Find a professional Villaboard contractor in NSW

Install villaboard ceiling approx 14m² in garage with corrosion resistant fixings.

Gyprock and close 2 bathroom hole in the walls using villa board as per the picture. I don’t have any materials or supplies

Outdoor area ceiling install 5x8 villaboard. Please quote. Photos to come

I need to sheet my pergola with cement villa board there is around 55 square meters

Replace water damaged timber frame in bathroom. Replace bathroom floor with 19mm cement sheets. Install 9mm villa board walls.

i need 9mm villaboard cut to 100mm heights at various lengths 2off at 1600mm 1off at 2600mm (can be 2pcs to make 2600mm) 2 off at 500mm all must be 100mm high and 9mm thick villaboard. delivered to byron bay

Looking for gyprocker to supply and install the following for small reno: Bathroom 1 - 5.5sqm of villaboard fixing only, wall with return and door cutout (Section 1:0.8mx3m, Section 2: .26mx3m, Section 3:1.3mx3m (minus door cutout)) Bathroom 2 - 10sqm of villaboard fixing only, one single wall (Section 4:3.5mx2.9m) Pantry - 8.4sqm of standard gyprock (backing to bathroom 2 wall above). (Section 5: 3.5mx2.4m) fixing and stopping.

I need some villa board patching in my bathroom. Install all new Gyproc ceiling & wall around toilet •Gyproc over existing ceiling. 2150-3800 •Gyproc over villa board around toilet cistern & door. 2.4-1m Villa board.. patching. 1m-600 2.4x 500 2.1-1m 1200-1100

Fix ceiling and sheet bathroom in villaboard

Sheeting bathroom walls and ceiling.

Looking for a carpenter/handyman. To quote for villa board sheeted in bathroom, small timber corners and skirting boards and make some cupboard doors In the laundry.

A carpenter has just finished putting in a couple of walls for a new bathroom in my granny flat and now I need someone to plaster the board gaps. The walls will be painted over and not tiled over and the walls are villaboard not gyprock as it is a wet area. I have hardies joining compound base coat and top coat plus a couple rolls of joining tape if needed. If you want to use your own materials that is completely fine as well.

Repaint villa boards front at house that has faded from the Sun Colour: Monument grey We will supply paint if you can supply all other equipment. It’s 2nd story Front face and right hand side face Approx 40 sq m

Need 2x 1.2 nib walls sheeted Either villaboard or aqua check Gyprock works Tasked must supply and install

A price for a carpenter, remove sheets, and sections highlighted only, with mould shown, and replace with Villaboard or similar waterproof product.

Hi, I need two sections of villaboard replaced in my laundry. Roughly, 500x600 and 600x600. Note; the taps you can see in this picture won't be there when you do the job. Also, Im tiling over the top so you don't need to give it a complete finish - Im just looking to basically repair this area but I wanted villaboard there as the area is located behind the laundry sink.

**Experienced Gyprocker / Plasterer Required – Outdoor Villaboard Pavilion** **Location:** St Ives, NSW 2075 I am looking for an experienced gyprocker/plasterer to complete the finishing work on two newly constructed outdoor Villaboard pavilion screens before painting. **Work Required** * Tape, bed and finish **2 vertical Villaboard joints** (each approximately 1.8 m high) * Sheets have been installed with an **approximately 5 mm gap** between boards to allow for proper tape and setting compound * Fill approximately **90 countersunk screw heads** (around 45 per screen) * Sand and feather all work * Leave ready for primer and paint **Materials Supplied** * Villaboard joint tape supplied * Large tub of filler / compound supplied * Structure fully built and ready to work on **Important** This is a feature structure within a recently renovated pool and garden area. I am looking for a **high-quality paint-ready finish** where the joints and screw heads are not visible after painting. Please only quote if you have experience with: * Villaboard / fibre cement sheeting * Joint setting and finishing * Achieving a professional paint-ready finish I am not looking for the cheapest quote. I am looking for an experienced tradesman who takes pride in their work and can deliver a quality result. Please Provide Phots of your work. Thanks Stephen

Need sheets installed i will supply everything

I need to patch my wall in my bathroom with Villaboard plus paint the wall

Cover existing glass splashback with villaboard then tile over with Kit Kat style tiles. Splashback is 690mm x 2190mm.