Find a professional gate installation in Thornbury

I need the track that the sliding gate runs on re done and leveled which involves lifting existing concrete and re pouring a new level base

due to movement in either fence or post, the magnetic latch is not connecting.

Electric gate not moving, cog is still spinning though. Also back door not locking properly, seems to change due to whether, I’d like advice on whether to replace the lock

New garden gate needed that’s lockable from the back and front (ideally w proper lock not cheap D&D lock)

Pool gate was taken off by previous owner and we wish to have it rehung. Screws and brackets still exist, just need a professional to hang it

My gate latch has come away from the brickwork and needs to be re-attached - see images. Additionally, the laminate has come away from my skirtings in three places - kitchen and bathroom and need re-attaching. I have purchased the glue for the skirtings.

Around 11m of fence and an electric gate for driveway.

My gate is broken at the latch. I think it might be because it’s become weathered over time so it squished into the middle on an angle. Please see photos for your reference. It was really difficult to open and close and recently the metal latch has fallen off now too. Basically it really just needs some TLC :) Will add better photos in the morning

My side gate blew off and fell apart due to the wind. It was already vulnerable and has been flapping/losing palings now and then. I need it either repaired or replaced and also I need a better solution for latching it and keeping it secure on the fence side.

I'm after someone to install a gate at the sideway of my house. Needs to supply posts & gate. Also attach a cover for my solar inverter on the wall of the house.

Clean the front face of our roof.

replace the old opener with a new one that I have

Hinge on wardrobe need repair or replaced. Out side gate needs alignment.

Supply, install and paint( 2 colours) picket fence including gate. Height of fence approximately 1m. Length of fence approximately 15m

Fence pedestrian gate is hard to close and needs some adjustment. The driveway gate needs to be fixed where section of the driveway fence had become detached. Some panel/pieces of the fence have come loose and fallen off requiring repair or replacement.

I have an automatic gate at my house with remotes, but I haven’t been able to code the remotes to the gate, so we can only operate it manually (pressing the open and close buttons inside of the unit that controls the gate)

Hello, we need a timber double gate and side gate built and installed with lock hardware at our house in Thornbury. The double gate will span across 2700mm and be 1900mm high, itcan be hung from the carport’s steel posts (they’re 75 x 75 with a 2.5mm wall). The side gate will be 1080 x 1800 can be hung off a brick wall and may need a post installed on the other side to strike onto - this will be replacing the existing green gate that’s in the photo. Looking for design pine that we will then paint ourselves and for the gate to have palings without any gaps and a border around it (some reference images attached). Thank you!

Electrical drive way swing gate not closng correctly

A carpenter removed a tin shed but left these sharp metal edges jutting out of the ground and embedded in concrete. These would be very quick to remove with the right tools, as there is under a metre in length.

A hinge on my front gate seized up and snapped and now needs replacing. I would like to replace all four hinges. The hinges are welded to the gate frame, and screwed with bolts to the fence post. The old hinges will need to be removed with a grinder. I can provide the hinge hardware.