Find an experienced handyman in Upper Coomera

I'm after someone who has experience putting motors on roller doors. The shed door is too heavy for me to lift and support. The roller door on my shed is 5m wide by 3m tall. I just need to lift at 1 end and slide motor housing into the door slot on 1 end. It's too awkward just 1 person.

Supply & install motorised roller door for new steel shed Key details / description: I’m looking for someone to supply and install a motorised roller door for a brand-new steel-framed shed in Upper Coomera. The roller door opening is approximately: 2000mm wide 2400mm high The door will be fixing onto a steel frame. I’m after: Supply and installation Motorised roller door Remote/opening setup included Colour to be confirmed, likely something around Wallaby or Monument, but I’m open depending on availability and price The shed frame is already up and accessible. I’m just looking for a fair quote and lead time from someone who does this kind of work.

there is a small hole in my garage wall that needs to be fixed

I have installed some wardrobes and I need the cornices repaired and replaced. Total of 4 and approx 8 meters total length.

1)I have 4 window set Brackets to be installed.No existing curtains up/ brackets. I have 4 x retractable rods. 2)I also have a squeaky back door screen, its only or not a year old? 3) I have 4 down lights that I need to have replaced, I will see what they are, see if they are hard wired ( or can you do this)?

Hi, We are needing someone to fix the FlyScreen (see pictures). Thank you

Need someone experienced to 2pac paint my kitchen cupboards sage green

Looking for someone to install a small section of cornice and patch/plaster the area above a kitchen cabinet. Area is approx 1–1.5m wide. Access is above cupboards so a small step ladder will be needed. We will supply: • Cornice • Paint You will need to: • Cut and install cornice • Patch and plaster surrounding area

Door is gets stuck on the frame and doesn’t close properly where you can push it open without using the door handle

Remove shower screen frame and install new one.

Repair fly screen not after new screen just re secure the mesh to frame

Looking for a handyman to fix the trim above my garage door. Left side: timber trim needs to be removed and the cement sheet trimmed shorter. Right side: my DIY attempt didn’t turn out well, so the cement sheet needs repairing or replacing.

I have a ceiling fan that needs to be replaced. I already have the new fan. Just need someone certified to install it.

We bought a new door handle to replace a broken one, and it looks like the hole requires widening on door so new door handle can be installed. Pretty sure a handyman with the right drill bits will be able to install this without too many problems. We have the new door handle ready to go - see attached photos. Flexible on times, but ideally between 9am and 2pm weekdays.

Construction of Celsius GS2 Home Gym (with leg press attachment).

Remove my old (heavy) freestanding tub. Needs manpower to get it down the stairs. Install the new one and dispose of the old one

There are two holes in the walls from repair work and also a cornice that needs to be put back up. That section then needs to be painted.

I am needing two flyscreen doors and a flyscreen window repaired (the mesh part) my dog ripped through all of them. I would like to have it fixed before the 16th of March if possible. Upper Coomera.

Supply and fit flyscreen mesh in 1 door and 4 window frames

We are looking for someone to fix and repaint 5–6 damaged spots on the wall. A previous person attempted to repair them, but the result was not good and the damage is still quite visible, so we are now looking for someone else to redo the work properly. We already have matching paint in the same colour.