Find a professional internal door contractor in Reservoir VIC

Job: Internal door supplied and installed Location: Reservoir, VIC Opening: approx. 970mm wide × 2680mm high, at the base of an internal staircase Scope: Supply and install an internal door to suit the opening Opening is wider than standard door stock (most standard doors are 820–920mm), so the door/frame will likely need to be built to fit or a wider unit sourced Space is tight – there's a light switch close to one side of the opening, so care needed with trim/clearance Purpose: containment door for cats, so doesn't need to be fancy – solid and functional is fine Notes: Photo attached. Keen to have someone assess in person before locking in an approach.

Hi,I am looking for someone to to close up an internal doorway. We are removing the existing door and timber frame ourselves, so you will be dealing with a raw, cleared opening.

Supply and Install 2x internal doors including weather seals, automatic drop seal and a soft close latch Doors need to be solid core. First entrance - width is 0.824m, H 2.035m Second entrance - width is 0.770, H 2.043m

The current door handles replaced the original door handles about 12 months ago, but as the doors are old, the handles are positioned at non standard height. I am seeking someone to lower the existing handles (1 x privacy and 3 x passage) to standard height and patch the original holes to a paint-ready finish (painting not required).

We need a cat door installed on our internal powder room door

We removed a folding sliding door to fit our new floors and would like to add a standard door in its place. I believe the two wooden bits attached to the door frame would have to be removed. Without those pieces the approx measurements of the door are W935mm x H2030mm. Would like this done ASAP. Thank you.

We need two internal doors shaved at the bottom by about 4cm for new carpet installation

External sliding door needs repair (possible new track & wheels) & internal door needs adjusting (does not close)

Need a door - one that is going to be good for draught proofing - supplied and installed, as well as all hardware. The previous door used to be a bifold - ideally want a normal one. Door will likely need to be cut down as it’s quite a narrow frame.

Secure a door back on to its hinges

Hang 1 internal door 2 hinges already in tact and cut and fix a door handle . Door may need a little sanding to fit as new door but I’m not sure as it might not be required. Standard size door bought from Bunnings.Door already purchased. Replacing old damaged door with new.Thank you

need bedroom door installed, door hinges, screws and door handles supplied.

Need two internal doors fitted and hung. Had carpet installed and need roughly 10mm taken off the bottom. Need done this weekend if possible.

Three bedroom doors to be fitted They are replacing different doors so a little adjustment required - Due date: Flexible