Find a professional kitchen sink installation service in NSW

I need help with replacing a kitchen sink tap. Bought new tap, just need labor.

We need new tap installed, we have the new tap, just don’t have the tools to install tap in tight space under sink. Should be relatively easy for someone with correct tools.

We need to change the tap as shown to new tap

remove the existing kitchen sink. Modify/open the internal cupboard carcass where required to provide adequate access to the mixer retaining hardware. Supply and install a new kitchen sink mixer. Reinstall and reseal the existing sink. Reconnect all associated plumbing services. Fully commission and test the installation to ensure correct operation and that all connections are leak-free.

I have purchased a new tap for the kitchen sink. Need to remove the old one and fit the new one.

I need a plumber or someone with the skills to help remove the blockage. The kitchen sink water flows to the outdoor drainage, but there is a blockage preventing the waste water freely flowing to the outdoor drain

the pipe under kitchen sink is leaking, please see attached images

Repair or Replace Insinkerator in kitchen sink

I got a new kitchen sink pipe. I want to replace existing one to the new one. Added pictures for the existing kitchen sink and new one that I purchased.

The water is dribbling from the hose of our kitchen sink.

The kitchen sink needs to be resealed. It leaks into the cupboard below the sink. And the seal that joins the bench and the tiles behind the sink need replacing.

We have a quartz stone kitchen sink and already has hole cut for the sink, hole is 400x460, we are upgrading to different type of sink and needs a slightly bigger hole 400x510

Hi, I’m a builder looking for a licensed plumber to install a new kitchen sink in Ashfield today. The job includes: * Install the kitchen sink. * Connect hot and cold water. * Connect the drain/waste pipe. * Check for leaks and make sure everything is working properly. * Advise if any additional fittings or parts are required. * I can purchase any required materials from Bunnings if you let me know what is needed. Requirements: * Licensed plumber only. * Own tools. * Honest, reliable and reasonably priced. * Available today. Please send: * Your price. * What time you can come. * Confirmation that you are a licensed plumber. Photos attached.

Looking for an experienced licensed plumber with good handyman skills to replace my existing kitchen sink and mixer. The job includes: * Remove existing undermount sink * Remove existing sink mixer * Thoroughly clean and remove all old silicone/adhesive from the benchtop around the existing sink cut-out * Install and reconnect a new undermount sink * Install and reconnect a new pull-out sink mixer * Reconnect waste, trap and water supply * Seal the new sink properly with silicone * Check for leaks and ensure everything is working correctly Requirements: * Experience installing undermount stainless steel sinks * Must have the correct tools (including clamps/supports if required for undermount installation) * Neat workmanship and attention to detail * Please bring all standard installation materials (silicone, fittings, etc.) unless otherwise discussed. The new sink and mixer will be supplied by me.

Water seeping through the cabinet underneath my kitchen sink. please get this fixed. It's not a lot of water at the moment but every few days I can see a puddle of water inside the cabinet. It seems to come from the bottom of the partition behind the pipes

The kitchen sink is blocked and needs to be unblocked.

See photos attached. Need rubber seal replaced on kitchen sink waste. Slow leak developed overtime, assuming just the rubber gasket needs to be replaced and tighten.

I need someone that can do a neat job removing the old silicon, clean, and apply new. Located central Tweed Heads. I can buy the product you want to use or quote me on bringing the silicon as well, whatever you prefer.

Minor leaks under kitchen sink and vanity Please note it’s 3 leaks in total 2 under kitchen sinks and 1 under a vanity **all in the same building

I need a skilled stonemason or fabricator to adjust a engineering stone kitchen benchtop. My undermount sink failed, and I’m transitioning to a top-mounted sink. The hole in the stone needs widening by about 1–2 mm. I want a precise finish so the top-mounted sink sits securely and is future-proofed from failing.