Find trusted local electricians in Sydney Eastern Suburbs

Hi, I’m looking for a licensed electrician to install a picture light in my living room with a clean, near-invisible cable finish. Scope of work: • Convert a hardwired picture light to plug-in (add power cord + plug, ideally inline switch) • Mount the light centred above artwork on a plaster wall • Run cable down the wall to an existing power point (bottom right) • Install a slim cable cover/conduit and paint/finish it to match the wall so it is as discreet as possible Finish is very important – I’m after a minimal, high-end look (not visible cabling or loose cords). Details: • Standard gyprock wall • No existing wiring at light position • I can provide paint if needed (or happy for you to advise) Please confirm: • You are a licensed electrician • Experience with similar installs (picture lights / wall lighting) • What materials you’d use for the cable concealment • Total cost including materials

An electrical trip - trip box is at front of house and the tripped button won’t go back up. Means no electricity at back part of house

I’m in Bondi Junction and had my house pressure washed today. Since then, one circuit breaker is tripping and won’t stay on. Lights and other circuits are working fine, so the issue is isolated to one circuit. Likely water ingress to an outdoor power point, light fitting, or external wiring. Looking for a licensed electrician to: • Identify which part of the circuit is causing the fault • Diagnose the issue • Make safe and repair if possible Prefer someone experienced in fault finding rather than just replacing fittings. Located in Bondi Junction – flexible with timing but ideally ASAP.

I need a power point put in in my hallway! There is one on the other side of the wall so it should just be a matter of connecting through to that one

Need two wires reattached to lightbulb holder

Lighting does not work, but have power as a result of a storm. - Fault testing - Repair fault testing House has cotton insulated wire.

Replace around 11 spotlights with new ones. We have already purchased these. You do not need to be an electrician. Both the old and new lights are powered by plugging into standard sockets. So it's simply taking them out, swapping them and clicking them into place. The ceiling is very high at points, so you will need a high step ladder. Our 3-step ladder isn't tall enough.

I need to wire a power point in the up stairs of my loft apartment. Cables already ran, just need a multimeter. Easy job.

Remove chandelier and dispose of it at dump

We need chandelier remove from ceiling and replaced with a downlight.

Air con panel saying error, it’s connected to our av teams system as well so meet with the them on site to fix together asap

Take off old oven and put in front garden and install a new oven

Looking for a friendly sparkie to replace an existing pendant light with a new light fitting for my home office. Friendly, tidy and clean people, I’m looking forward to hearing from you.

I am seeking a licensed technician to diagnose and repair a large-capacity air conditioning system currently servicing a 10-room boarding house. The unit has completely stopped functioning and requires a professional assessment to identify the root cause—whether it be a compressor failure, electrical fault, or refrigerant issue—and a subsequent fix to restore cooling to all residents.

I need to replace kitchen down lights that can be accessed from the attic and are hot wired to the switch, I can supply the led replacement or have you source them.

Looking for a licensed electrician to attend a commercial shop close to Edgecliff Station today for a site inspection. This task is for a $100 call-out fee only to assess the job and confirm exact requirements. Work required: • Three-phase installation (subject to inspection) • Install 32A outlet in one room The $100 call-out fee will be redeemable and deducted from the total cost if you proceed with the full job. When submitting your offer, please: • Provide your licence number • Confirm availability today • Include an estimated total cost for the full job based on the information provided After inspection and agreement, the remaining balance can be added to the task. Thank you.

Replace 8 drivers in ceiling - halogen down lights. Replace 2 x 3 gang with 4 gang power outlets Add a 2 gang power point to an existing power point Replace 4 light switches with smart switches I have all of the items. Looking at budget of 400 Ready to go and flexible with timing.

Hanging light is tripping. Please find fault and fix.

ASAP. Boss’s hard wired smoke alarms are going off. Need someone to check out what’s happening and shut them up.

Hi, I need to tag and test my Pioneer RX3, 2 x 12 inch speakers (JBL EON 612) and associated power cables. Many thanks, Jeremy