Find trusted local electricians in Brighton East

Need to remove PowerPoints as we need to install gas equipments

I’m looking for a qualified auto electrician (or someone with solid campervan wiring experience) to install the 12V electrical system in my Toyota hiace campervan conversion. ⸻ I already have: 100Ah battery (AGM or Lithium) 25A DC-DC charger (to connect to starter battery) 1000W inverter Solar charge controller & panels Lights and switches Wiring for the DC-DC charger and solar panels All other cables, fuses, and connectors will need to be purchased — I’m happy to buy them with your guidance, or reimburse if you supply. ⸻ What I Need Done Connect DC-DC charger to starter battery (with proper fusing) 1 x 12V outlet 1 x 24V outlet Wire up battery, inverter, outlets, and fuse box Install isolator, grounding, and solar input connection Run cabling neatly through van framing Test entire system to confirm safe operation from both alternator and solar.

Qualified electrician needed to install 1 track light with dimmer in kitchen - i have the track light already, but will need a dimmer supplier. 3 outside lights + motion sensor - I have these already. Power already exists to all areas. Located Brighton east. Thanks

*updated scope*: - Licensed electrician required for a two-stage job - Stage 1: Pre-demolition - Disconnect power prior to demo works - Stage 2: Post-demolition (2–3 weeks later) - Return to reconnect power - Install 3x lights - Install 3x GPOs (PowerPoints) Room is 4.3m long, assume exposed rafters The power at the back of the house is currently servicing two lights and one GPO. We need you to come by and cut it safely because we’re demolishing the roof. Old brick house. Power external or in roof

I need an electrician to move a light / dimmer switch from inside room to the outside of the room on the same wall.

Roller blind chain needs to be put back on as it is not catching properly. Some kitchen down lights need to be checked as they are flickering.

Looking for an experienced electrician who can quote on a few electrical tasks that range from: cost to install a 3 phase unit, adding a dedicated heat pump line, moving nbn point to a alternative location

We currently have 2 smoke alarms wired into our roof, we want them replaced with 2 smart battery operated smoke alarms. Pictures attached of the old smoke alarms and the new ones. Needs to be done today as our old one is beeping and very annoying. Ceilings are kind of high so will need a small ladder.

I am planning to build a new front yard fence with the following specifications: • Total width: approximately 17 meters • Height: 1.5 meters • Structure: brick wall base with wrought iron panels on top • Gate: one automatic sliding/swing gate for vehicle access The photos are current looking and what I want to make Price is negotiable

Overhead nbn Hybrid Fibre Coaxial (HFC) is damaged and needs to be patched

We need two double outdoor sockets to connect a pool pump, chlorinator and LED lights. There is a power point on the perpendicular wall that we got disconnected recently marked in the photo Need to get the pool heater hardwired. 3KW 12A power draw. The pool builders have left a conduit that needs earthing. Need supply and install pricing please.

We need an electrician to supply and install a an exhaust fan in small bulkhead in our toilet. Happy to use the power that already goes to nearby light (so both light and fan turn on simultaneously). There is no ceiling cavity (other than small bulkhead so the fan needs to be ducted to the outside roof (which is flat).

Need to swap plugs to recessed plugs at the back of tv Send me your offers as I didn’t have any idea so i put 5$ just to post it

Need to install an outdoor 15 amp power point on the side of the house.

We have to replace 3 light fittings. One in kitchen and two in bedroom. We have fittings on hand. Removal of existing fittings as well

Need to replace down light in a bathroom. Replacement bulb can be provided separately.

celling light installation

I have a light fitting above my kitchen sink. The transformer needs replacing which I have just received.

I have a GU5.3 downlight that is not working. Replaced the blub but it didnt help , so looks like the transformer is dead so task is it be rewired to work with a GU10 bulb or the transformer replaced The exisitng ceiling hole and light hitting will work and no changes needed to that.

I would like to relocate my nbn box to a cupboard in my house. From there I'd like to run some cat cable into the roof and connect my Ubiquiti puck to the roof. I have the cat6 cable and the cat6 wall plates. Roof and crawl space access.