Find an experienced handyman in Reservoir VIC

Find replacement slat for plantation shutters and install 63mm wide by 430mm long

Install a plastic door canopy in to rendered brick. Will need masonry drill bit.

Tyre puncture / repair to be replaced

Looking for someone with experience with installing outdoor blinds. Very specifically the brand known as "Blinds On Line". This task is to do my measurements so that I order the correct blinds to be manufactured. You must have good knowledge of this specific brand and its outdoor patio blind products to accept this task. I need someone who knows about this specific brand and its patio blinds because you will be measuring my patio dimensions so that I can place an on line order for fitted blinds. I am mindful that they have different types of outdoor blinds and I need advice on which one is going to best suit my patio which has posts that are not plum and some bolts in the posts that may (or may not) be an obstruction to the blind's operation. So, please only make an offer if you have first hand experience with the brand "Blinds On Line" and their outdoor patio blinds. This task is to come on site and do the measurements and offer advice only. There is not fitting involved with this task. The fitting will be a separate task when the blinds arrive in a few weeks time. Thanks.

need to fix my Sennheiser headphone. one side doesnt work

Parcel letterbox installed over separate days labour. concrete and drilling needs to be done.

Need to fix the roller shutter on ground floor. It got detached with the motor. Motor is working fine

Supply and install approximately 25m2 of 10mm Aquachek plasterboard to walls only (including taping, joint and sand) - Walls are already plum - Cornices will be going in eventually

I have a rogue RML-3W fold back squat rack that needs to be installed in my garage, along with a mount for bumper plates and gym tiles secured to the floor. The rack and mount will be installed into brick. It will be installed where the shelving unit currently sits. I am 1 floor tile short of a 3x3 grid which i will pick up prior to the job.

My roller shutter are stuck

The The metal plug/strainer assembly (the part that sits in the sink hole and acts as both a filter and a push-down stopper) has detached from the drain pipe beneath the sink. It appears the issue is a missing nut or fastener. I can see the thread/bolt from the plug assembly hanging down below the sink, and I can see the pipe with the corresponding hole, but the piece that secures them together is gone. How to Fix It (As I See It) This should be a straightforward job for someone with basic tools and confidence: Obtain a suitable nut/fastener to fit the existing bolt/thread. Unscrew/detach the immediate section of the drain pipe below the sink Properly seat and secure the metal plug assembly onto the sink hole from above. Fasten it securely to the pipe thread from below using the new nut. Reattach the rest of the drain pipe and ensure everything is tight and sealed (a quick water test would be ideal). I believe this is a simple handyman or maintenance fix and does not require a licensed plumber. I just want someone confident to do the job properly so I don't have leaks.

My blinds stuck at certain point, no able to to further this point, need help fixing it, allow it to go all the way.

Had the presta valve core on the bike break and tires deflate straight away. Bought a replacement core this morning but it seems too wide to go back in. Just looking to have the tire inflated again.

Need to change the roller wheel below the sliding door. Job in Reservoir.

My kitchen cupboard door needs adjusting as it will not close properly. Also the bathroom window seems to be stuck and won’t open

Install dog door into wooden back door - we will supply the dog door. Reservoir, Victoria. Needs to happen Sat afternoon 19th July after 1.30pm. You will need to bring tools. Thanks

Fix wooden ikea bookshelf to wall

Looking to replace chain off 3 blinds and rehook back to the wall

Looking to repair a bathroom bench top with a minor chop in it. Believe the bench is stone but not 100% certain.

The rivets have popped off the top hinge of my security screen door. I need someone with the right materials, tools and skills to affix the door. I think this would involve moving the hinge up or down by about 10mm on both the door and the door jamb.