Find trusted local electricians in Melbourne

We have had 2 motorised blinds installed but the power cord that was wired up when we first built the house is different to the power cord installed on the blind. Job is to change the house supply end of the wire to match that of the new blind as seen in the pictures.

Seeking a licences electrician two install two bathroom heat lamps (separate switches) and two outside sensor lights (replacing existing lights). Bathroom job will require plaster to be fixed, which we will take care.

I need a fully qualified, licensed Electrician (Registered Electrical Contractor) to install a new power point in my kitchen specifically for my refrigerator. The job requires: Running the appropriate wiring and installing a new single or double power point. -Testing the connection to ensure it is completely safe and dedicated for a large appliance. - Providing an official Victorian Certificate of Electrical Safety (COES) upon completion of the work. Please only bid if you are a fully licensed REC in Victoria and can supply the legal safety certification on the day. Please quote your total price including materials, labor, and the certificate fee. Located in St Kilda.

Looking for a licensed electrician to install three pendant lights in a single-storey home in Coburg/Brunswick. Scope of works: * Bedroom 1: Remove the existing ceiling light and install a new pendant light in a different ceiling location (wiring to be relocated). * Bedroom 2: Remove the existing ceiling fan/light and install a pendant light in its place. * Kitchen: Install a new pendant light in a new location where there is currently no light fitting (new wiring required). Additional information: * All three lights are to be installed on dimmer switches (existing switches are standard switches and will need to be replaced). * Single-storey house with good roof access above all three locations. * Plasterboard ceilings. * Pendant lights have not yet been purchased, so the installation will take place once fittings have been selected. * Please remove and dispose of the existing light fitting and ceiling fan. * All work to be tested and completed by a licensed electrician. Please provide an indicative quote for the installation and any assumptions made. Happy to provide photos or arrange a site visit if required. See images below: Switchboard Bedroom one existing ceiling fan and switch/dial for fan (new pendant installed in same location as fan) Bedroom two existing pendant (new pendant to be installed in different location)

I need the following electrical work completed: * Install a new switch next to an existing power point, where a switch was previously removed. * Replace 3 old-style slim double power points located in the skirting boards with modern double power points. * Install 3 new power points - one double power point approximately 2 metres from each of the 3 existing power points being replaced. The walls are concrete, so the new and replacement power points will need to be surface-mounted. Please provide a quote for the above work. Happy to pay for materials separately on completion if an estimate is provided.

I need a power point changes to a 20-amp (20A)

Hang light fitting. Photos attached

Hi there, calling electricians who diagnose /repair and or install split systems We have an AC split system that currently is flashing and won't turn on. Need help rectifying that error. Not sure how simple it is, if it's a setting or a repair. Could well be a new AC split system install job. Please advise your availability ASAP this week, ideally Wednesday, Thursday, worst case Friday if has to be Location: -South Melbourne location (next to Albert Park near MSAC) - parking provided Payment: $180 for 1st hour labour including call out. seperate (above and sepate to this listing): extra /seperate for additional hours - $100/hour I'll upload photos/details of the unit ASAP

Seeking an electrician to take down an old light fitting and install new one

Remove old light fitting and install suspension kit (supplied by me)

Hello, We require an URGENT, SAME-DAY call-out from a licensed A-Grade Electrician to diagnose and repair a faulty track light at our retail store, in Moonee Ponds Central. The Issue: One of our track light on the main sales floor has failed. It flickers intermittently and then shuts off completely after a short period. This is highly distracting for customers and staff and needs to be resolved as a priority. The Job: The task is to attend today to inspect and rectify the issue. The scope of work includes: 1. Safely accessing the track light (a suitable ladder is required for a ceiling height of approx. 3.5m). 2. Diagnosing the cause of the fault (e.g., loose connection, faulty track light). 3. Supplying and installing a new, compatible like for like replacement track light and/or driver if the existing one is faulty. 4. Testing the light to confirm it is secure, stable, and operating correctly. Please note: The successful contractor MUST be able to supply a compatible replacement track light and other required materials if required during today's visit. The cost of this hardware should be included in your final offer. Requirements: - MUST be a fully licensed and insured A-Grade Electrician in Victoria. - You must have your own tools and a suitable ladder. - You must be available to complete this job today, 17th July. Location: Moonee Ponds Central, 14-16 Hall St, Moonee Ponds VIC 3039 Please provide your comprehensive quote for an urgent, same-day job. Thank you.

Hello, We are looking for a licensed Electrician to replace a faulty ceiling downlight at our retail store, in Melbourne Central. The Issue: One recessed LED downlight in the corner of our sales floor has stopped working. The ceiling height: approximately 3.5 meters The Job: The task is to replace the faulty LED downlight. The scope of work includes: 1. Safely accessing the light fitting in the high ceiling (A-frame ladder is required). 2. Diagnosing the fault (e.g., failed LED unit or faulty driver). 3. Supplying and installing a new, suitable replacement LED downlight and/or driver. 4. Ensuring the new light's colour temperature and brightness matches the other existing lights in the area. 5. Testing the new light to confirm it is fully operational. Please note: The successful contractor MUST supply the new replacement downlight and driver. The cost of this hardware must be included in your final offer. Requirements: - MUST be a fully licensed and insured A-Grade Electrician in Victoria. - You must have your own tools, including an A-frame ladder. - Experience with commercial lighting, particularly recessed LEDs. Location & Timing: Location: Ground Level, 211 La Trobe Street, Melbourne VIC 3000 When: The job can be completed at your earliest convenience. Please state your availability in your offer. Please provide a comprehensive quote for the complete job. Your offer should include all labour costs AND the cost of supplying one new LED downlight fitting. Thank you.

Hello, We are looking for an experienced handyman or electrician to replace a blown light bulb in the rear staff stairwell of our retail store, at Chapel St, South Yarra. The Issue: The pendant light bulb directly above our steep staff staircase has blown, making the stairs dark and creating a significant safety/trip hazard. The bulb is located high up on a suspended cord over the staircase. The Job: The task is to replace the blown bulb. The scope of work includes: 1. Safely accessing the light fitting located above the staircase (appropriate tall access equipment, such as an adjustable stair-friendly ladder or extension bulb changer, is essential). 2. Removing the old bulb (looks like a compact fluorescent bulb). 3. Supplying and installing a new, energy-efficient LED bulb (Cool White or Warm White, standard bayonet/screw fitting). 3. Testing the light to confirm the stairwell is fully lit. Requirements: - You must have your own tools and appropriate, safe equipment to work at height on a staircase. - You must supply the new replacement LED bulb. - Public liability insurance is required. Location & Timing: Location: Chapel St, South Yarra VIC 3141 When: URGENT - As this is a primary staff access way and currently a safety hazard, we need this replaced as soon as possible. Please state your earliest availability in your offer. Please provide a quote for the complete bulb replacement. Thank you.

Change smoke alarm battery High ceiling so needs large ladder Need asap Roughly 4m high ceilings

MULTI-HEAD AIR CONDITIONING REPAIR – QUOTE REQUEST Location: Port Melbourne, VIC I am seeking quotes from licensed and experienced HVAC technicians to diagnose and repair a refrigerant leak on a multi-head split-system air conditioning system. Known Information: • Mitsubishi Multi-head split system • System is operating but performance is reduced • Technician has advised refrigerant level is low • Visible signs of refrigerant/oil leakage are present at the outdoor unit pipe connections • Suspected leak at flare fittings or external pipe connections Please provide a quote for: 1. Leak detection and confirmation 2. Pressure testing with nitrogen 3. Repair or replacement of leaking flare connections/fittings 4. Vacuum and evacuation of the system 5. Refrigerant recharge to manufacturer specifications 6. Full operational testing Please advise: • Your call-out fee • Hourly labour rate • Refrigerant type and cost per kilogram • Estimated total repair cost • Warranty provided on repair work • Earliest available attendance date Only licensed refrigeration mechanics please. Thank you.

Description: Looking for a fully licensed electrician to replace existing light switches with LED-compatible dimmers across four zones. The job requires: 1. Kitchen & Living Room: Replace a 2-gang (double) switch sitting between the rooms. Both the kitchen and living room lights are on 3-way circuits (controlled by two different switches). I want this double switch converted to a double-dimmer plate. The secondary switches for these rooms will remain standard. 2. Bedrooms: Replace standard single switches in two separate bedrooms with standard single dimmer switches. Bulbs: ​The existing downlights are dimmable Domus BOOST-10-WHT units. Switches: Current faceplate sizes are about 117mm x 72mm Requirements: - Must be a licensed electrician and provide your license number in your offer. - Electrical Safety Certificate must be issued upon completion. - Please include the cost of all 4 LED compatible dimmer mechanisms (preferable matching current switch style and of good quality like Clipsal Iconic or HPM) and new faceplates (or explicitly detail material costs in your offer). Thank you!

I need the power cord replaced on my Bosch Serie 4 washing machine. It has plug gas corroded / burnt due to hea lt and moisture in the laundry / not fitting properly. See photo.

I require the electricity to be safely cut/isolated in order to pull out old kitchen. Ideally also some advice in regards to how to run the power for new kitchen, see photos for the current shit show that it is...

I’m looking for a sparky to put existing down lights on dimmers. 2 zones off existing switch, new switch for dimmers if required. 4 down lights in each zone. Please see photos for reference. Sparky to supply material please.

Electrician as soon as possible. To fix switch - refer to photo. Moving into property. Safety switch won’t turn on. Any time from Friday evening.