Find experienced local tradies in Point Cook

Looking for an electrician to: add power point in powder room add power point in Laundry wire in a doorbell Move power point in living area Rewire downlight in bedroom Fix comms ports for internet New light for backyard New exhaust fans for bathrooms

Retractable awnings not working, not sure if motor issue

i have a small job of plastering drywall that i have built for fireplace. its mainly corners of the frame. corner beads are also installed. Dimension are: H: 880mm, W: 2m, D: 285mm. thanks.

I have 8 evaporative vents that need to plastered, sanded and painted. Whole ceiling wont need to be painted as it is recently painted.

Need to swap a kitchen sink . It would need cutting the board a bit for adjustment . The current sink is 1.06m * 0.48m . It’s wooden board top . The new sink is 1080mm * 500mm. See photos .

I have two small speakers to wall mount, hence need to first do the power point and then mount the speakers on the wall

I want the rendering for the front face of my house

Render wall approximately 2m wide 6m high Prefer if you have scaffolding Or maybe able to do with ladder.

Scaffolding for rendering job 2m wide 5m high

Double power point installed in living room of a town house. Bottom level of home and with other power points within a few meters either side of where the new one needs to be installed to possibly run power off. Photo attached with red marking where point will be.

The socket came out from wall which need to be replaced and plastered

Install 2x outdoor power points in two different areas. See attached photos of the locations.

I want to get a quote for rendering the front facade of this house. Prefer if you could quote per Sqm rates as I want to try and render the side of the house as well depending on the cost. The facade would be a miminum

Need a bit of spot painting around the house, paint provided. Some areas may need a bit of plastering. Looking for someone to sand down an area and paint as well.

There is a hole in the wall caused by the door knob. Need it fixed.

Need help from handyman in fixing dent in my garage drywall. Images attached

I have two jayco larks and I'd like to have the awnings swapped.

Setting a gyprock wall

Data connectivity & electrician needed Note: no software config required. This is already sorted ! Single story house *** Task 1 *** Physical Install of PoE camera in front wall of the house - includes physically installing the camera on the outside wall - running a Cat6 network cable - length from front house wall to inside the house (about 20m). You will supply the CAT6 cable - inside the house you need to change from existing 2-port RJ45 wall-plate to 4-port RJ45 wall-plate. You do not need to supply this, I already have the 4-port RJ45 Wall plate. You only need to cable. Note: I already have a camera outside, this is the second one I'm installing, and you should be able to route the cable very easily, as the new camera is on the same wall as the older one, and it goes into the same location inside the house as the old camera. *** Task 2 *** install a new electrical powerpoint inside the house (you will supply this)

Need below 2 external power points for future gate and water feature. 1. Front of the Home. There is external GPO in the facade- take line from that to until the front (6m) -  see photo 2. Backyard - There is external GPO- take line from that to until the Fence (6m) -  see photo There are trenches already 600mm deep. you may need to correct in some places a little bit. See photo Follow the electrical guidelines to comply with regulation and provide compliance certificate. Once work is complete put back the soil and tidy up. With Regards, Prabu