Find trusted local electricians in Canberra

We're running an outdoor event on Friday 27th March (5 hours), Saturday 28th March (2 hours work, 10 hours sitting around) and potentially Sunday (2 hours work, 10 hours sitting around), and require the services of an electrician to connect power from a 3-phase Park power supply to our stage, marquees, food and general stalls. We also need to determine if we need to organise a backup generator to power our event. Once the connections are done, you're sitting around on standby, and available for support and technical assistance if need be. The amount below is the hourly, if you're a qualified electrician who wants to make some easy cash over a weekend, we'd be honoured to have you.

Needing Eletrician to install 5 down lights inside the living room and 1 porch light outside the front door. The ceiling has markings to show where the cables are, and you will need to cut a hole to put in the lights. I can supply the down lights or oyster lights. Please send a quote and message for option 1)down light installation and 2 ) 2 oyster light installation

Install power point at verandah for Starlink. There are two potential nearest connections as shown in the photos.

Supply and replace 2 x fluorescent lights to new 1200mm led baton lights . Supply and replace 2 gang switch

Looking for someone to supply and install a solid panel on existing fence to reduce noise from my heat pump hot water system. Details: • Panel approx 2.1 m high × 1.0–1.2 m wide • Installed on fence opposite the unit (narrow side walkway) • Must keep walkway clear and allow access for servicing • Optional: include acoustic backing (rubber/foam) for better noise reduction Goal is to reduce noise toward neighbour (currently ~5–8 dB above limit). Budget: $300–$600 (open to quotes depending on materials) Located in Canberra. Photos available.

Floodlight to be installed on a brick wall above a carport. There is already electricity to the carport.

Need to install mesh to bird proof my solar panels on double storey house on both sides

I want 32 downlights I will supply the downlights (they are Phillips with plugs, so the job will need wire and sockets

The hot water heat pump stopped working and no hot water. Need someone to diagnose it and give me a quote of how much it will cost to repair. Brand is Quantum Energy Technologies and model number is 340-11AC3-134

Install the light pendant at the kitchen celing

Need a new power point put in for my work station

The external unit is not starting properly. Indoor units work fine, but the outdoor fan was not spinning and now only spins slowly / intermittently. No loud noises. Likely run capacitor or electrical issue. Looking for diagnosis and repair ASAP.

I request a qualified electrician to install two pendant lights as per the circled green colour and deactivate (so they don't turn on) the two ceiling lights as per the circled red colour. In short: you would need to make the circled-red ceiling lights completely non-operational—so that only the pendant lights turn on when I use the switch—you would need to disconnect the wiring that supplies power to those ceiling lights. The wiring should be inside those individual red-circled lights.

I just need a light globe change - but it is an old socket. The switchboard has been upgraded.

All quotes welcome. I need 2 indoor lights replaced. One is a bathroom vanity light, and the other is a dining room ceiling light that has already been removed. The other two are outdoor wall lights that have already been removed. I already have the light fittings. There is existing wiring at the locations. I'm home all day Friday so flexible with timing, but perhaps not at the crack of dawn, and no later than 4pm please. I'll add photos shortly.

Two skylights side by side. Raked ceiling, exposed beams, tiled roof. 780x1400 fixed VELUX skylights M08. Have EKW01&03 side by side kits and solar blinds to fit. Need experienced installer.

Hi! We’re looking for a professional electrician or handyman to install four solar-powered security cameras at our home. All equipment comes in the box and is designed for easy installation — we just need someone experienced to set them up properly. Photos are attached for reference. If you're available, please let us know. Thank you!

I need two 70s wooden standard lamps to be rewired. Both have bayonet sockets for bulbs that look in good shape. Both have had cords cut at the base. I don’t have the replacement cord or wall socket. I’m in Wanniassa but I can drop these off Southside, especially Fyshwick.

An artwork fell and damaged the electrical socket, it has come away from the wall and the wooden mount is broken. Not needing exact match on style / wood, just need it fixed and working!

I need four small solar panel brackets installed so I can charge our outdoor Arlo cameras. I have attached pictures of the brackets and the location of the Arlo cameras. Two brackets need to be installed on brick, and the two other on axon cladding. A ladder will be needed. House is single storey. Max height is 4m.