Find trusted local electricians in Canberra

Looking for a licensed electrician to install a new weatherproof outdoor power point on an external brick wall. There is an existing indoor power point directly behind the proposed location, so hoping it should be a relatively straightforward installation through the wall (brick veneer). Photos attached showing: • Proposed location of the new outdoor power point (marked with red X). • Existing switchboard/meter box. Please provide a quote including supply and installation of the outdoor power point. Located in Florey, ACT. Flexible with timing.

This was was built by previous owners prior to selling so it could be sold as an extra bedroom - it’s not load bearing and doesn’t have electrical in it. We want the wall removed to the door next to the kitchen. (You can see where the wall has been attached)

I have three recessed downlights installed (wired), only two working at the moment. Would like to replace them with smart lights (likely the Nanoleaf) and also install a Shelly 1 Gen 4 relay switch. The switch controls all three lights. I haven't got Home Assistant set up yet, so assume will need to have the Nanoleaf act as 'dumb' lights, but priority 1 is painting the room! Happy to discuss/get suggestions - the lights and the switch are arriving Monday, but can always return if needed.

Hi I need a certified electrician to: - Install a ceiling fan and 2 low profile downlight in a master bedroom -Fix / replace a sensor light in the garage.

I need two quotes and the work completed asap: 1, fit ceiling lights/fan see images for details/brand. Iv disconnected the current light as per pics and have now lost power to half the lights in the house and the heating. I need the bracket mounted to a knoggen or sufficient to carry 12kgs. (Not straight into plaster) so it’s likely the electrician will need to access the roof space and install 3 plates/noggins for fixing to. Or 2, If this is two expensive just a quote to fit 3x new lights to the ceiling through the plaster board. Iv attached images.

Looking for a licensed ACT electrician to complete the lighting fit-out in my newly built home in Dickson. Scope of Work • Install approximately 50 supplied Clipsal LED downlights with 50 supplied plug bases. Existing lighting circuits are already in place with one ceiling light point per room. Each room requires the existing light point to be expanded to approximately 4–6 downlights. Electrician to run cabling between lights, cut ceiling holes, install plug bases, connect and test. • Install 1 hallway chandelier. Existing electrical point is available, however there is no ceiling support/hanging point, so suitable structural support will need to be installed. • Install 1 kitchen island pendant light. There is no electrical point or hanging point above the island, so a new electrical feed and suitable ceiling support will need to be provided. • Install 2 bathroom Tastic-style heat/light/exhaust units. Existing power is available. Ducting needs to be connected to an existing duct point approximately 2–3 metres away. • Hardwire 5 LED bathroom mirrors. Electrical connection points already exist behind each mirror. Materials Supplied I will supply: Downlights Plug bases Chandelier Island pendant Bathroom Tastic units Bathroom mirrors Electrician to supply any additional cable, ducting, mounting hardware and consumables required. Please provide: Fixed price quote (labour) ACT electrical licence number Estimated duration Earliest availability The house is a new build with good roof access. I'm looking for a neat, high-quality installation and would prefer a fixed-price quote rather than an hourly rate.

Power point to be installed in a bedroom.

Removing several power points from 2 walls in a office.

Need lightbulbs and downlights replaced

A couple of electrician based tasks required around the house - installation of a new light fitting in the living room (3 independent lights to be hung together similar to first pic) - replaces existing - installation of 6x up/down lights around the deck - new fittings - rewire a standing lamp

Replace power point and rewire . Middle switch is lopsided and is causing Induction hob to switch off

Couple of down lights Extra power points Exhaust fan bathroom and re wire with independent switch 1 switch replacement

Hello, We are looking for a licensed ACT Electrician to attend our retail store, in Westfield Belconnen, to replace two faulty track light fittings. The Issue: Two of our ceiling-mounted track spotlights have stopped working. As these are integrated LED units, the entire fitting needs to be replaced, not just a bulb. The Job: The task is to supply and install new, like-for-like replacements for the two faulty lights. The scope of work includes: 1. Safely accessing the light fittings on the high ceiling track (a suitable ladder is required). 2. Removing the two faulty light fittings. 3. Supplying and installing two new, compatible track light fittings that match the existing ones in style, colour, and light temperature. 4. Testing the new lights to confirm they are fully operational. Requirements: - MUST be a fully licensed and insured ACT Electrician. - You must have your own tools, including an A-frame ladder appropriate for a high commercial ceiling. - The contractor must be able to source and supply the two replacement track light fittings. Location & Timing: Location: Westfield Belconnen, Benjamin Way, Belconnen ACT 2617 When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include all labour costs AND the cost of supplying two new track light fittings. Thank you.

After painting the wall I went to put the light switch back on and two of the wires came out. I just want an electrician to put them back in safely.

I need a sparky to do a small job for me, check that this PowerPoint is safe (something fell on it) and put a new face plate on. I can sort out the rest (patching and painting)

Hi all, Looking for someone to help with a small job: Replace a cracked power point cover (GPO), outlet is working fine Location: Ngunnawal ACT 2913 Happy to share more pictures Let me know your availability and experience. Thanks!

Hi there, I’m looking for someone to assist with the following in my home: • Replace approx. 8–9 existing light fixtures with modern LED fittings • Replace 2 power point covers (no rewiring required) • Create 1 new ceiling light point in a bedroom (cutting access in ceiling + install) • Fix a bathroom heat lamp that is no longer sitting flush with the ceiling • Check bathroom exhaust fans (2x) – one not functioning another quite loud Notes: • Light fittings can be supplied • Please bring any other required materials/tools • Most items are straightforward swaps

（10mins job）Electrician needed to change a battery smart meter/smart power sensor, model ADL400N-CT, tech support from manufacture will provide you a new meter and instruct u to do this.

Electrician to replace two light switches in my home: • One four-gang switch in the bathroom • One single-gang switch in the bedroom I already have the replacement switches ready, this job is simply to install/swap them over