Find trusted local electricians in Melbourne

garage with power needs Supply and Install 2x Double GPO's and Certificate of Safety

Looking for a licensed electrician to complete two jobs in my first-floor apartment: * Install a ceiling fan in the bedroom (fan already purchased) * Replace the existing hallway pendant light with a new pendant (new fitting already purchased) There is access to the roof/attic space above the apartment if required.

Install 2 PowerPoints into splashback. Should not take very long. Correctly wired/Covers etc supplied.

Hi I have a small unit in Richmond. Need and electrician to put some power points around, wires for lighting ect.

I need someone to bring their ladder to change 2x down lights on a roof 3.2m tall. I already have the new down lights

Hi, I'm looking for a licensed electrician to provide a written quote and install a standard 10A power point inside my ground-floor garage for charging a Tesla Model 3 using a Tesla Mobile Connector. **Important – Victorian EV Charging Requirements** A dedicated wall-mounted EV charger (such as a Tesla Wall Connector) is NOT required. The Victorian Government confirms that EVs can be charged using a standard Australian 10A household power point (Level 1 charging). Reference: https://www.energy.vic.gov.au/renewable-energy/zero-emission-vehicles/charging-your-electric-vehicle The installation must still comply with Victorian electrical safety requirements, applicable Australian Standards and Tesla's instructions, including any dedicated-circuit requirements. **Existing Setup:** - Existing outdoor power point on the upper-floor balcony, connected to my electricity meter. - Garage located approximately two levels below. - Preferred cable route is vertically down the external brick wall using protective conduit. - New standard 10A outlet to be installed inside the garage, protected from weather. **Scope of Work:** 1. Assess whether the existing balcony circuit can safely support regular overnight EV charging. 2. Provide a written quotation for landlord and body corporate approval. 3. Install a standard indoor 10A outlet using the existing circuit only if compliant. 4. Ensure appropriate electrical protection, earthing and testing. 5. Provide a Victorian Certificate of Electrical Safety. **Budget: Maximum $250**, including quotation, labour, materials, GST and certification. I am renting, so installation can only proceed after landlord and body corporate approval. If a dedicated circuit or additional electrical work is required, please explain before proceeding. I am seeking a safe, compliant and cost-effective solution without purchasing a wall-mounted EV charger. Photo of proposed installation route attached. Thank you.

We bought a Electrolux steam oven and thought we could plug it into existing outlet. However it requires it to be hardwired. PowerPoint already behind oven that the wires can feed into. Put 10 dollars as it is minimum and not sure how much it is, but please add your price

1. check flickering down lamp 2. Rerouting/ extending PowerPoints for 5 location. PowerPoints purchase required. Fairfield/Preston Bunnings nearby.

My LG air conditioner recently stopped working. The inside unit works for about 5 minutes before switching itself off and displaying error code C5. The outdoor unit doesn't seem to come on, and the fan doesn't move. I've power cycled both units with no success, and there's no physical damage anywhere. I need a licensed technician to diagnose and assess the problem, so I can decide whether it's worth repairing, or if it needs to be replaced. It's in my apartment and the unit is getting close to 20 years old. I've included photos of the units and model numbers etc. Located in South Yarra and there's free visitor parking inside the apartment building for vehicles under 2.2m height. Please let me know if you have any questions, thanks 😊

Looking for a electrician to replace the function selector switch on our built-in Belling IB609FP electric oven. The function knob snapped off and the switch shaft broke flush with the switch, so the switch needs replacing. Everything else on the oven was working fine before this. We have the replacement part ready (Glen Dimplex part [22102002 / 20884983]). We believe the job may involve: - Isolating power and sliding the oven out of the cabinet - Removing the control panel (it has a glass front, so please take care) - Swapping the old switch for the new one and transferring the wiring - Refitting the oven and testing each function We are open to fixing it other ways though if you can think of any. Photos of the broken knob and switch are attached.

Looking for an affordable, reliable, licensed and insured electrician to install 3 supplied light fittings. PHOTOS ATTACHED. 1 pendant light and 2 wall lights as shown in photo. Occasional advice and installations for lighting solutions for future interior projects may also be needed so potential for ongoing work. Please provide quote. Photos and job details will be provided. Please share your availability and licence details. Required electrical safety certificate to be included.

Just changed a switch over electrics are fine

Electrician Needed – Today if Possible Looking for a licensed electrician to come out and securely screw an electricity meter back into place. Should be a quick, straightforward job, if safe and permitted. Preferably today (ASAP). Please message me with your availability and price. Thanks!

Looking for a licensed electrician to install two ceiling fans with lights in our house. Scope of work: * Remove/disassemble the two existing light fittings. * Install two new ceiling fans with integrated lights (fans supplied by us). * Check and ensure there is suitable timber support to securely attach the fans to the ceiling. Timber may need to be installed or reinforced if required. * Connect and test the fans, lights and switches to ensure everything works safely. Requirements: * Must be a licensed electrician. * Please bring the necessary tools and materials. * Please advise if any additional timber or other materials are required and whether this would incur an extra cost. Please provide a quote for labour and any additional materials. Photos of the existing fittings and ceiling can be provided if helpful. Fans: https://www.ceilingfansdirect.com.au/product/white-martec-link-48-ceiling-fan-with-2-x-e27-light-and-remote-20707?omnisendContactID=6acca481b9ab8218806abd2d&utm_campaign=Order+Shipped&utm_content=64f531b1990d8c96955f406c&utm_medium=transaction-email&utm_source=omnisend

Remove Existing hard-wired exhaust fan in laundry and install new exhaust fan. The task involves cutting the plug wire and affixing it the existing wire coming down from the ceiling which is connected to a wall switch.

Light and fan switch in the bathroom needs replacing. And the two bathrooms are wired in such a way that both fans are linked and the switches operate strangely. Hard to get one on and one off or both of or on etc. Please fix

Hi, I’m looking for a qualified electrician to remove and replace 2 existing pendant lights with new ones. The entire pendant fittings need to be changed. Old pendant (pictured) New pendants are 1 x lantern with cables and the other is a black pendant light (photo attached) If can be done towards the end of next week

Smoke alarms are going off and batteries need to be changed. I am unable to get on a ladder at the moment due to surgery. Just need someone to go buy batteries and come change both batteries so they stop beeping.