Find an experienced flooring expert in East Melbourne

Laying hybrid flooring in existing floors

Laying hybrid flooring in existing timber floors three bedroom house

Lay engineered timber floor in small corridor. We have the direct stick glue etc. We will also take up the carpet first.

Looking for an experienced flooring installer to lay commercial-grade vinyl or suitable flooring for a small café in Ashburton VIC. Scope of work: Approx. 15–20 sqm Floor is currently concrete Needs basic prep and clean finish for customer-facing area and staff zone I’m aiming for a clean, cost-effective fitout — nothing fancy, just safe, smooth and food-friendly.

this is kids apartment... we have just ripped up carpets, underlay scraps left being taken up. cement slab to lay we think bunnings floors. 50 sq metres. We will supply the floors and trade assistant to lift and assist with cuts etc... to get job done quick.

Finish installing engineered timber in the hallway (We have engineered boards ready for use)

I need skirting boards installed in 5 rooms. They have already been removed. Roughly under 60 lineal meters of skirting boards across 5 rooms. I've supplied a floor plan and the ones highlighted in red are the ones that need to be installed. I have the original boards for the ground floor bedrooms but only half for upstairs. Need a quote for supplies too.

Hello. We have approximately 50 square metres ground floor two-bedroom apartment that we need to have click floors laminate laid. We will have the surface completely clear (demoed carpets, baseboards up) and all "Click - floors" from Bunnings in packages in the unit unwrapped and sorted propertly. In addition, we can supply our sons as assistants to lift the floors and pass to you to help lay and put in place. Don't have any images at this stage as we get possession of the place this Friday.

Garage floor is approximately 8 m x 8 m concrete slab with old final tiles in good condition over the top. Rubber used to be rolled out across the whole garage. Just a few cut outs. Rubber used to be stuck down with adhesive.

Looking for hybrid flooring install (maybe supply as well) for a room on concrete slab approx 32sqm and about 17 steps. Carpet is all removed.

Pick up carpet from Fowles, Clayton. Install on concrete floor (5.5*5.8) in Bulleen. Garage is empty, floor is clean. No underlayer needed.

Provide labor to lay hybrid timber flooring . Removed carpet. No disposal required. I supplied the Timber flooring material

Around 24m2. Remove and dispose off Vinyl and Masonite/MDF (not sure what it is) underlay in kitchen and dining room. Refer photos.

Hello, I'm looking for a reliable and experienced flooring professional to help with the following task: Job Details: Location: Upstairs area of my home Date: Flexible, but ideally 23 or 30th of May Areas: Small corridor and 3 small bedrooms (floor plan attached for reference) Scope of Work: - Remove existing carpet - Prepare the surface (wooden floorboards are underneath the carpet) - Install supplied hybrid floorboards and floor trims (if needed) We will provide the hybrid floorboards and trims – you just need to bring your tools and expertise!

Install carpet over existing carpet living room and study room

We need part of our flooring to be replaced with new Vinyl sheet flooring. More can be discussed on site.

Small side room used to be a gym. Replace flooring with underlay, install laminate and edging. Approx 5x2m. Laminate purchased.

Lay carpet I have hallway area need to be laid appeox 3sqm I provide carpet material Just need a handy pair of hands

Need to remove and supply and install flooring

Floorboards for kitchen. 4.6x2.7m I already have purchased the floorboards and the underlay

Need floor sanding and restoration for a 2 bed unit where living room and both bedrooms are covered with timber flooring (50-60m2). Need to have the quad trim replaced for all area. The material is shown in photo.

Wooden floor polishing for2 rooms

I have just pulled up some old carpet and would like to get someone to sand and polish the floorboards. The floorboards are in great condition and no repairs are needed. Please see photos and plan attached. Final colour should match as close as possible to the other floorboard area you can see in the "short hallway" photo (noting they will probably not be exactly the same). The plan measurements are quite accurate. I very roughly work this out to be approx 9.3m2. There is very easy access for equipment via the front door. Day and time is flexible and can be worked out after we have selected someone. Ideally in the next 3 weeks. Job is in Kew East.

Sand and polish floor boards in 195 sqm house, ground floor only. No furniture, it’s an empty house.

Sanding and varnishing of floor boards in room approx 3.5 m x 4 m

Wood Floor Staining Job | Bulleen | 80-90㎡ I am looking for an experienced and skilled worker to change the color of my wooden floor in Bulleen. Job Details: • Floor area: Approx. 80-90 sqm • Task: Sanding & staining to change the floor color • Must ensure a smooth and professional finish Requirements: • Experience in wood floor staining and refinishing • Reliable, detail-oriented, and efficient • Own tools and transport preferred

Damage to floor, largely due to water stains. Looking for repairs on those spots, bringing the floorboards back to their original colour, and a whole polishing of the area.

Need timber floor polished and recoated

Flooded studio apartment on lower ground. Floorboard needs to be ripped out. Concrete floor under needs fo be polished. Room size around 20sqm.

I have a unit that has a hardwood floor that has been stained with use over the past few years. It's roughly 50m2. I need to have it sanded down and coated with polish so that the floors are presentable.

I need floor boards sanded and polished 70 square

A few areas of floorboards in lounge need to be repaired/polished

You need good attitude and when u done I’m happy to pay full day

I have an area that’s about 25sqm. Remove tiles and either do polished concrete or grind and seal.

Previously had carpet and Lino, already pulled up. Need to fill staple holes, sand floors and polish. Repair one spot in the middle of the room so the entire floor matches. Squeaky in some areas as floorboards have popped up - must also fix this. Approx 40-50 m2

Sand and clear coat existing Kitchen and Family room Tasmanian oak hardwood flooring. Furniture has been removed

Sand and polish with water-based finishes for an area of 106 m2 (approx.)

Bedroom was with carpet, now removed. Boards need to be prepared, sanded and polished to match rest of house. Area is 3.6x3.6.

Sand and polish Baltic pine in one room 4 m x 4.2 m.

Need to remove the burn mark on wooden floor and polish it. Looking for an affordable rate Sq ft 1x1

Timber floorboards in small kitchen area need revarnising and a light buff/sand as varnish worn away in high traffic areas Room measurements: 1.9mx 3.6m - Due date: Flexible

I have recently installed a new floating floor. There are two rooms either side of the new floor that have carpet in them. The carpet needs to be refinished up to the floating floor in the doorways using new smooth edge, there is no need for any metal trim as the floating floor has a trim already. One doorway is 800mm the other is 1500mm. - Due date: Flexible