Find a professional gate installation in Toorak

Reprogram remotes for two gates

Remove old garage gate and all gate related equipment including the two support posts. Gate cut but cut down on site if needed. Size is about 5m wide, 2m high. Side gate 1.5m x 2m. Quite heavy. Remove all brackets from the ceiling also.

Prepare and repaint front gate

Need an entrance gate built. Looking to have something similar to the 3rd image. The stone walls are cut so will also need some sort of steel frame on the sides to fix the gate too and finish off the appearance, like a capping.

Raise timber gate by 10cm. Add a 10cm high block of wood underneath the raised gate so minimal gap to ground. No painting required

Assemble dog bed and assemble children gate for inside kitchen

Require a plywood double gate for the front of our property doing construction. Soon the gate has broken in the wind storm need this done on Monday.. the gate would be something you would see a construction company put up for construction work being done on a home the third photo below shows what typically we would want does not have to be painted. Current gate is 1200 mm wide by 2200 high.x2. We would use a chain and lock foreclosure.. we are only interested in builders doing this job.

Need new gate remote, and programmed gate currently stuck open, so looking for asap will reimburse for remote in addition to fee Current remote is Elesma gate remote key 301 27.145MHz FMT301/FMT401 (not very good!)

Need new gate remote, and programmed gate currently stuck open, so looking for asap will reimburse for remote in addition to fee Current remote is Elesma gate remote key 301 27.145MHz FMT301/FMT401 (not very good!)

Need to cut the gate add hinges attached and latch.

Reset gate buzzer by pairing the buzzer with the gate motor

The gate latch won’t release remotely. I think the gate has dropped a little and needs to be realigned. Putting some washers on the hinge pins may do the trick but the gate has to be lifted off its hinges to do that

Gate sticking due to heat. Difficult to close. need someone who works with steel and knows gates Many thanks Margaret

The gates are touching at the top & cannot be opened & closed easily.

Metal gate to be attached to balcony railing with a timber post to be added for the gate to hold onto

Need a secure side gate installed at my townhouse. Length of gap is about 97 cm. Ideal height is 2M Alternatively, this side pathway just needs to be secured with a temporary barrier of the same height and width, as we are renting and have a 1 year old and we are getting a dog.

I need someone to repair the gate at my property. As you can see in the attached image, part of the gate has come loose and needs to be secured with nails or other appropriate fasteners.

Need a secure side gate installed at my townhouse. Ideally similar/matches the side gate of the neighbouring townhouse. Length of gap is about 97 cm

We have 2 metal gates in our property wall. One is very stiff, with some rust in it's bottom hinge, which may need to be replaced. After rain, the walls move slightly, which can jam the gates, so it would be ideal if both could be moved ~3 millimeters. Both need hydraulic arms replaced. The main bodies of the gates are in very good condition.

Gate should open from inside when green button on side is pressed to free lock. Not working