Find a professional gyprocker contractor in VIC

Need someone experienced to demolish and remove an internal partition wall. Job details: Partition wall is approximately 8m long x 3m high Wall is made from timber framing and gyprock/plasterboard Demolish and remove the wall safely Remove all waste/rubbish from site Leave the area clean and tidy after completion Please provide a quote including: - Labour - Tools/equipment required - Rubbish removal/disposal - Your availability - Whether you have completed similar demolition or partition wall - - removal jobs before - Prefer someone reliable, experienced, and careful with commercial/showroom spaces.

Need a sliding wardrobe door hole fixed, the whole panel replaced and installed (Sliding door panel set up, simple remove panel from frame and slide new gyprock panel cut to size in). The sliding door messurements approx H:2350mm W: 1060mm Thickness 10mm Will need to get supplies (Bunnings) materials, own tools and be able to transport the panel. No need to paint the panel, just install it into the existing frame. ($250) Or if you can just patch it up with no sanding or painting needed happy to pay $90

A gas column heater once was installed on this wall, and has now been removed. The opening where the gas heater used to be, is now required to be covered up. On either side of the opening, there is timber, so its possible to put a piece of timber in the middle to support the repair area. The opening is 45cm wide and 170cm tall. No need to paint, just need a smooth finish. This job will suit a person with dry wall repair skills, e.g. plasterer.

Hi, I need a handyman or plasterer to repair 3 small holes in internal plasterboard walls (see photos). Scope includes: * Patch and repair holes (one slightly larger, two small) * Sand smooth and flush with wall * Prime ready for paint if you can colour match Details: * Location: beaumauris, VIC * Flexible with timing but prefer within the next week * Must have own tools and experience with clean, neat finishes Please quote including materials. Bonus if you can match paint and do final touch-up.

Install plasterboard (Gyprock) to garage ceiling using existing timber joists, including full finishing and painting. 6mx5m Scope: • Inspect existing joists for alignment and suitability • Install additional battens/noggings if required • Supply and fix plasterboard sheets to ceiling • Tape, set, and sand joints to a smooth Level 4 finish • Stop all screw holes and prepare surface for painting • Apply sealer/undercoat • Apply two finish coats of ceiling paint • Install cornice if required (confirm separately) • Clean and remove all waste on completion Notes: • Existing timber joists available for fixing • No major structural modifications included • Electrical works excluded • Insulation excluded unless specified

The gyprock wall has multiple old anchor screws and holes in the wall. The first wall needs to be patched, plastered and painted. Second wall has minor chips in the plaster needs to be patched and painted. I’ve included photos. Task preferably to be completed on a Monday or Thursday between 8:30am and 4pm

Gyprock (fire safe) on two walls. 7x4m wall and 11x4m wall. Thank you

Looking to have 2/4 walls gyprocked finish. One wall is 4m high x 11.2 m long and the other is 4m high and 7m long (approx).

I am looking for a professional handyman/plasterer to fix the following damages in Melbourne. A high-quality, invisible finish is required for a rental inspection. 1. Gyprock Wall Repair (2 locations): • Patch, sand, and finish 2 holes in the plasterboard walls. • Full wall section painting (corner to corner) required for a perfect color match (no patch marks). 2. Internal Door Replacement (2 doors): • Remove 2 damaged hollow core doors and replace them with new ones. • Source and purchase standard hollow core doors (approx. size to be confirmed upon visit/measurement). • Install existing hardware (handles/latches) onto the new doors. • Paint the new doors to match the existing interior color. Requirements: • Professional Finish: Repairs must be seamless and invisible. • Tax Invoice: A formal tax invoice must be provided upon completion for bond/record purposes. • Materials: Please specify in your offer if your quote includes materials (doors, paint, plaster) or if it is for labor only. Please provide your best offer and estimated timeframe. Photos are attached for reference.

I need hand of experienced plasterer to finish the remaining job i have done the ase coat and need someone to do topcoat

I have an attached brick garage, 2 walls are brick, I'd like them gyproced and undercoated. 1 wall has brick posts that push out from the wall to be covered, the other wall is only above the roller door and is flat. I will clear half the garage and everything off the walls so that its easy to work on.

Looking for someone to come out and patch and internal wall where there has been some damage over the years. It also needs a new lick of paint from wear and tear. You'll need to supply your own materials.

1) kitchen is being renovated, electrical and plumbing has been roughed in already. Need to fill gap with drywall an waterproof it and finish it to a high standard

Require removal of a small number of stud and partition walls in a commercial office in Keilor Park. Make good to be as per new wall where existing wall is removed.

Install single gang 10A power point in hollow gyprock wall, using an existing power outlet on other side of wall as feed.

I need an experienced handyman / plasterer to repair a large hole and cracks in an internal plasterboard (gyprock) wall. Damage size approx. 60–70 cm wide (see photos). Job includes: • Cutting out damaged plasterboard • Installing new plasterboard patch • Taping, setting, sanding • Priming and painting to match existing wall Wall is internal, no moisture damage. Please bring your own tools and materials. Looking for a neat, professional finish.

Remove door and put Gyprock wall on both side All door fitting need to be removed Wall need to be painted after work is done All things need to be cleaned after job Door size is 210 length and 100 width cm

Replace approx 6m x 1.7m garage ceiling plaster to exposed joists after plumbing repair works. Surface to be ready for painting. Available material for use: - 3x Gyprock CSR 3600 x 1200mm 10mm 4.32sqm Plasterboard RE - 100x 6G x 3mm plasterboard screws - 1kg stud acrylic Screws have been removed from joists. Area under works to be cleared prior. Plan is for Knauf Sheetrock 55mm Plaster Cornice Cove (or similar) to be installed after then area to be painted (not included in this quote).

Im building a salt cave and need a frame and gyprock put up no sabdu g or painting as it will be coveted with cladding also need to drop a door too

Looking for an experienced gyprock / plasterboard installer to supply and install gyprock in my garage in Bundoora (VIC). Scope of work: • Supply and install gyprock to garage walls and/or ceiling • Fixing to existing studs • Taping, stopping and sanding – ready for painting • Clean and professional finish Details: • Location: Bundoora, VIC • Garage: Standard residential garage • Access: Easy access • Open to quotes including materials + labour • Happy to discuss onsite inspection if required Requirements: • Experience in plastering / gyprock installation • Own tools • Public liability insurance preferred • Ability to provide examples or reviews Budget: Open to reasonable quotes (please include what’s covered) Please message with your availability, quote, and experience