbers before I accept your offer.

replace the hot and cold water supply lines for basin

​Hi, I need an experienced, licensed plumber to fix an active leak on a back-to-wall toilet with a Valsir concealed cistern (see attached photo). ​Water is pooling on the tile floor beneath the cabinetry framework. I tried turning off the local isolation valve, but water is still leaking, which suggests the valve itself has failed or there is a breach at the base of the cistern/pipes. ​Important Note on Access: While standard access is via the chrome push-button flush plate on the countertop, it is completely okay to cut open/dismantle the cabinetry to access the pipework. We are fully renovating the bathroom soon, so damaging the cabinet facade is not an issue. ​What needs to be done: 1.​Diagnose the source of the leak beneath the cabinetry/cistern framework. 2.​Replace the faulty isolation valve and any compromised flush/inlet seals or pipes causing the external leak. 3.​Ensure the entire system is completely watertight. ​Details: ​Brand: Valsir ​Location: Epping Rd, Lane Cove ​Parking: Free onsite parking available. ​Must be a licensed plumber with experience in concealed cisterns. ​Please reply with your earliest availability today. Thank you!

Need someone to install waste trap on bathroom sink. Already bought the waste trap but tube will need to be cut down to length to fit.

Need to unstack a washing machine and dryer. replace the washing machine with our existing one, re-stack, and move the old washing machine into the garage.

Remove existing leaking mixer tap and replace with this Caroma mixer https://www.bunnings.com.au/caroma-chrome-lead-free-cirrus-sink-mixer_p0738431

Bathroom sink seems to be leaking slightly into the cupboard below. Can only replicate with hot water but both pipes seem old and likely need replacing. See images and video for more.

I need my old toilet to be removed and the new one to be installed. Pics of my old toilet.

Kitchen water tap running very slow. Need someone to inspect, could be cartridge need replacement or water tap need to be replaced.

Wanting a quote for the removal of this old section of pipe and replacement with new pipe. Very simple job. See photos

Install LG washing machine WV5 1208W

I need your help to - remove the cupboard door - take out my broken washer - install a new washer - put the door back in

Licensed and experienced plumber preferred. I’d like to install a garden tap just inside the garage entrance for a hose. There is an existing tap on the other side of the double-brick wall (approx. 275 mm with cavity), so the pipework should be straightforward and accessible. The existing outside tap will remain. The job involves drilling through the wall and extending the current piping to create the new tap point. Please supply a full-brass 1/4-turn dual-outlet tap (similar to the $25 model at Bunnings). I’m happy to reimburse the cost. Photos below.

Install new vanity tap set which i will supply, picture of underneath and existing taps and new ones which i will supply. Can be done either tomorrow morning, this saturday morning or tuesday morning