Find an experienced handyman in West Melbourne

Experienced plumber / kitchen installer needed to replace my kitchen sink.Location: Williams Landing, VIC (Melbourne western suburbs)Current Setup:Wood base with Formica/laminate topExisting sink: ~1180mm wide (double bowl + drainer)Benchtop cut-out will be TOO BIG for new sink (33cm gap!)New Sink: Costco Presenza Deluxe Stainless Steel Kitchen Sink Kit QKA051 (850mm wide)Already purchased or will purchase soonSingle deep bowl - much more practical than current setupWhat I need:Disconnect/remove old sink, plumbing, wastesSOLVE the large cut-out gap (laminate benchtop) - options include:Cut wood supports/packers and laminate pieces to fill the extra spaceUse expanding foam filler + trim/sand smoothCustom wood/laminate insert secured from underneathAny other clean, professional method that seals water-tightInstall new sink (top-mount/drop-in) with included accessoriesReconnect plumbing, fit tap/wastes, test for leaksPerfect silicone seal around all edgesPriority: Clean professional finish, no visible gaps, waterproof seal to protect wood underneathYour quote should include:Experience with laminate benchtop retrofits (smaller sink in large hole)Licensed plumber + insuredLabour cost + materials (wood, laminate, silicone, etc.)Availability (weekends ideal)Time estimatePhotos of current benchtop/sink available - happy to share!

Dismantle the gym Transport from one place to another Then put it together

Roller shutter won’t close

I want to put in ceiling access panel, to the roof space.

My garage door pulley came off from one side and door is opened half. I saw there are many DIY on YouTube to do it at home but if someone has done it before, it should be quick

I need a few things done around the house. You will need to have the tools and a ladder. 1. Gutters cleaned - single story, 3 bed unit. You'll need your own ladder. 2. 2 x small trees trimmed back on the driveway. The tree on the right of the photo, and a small one further down the drive. 3. A bed repaired. I have new fixtures to fit on each end to make it more stable. I have the drill for this one.

Need someone to purchase and install the ceiling cornice.; get the new cornice and install and paint (builders white). Remove left part & replace whole side.. Size around 5-6m See attached.

IKEA queen bed malm screws are missing and standing fan

My current fly screen on this door has holes, want to replace with a new fly screen

I am looking for someone who can fix a few things -Adjust front door as it is not latching -Hang some festoon lights out the back from the roof to the shed (replace existing in pic) -Adjust direction of solar panels for security cameras You will need to bring your own tools and a ladder that allows you to reach the roof. Also I have a friendly pug 🐶 (an FYI in case you are scared if dogs)

1. Garage Door: The steel panel of the garage door has come out, and there is also a small dent visible on the garage door. 2. Internal Door: The internal door is making noise when opening and is dragging while closing.

I’ve had my kitchen sink tap replaced by someone from Airtasker 2 weeks ago and sadly the tap is loose again. I need someone to come and check this again and give me a proper diagnosis about why this is an ongoing issue and fix it. Need it fixed

Repair plaster on ceiling - was removed to inspect water leak which has now been repaired. Repair is approx 1600mm long x 400mm width New plaster board will be provided. Price will need to be inclusive of materials, joint compound / tape etc Painting not required, just ready to paint is only required.

Fix the sliding door.Door not opening and close smoothly getting stuck somewhere need to lift the door to open and close. - Due date: Flexible

Need an installation of peel and stick wallpaper done on one wall of a bedroom. -The wall size is about 3 x 2.6 -Has been undercoat painted and cleaned -Wallpaper is from Olive et Oriel Looking for someone who's experienced and has done this work before.

Looking for a professional plasterer (not a handyman) to fix a wall repair that was done poorly. TV brackets were previously installed, and the wall was patched after the tenancy, but the repair is not up to a professional standard. The work needs to be properly patched, sanded, and repainted. Requirements: Must be a qualified plasterer Can provide invoice on company letterhead and a proper invoice Able to complete work to a professional standard Please only contact if you are a professional tradesperson who can provide a proper invoice for insurance/tenancy purposes.

Looking someone to fix the wall damage and relocate the remote,pics attached

Hi there, I’m looking for an experienced plasterer/carpenter to install about 1.5m cornice in a home in Point Cook. It’s a small job and I’d like a neat, professional finish including accurate cuts, mitres, adhesive/fixing, and clean-up (and patch/paint-ready finish if needed). ASAP—please let me know your availability and a rough quote

I am looking for someone to trim the bottom of an aluminum door that is currently dragging on the floor/threshold. It makes a loud metal scraping sound every time it opens or closes, and I want to prevent damage to my flooring. ​Task Requirements: ​Assessment: Check if the door needs to be planed, cut, or if the hinges just need adjustment/shimming. ​The Cut: Use the appropriate power tools (e.g., circular saw with a metal blade or a metal planer) to trim approximately 2-5mm off the bottom for a smooth swing. ​Finishing: File down any sharp edges so the finish is clean and safe. ​Re-hanging: Ensure the door is properly aligned and swings freely after the trim.

Sign & Banner Installation Scope of Works 1. Banner Installation Quantity: 4 banners Size: 50m (L) x 1.6m (H) each Material: Mesh 2. Park & Pay Sign Installation Quantity: 20 signs approx Size: 900Hx600W Material: Coflute 3. Tow Warning Signs Quantity: 2 signs Size: 300hx400w Material: Coflute