Find experienced local tradies in Gold Coast

Need power point set up in garage for fibre box

We need 2 people to disassemble an old sauna and take it to the tip. Front door is glass and walls are timber. The photo has the dimensions. Walls re locked in place and need to be lifted up to pull apart.

Move bedroom light across. Move PowerPoint behind fridge to sit higher. Move PowerPoint in bedroom. Install a new PowerPoint in study nook

Needs a kings 270 freestanding awning firting to Thule evo bars or Yakima offgrid tray

It had a power point directly on the other side of the wall so very easy. Need an antenna point as well for free to air.

A bar has been removed so the wall needs plastering. Please see photo. Ask any questions you have. Job is a house in 4217 - Please offer your bid - thanks

Scope of work: • Filling gaps and penetrations • Applying expanding foam • General labouring support for renderer/wall works • Site clean-up as required

Quote to wire and connect a sauna to our switchboard. See photos of the carport where it will be installed and the switchboard which is on the left. See details below on sauna. Please offer a cost to come out and quote and we can go from there. Twin and earth cable 6kw 32amp RCBO 32amp 2-pole lockable isolator Single Phase

I have just purchased 3 x curtain rods. I'm going to remove the old retractable blinds and need someone to measure 250cm from floor, brackets over window to hang new curtain.

The bed knocked the wall on moving and put a small hole in the drywall. Needs repair before I vacate the rental.

Fixing holes in walls, and areas hooks have been placed into walls as well as some Areas paint has been ripped off the walls. Will need repainting in certain areas too. Paint will be provided.

Needing someone to come and finish patching the hole in the attached photo. I have compound and tape.

I have two holes in the plasterboard that need repairing.

Render Two External walls - quote & complete job I have two external brick walls that need to be rendered. Looking for someone to quote and complete the full job, including materials, labour, and Airtasker fees. The surface has an old-style Granosite texture. Colour to be added to the mix, and the job completed ready for painting. Photos attached for reference.

Renovating a small bathroom and getting it ripped out. Will need to replace 7m2 of villaboard/gyprock sheet in the shower. Also would need to cut out a niche. Two sides of the shower wall is villaboard and third is gyprock. Small patches of gyprock in the skirting. Feel free to quote or we can setup a time for you to stop by

Repair and paint window awnings and also repair a downlight fitting that is hanging from outdoor deck roof

Needing a repair done on a section of wall and roof. Part of it is where the cornice is. Don’t pay attention to price. Let me know what you can do it for

Fix the two holes in drywall, one large on small, ready for painting

Repair ceiling gyprock and paint

I’m replacing my existing hard-wired oven (20A) with a new oven that has a 10A plug. The current setup is a hard-wired 20A oven circuit (with existing cabling in place). I need a licensed electrician to: Disconnect the existing hard-wired oven connection. Install a standard 10A single power point (or double) (surface-mounted or flush, depending on what suits). Replace the 20A circuit breaker at the electrical switchboard with a 10A breaker to suit the new outlet. Test the circuit for safety and compliance (RCD, earthing, etc.) Notes: The existing cabling and circuit are already in place — just need conversion to a socket outlet. The new oven is 10A with a standard plug (comes fitted). Please bring all required parts (10A socket, 10A breaker, etc.) and include them in your quote. Location: Robina When: Flexible — ideally within the next week. Requirements: Must be a licensed electrician (please include licence number in your offer).