Find trusted local electricians in Darling South

I have 5 mains powered smoke alarms in my property that need replacing. I have already purchased the replacement alarms so am in need of an electrician to install/wire the new ones for me. The new alarms are the same make and model as the previous ones which should make the installation easier. I am located in Malvern East. Looking forward to receiving your quote.

Install approx 10m of electrical cable from house to new front gate. I will dig the trench to require depth (600mm). Task involves working with gate installer to figure out exact location where power needs to be provided to ensure proper working of the gate. Must supply all materials.

Looking for an electrician to come today to remove 2 x led mirrors from wall (installed to electrical panel)

The main power board had a switch tripped

I need a quote to install around 20 down lights in a townhouse in Malvern East. Approximately 13 downstairs and 6 upstairs. The down lights come with an AU plug. I will supply the lights. Would there be any difference in cost if upstairs or downstairs? Price for installation per light would be useful, then I can confirm exact number. Electrician to provide CES upon completion.

-wiring to studio in back garden (conduit already in) for power and lights; -moving power point -installing heated towel rail (wiring already present)

I need help with three things. 1. Three plug sockets removed and disconnected. 2. One led light replaced in the bathroom and 3 investigate a ceiling fan that is not working when switched on

Power point in bedroom detached from wall

Hi, looking for electrician for jnstall led light at work

Install new fuse box per AS/NZS 3000:2018 Wiring Rules, which include the following key requirements: 1. RCD Protection: • All final sub-circuits must be protected by 30mA Residual Current Devices (RCDs) to prevent electric shocks and reduce fire risks. • where applicable use RCBOs (combining RCD and overcurrent protection) for individual sub-circuits to avoid supply loss across multiple circuit.

We require an electrician to install a ceiling fan. There is currently a pendant light in the position where we would like the fan. We are providing the fan so just labour only.

Gas water heater doesn’t light. Can’t hear gas but gas stove is working.

Scope 1. Remove existing light fitting 2. Install new bathroom vanity light fitting Labour only. Will supply light fitting from Beacon.

Sandwich bar fridge temperature not reach the right temperature .Especially in the hot day.

Smoke alarms beeping. Need checking and probably batteries changing.

Running the airconditioner (cooling) is causing the air conditioner circuit as well as the mains switch to trip on the switch board. Need help resolving

Handyman to attach cctv camera and solar panel to wall today, you will need your own tools and a ladder

I need someone to come and help preparing the electricals for downlights. I want to remove the light in the photograph and rig up 4/5 downlights. I’ve done as much as I know how. I’ll of course pay for any materials needed.

Scope: 1. Remove existing light fittings 2. Install new light fittings Ceiling internal: 11 approx Bathroom wall light: 2 Front entrance: 1 Outside Spotlights: 3 approx Note: some of fittings have been unscrewed from ceiling. Materials: Light fittings to be supplied (from Beacon Lighting). new fittings might be different (flush or pendants etc) than existing Fee - fixed fee only.

Replace and install a new SAL dimmable LED downlight