Find a professional gate installation in Brighton East

Side gate needs repair along with potential internal door hinges and handles.

My garage gate is currently not opening properly. The top bolt that holds the gate’s stopping mechanism has come loose from the brick pillar. Additionally, the ground stopper has been pushed out of the ground. It appears the issue has developed over time because the gate motor continues running for a short period after the gate fully closes, pushing hard against the stopper. This has eventually dislodged both the top bracket and the ground stopper. I’m looking for someone experienced with gate repairs to: 1. Re-secure/re-attach the top bracket and bolt firmly back into the brick wall 2. Re-fix the ground stopper securely into the ground Please reply with your rough quote.

Gate: fix and reinforce the bolts and screws in wall for lock to go into (see photo - the cement has worn away around screw) Pelaton bike - carry up about 15 stairs. Probably need 2 people for this (50-60kg)

Gate: fix and reinforce the bolts and screws in wall for lock to go into (see photo - the cement has worn away around screw) Couch: the material has ripped away from the seam and needs to be stapled back and resecured

Description: Looking for an experienced concreter to construct exposed aggregate concrete bench seating, similar to the attached photo. Scope: Two sections: approx. 37 metres (main) + 18 metres (separate section) Construct concrete bench seating only (no planting required) Finish: exposed aggregate (clean, modern look) Straight, level, and consistent height throughout Full formwork, pour, exposure, and sealing included Location: Brighton East, Melbourne Requirements: Proven experience with exposed aggregate concrete Must provide photos of similar work All labour, materials, and clean-up included Timing: Flexible start Budget: Open to quotes

Paver has lifted on step at gate & also on step on entrance porch

I need a front door bell needs to be installed in the front gate post It is the first time to be install

Install a new gate lock.

Fix metal gate, put new metal plate in the middle to connect arm to gate,drill holes, place screws

Old motor burnt out need to replace with new supplied motor

We are buying a DIY colorbond double gate which needs installation in our driveway. Two fence post need to be concreted in (concrete already exists) and the gates to be hinged on.

I am planning to build a new front yard fence with the following specifications: • Total width: approximately 17 meters • Height: 1.5 meters • Structure: brick wall base with wrought iron panels on top • Gate: one automatic sliding/swing gate for vehicle access The photos are current looking and what I want to make Price is negotiable

Hi Guys. My gate’s metal frame needs to be reinforced by welding. Welding tools are required. All four corners need to be re-fixed. Please Including in price if new hitch needs to be replaced.

I have an old rotten garden fence post that needs removing then a replacement of the same size to be installed. The fence and gate are collapsing because of this rotting corner post. The new post will need concreting in and aligning.

Our manual front gate has become misaligned on both sides. One side has popped out completely, and the hinges may need to be repaired or replaced. It may require full reinstallation to ensure it closes properly and is secure.

Move gate down closer to the ground and install a digital PIN lock

Key release function on an iView intercom system is not releasing the front gate lock. Doorbell works fine but no image is displayed on the internal screen showing who the visitor is. Maybe the camera is broken or the internal system has an incorrect setting. We have recently moved into this property so unfamiliar with the iView system.

Supply and Replace exisitg mechanical pon code lock or supply and install bateery operated digital lock

I need someone to program the gate motor, connect remote gargare door receiver and program the front door lock (samsung) - I ahve all the instructions - should take max 2 - 3 hours for someone who has done it before

We have a new Lockwood touch pad lock that we would like to have fitted to our front gate.