Find experienced local carpenters in St Kilda VIC

Need to raise the shelf above the fridge as I’m buying a new one which is slightly taller. May need to also make some adjustments to the cupboard as well.

I am installing a new cooktop, but the wooden cabinet walls underneath the cutout are a TINY bit to high. Probably a centimetre or less. I need an experienced woodworker or cabinet maker to cut the top of these cabinet walls (marked up under the red circles - see pics). It would be great if you're available today (Friday). Many thanks!

revarnish wood on panels Can discuss quote

Qualified carpenter required for framing. Must have own tools

Cracked laminate on single cabinet door only. Needs to be replaced. Laminex gloss panel (Formica - Snowdrift)

A kitchen cabinet door - perspex - about 114cm high (so a bit heavy and bulky) needs to be rehung on 3 existing hinges - we have the fixing screws. The cabinet is above a benchtop. There are two other kitchen cabinet doors where the hinges need adjusting and another hinge on a laundry cupboard that needs to be re-clipped.

I need a boxed in shelf built in my kitchen Lattice installed on my balcony - one large piece (90x1800cm horizontal slats) to cover a glass divider. I also need 2 shelves on this lattice. There is another piece of lattice 730x800cm (vertical slats) to cover my air con unit. I also need a cupboard door either side of the aircon unit. I have put a quote of $200 (which is obviously not enough)as Airtasker won't allow me to publish a task without a quote. I'll ask for a quote from the Airtasker

Need a chippy to install a barn door all materials supplied. Need to install a backboard behind the barn door rails first; and also Wall has a bend on it might need to pack the backboard first so it’s level. Wall is timber framed and plaster. Easy 10-15 min straightforward job. Opportunity for more work for right chippy

I'm looking for an experienced cabinetmaker/joiner to build and install a new commercial café front counter at #8 Coffee in St Kilda. This is the first stage of a complete café refurbishment. If we're happy with the workmanship, there will be a second stage (4.46m rear workbench) for the same cabinetmaker. Front Counter Approx. 2000mm wide x 600mm deep x 900mm high Commercial laminate cabinetry (or optional engineered stone benchtop if competitively priced) Recessed 550mm SAYL pastry display Integrated Polar CX574 display fridge Commercial quality suitable for daily café use Soft-close doors/drawers preferred Important Concept drawings supplied. Site measure required before final quote. Looking for someone who can also suggest improvements to the design. Installation required. Experience with café, retail or commercial joinery preferred. Please include Photos of similar work. Approximate timeframe. Whether you manufacture yourself or outsource. Warranty on workmanship/ Budget shown is indicative only. Final price will depend on site measure, materials (commercial laminate or optional engineered stone), and agreed design.

Custom joinery for our entrance way, similar to the below references

The cabinet hinge broke (needs to be replaced) and since the hinge is gone the cupboard fell and snapped off it’s fixtures (so it needs to be re secured)

My dishwasher won't close properly due to a building MDF panel. I need someone to make a panel that is 60 cm by 7.2 cm panel and paint it vivid white ..I think it's 2 pack

Paint has peeled off the wall exposing the plaster. So it would need some filler then sanding and paint. Also the window cill and a bit of the skirting board needs painting. Acrylic paint on the carpet. So it needs a good steam clean. Finally a new desk top need to be screwed to the legs.

I need window frame adapted so it can incorporate an infil to hold a fan. You will also need to install glass once infil is added.

Full replacement of 4m x 2m deck- joists and decking boards. Leaning towards spotted gum for boards. Removal of old deck. There’s a split system fan unit sitting on the current deck that will need to be moved/suspended, perhaps disconnected to enable works. Also, a simple roof of the same size to be replaced, above the deck. Colorbond or Laserlite sort of deal, roof is pretty high up so might require scissor lift and harness setups for safety reasons so high up!

Bathroom wall repair, painting (beige), cabinet/mirror install + resealing – 2 bathrooms I’m looking for an experienced handyman (ideally with plastering/carpentry experience) to complete work across two small bathrooms. 1. Wall repair & painting (behind vanity areas) * Scrape and remove all peeling/flaking paint and damaged plaster * Sand and properly prepare surfaces * Apply sealer/primer * Patch and smooth walls with filler * Sand to a smooth finish * Prime and repaint Paint colour will be a **warm beige/neutral tone (not white)** – I will confirm paint. 2. Install wall-mounted mirror/cabinet (heavy)** * Install a **heavy mirror cabinet** securely to the wall * Must be properly anchored (into studs or appropriate wall anchors) * A **cut-out is required in the back of the cabinet** to allow for an existing electrical outlet/cable point * Ensure clean, neat finish and correct alignment **3. Bathroom resealing (silicone)** * Remove old silicone where required * Reapply fresh silicone around: * Showers * Vanities/sinks * Any gaps needing sealing **Additional details:** * One wall has an existing electrical wire/outlet for hair tools – must be worked around carefully (do not remove or modify wiring) * Bathrooms are small * Looking for a **clean, professional finish** (not a quick patch job) Please bring your own tools. Let me know if you will supply materials or if I should. Photos attached. Preference for someone experienced with wall repairs, cabinet installation, and bathroom sealing. Please include photos of similar work if available.

Need a carpenter or handyman to fix this broken step on our back staircase of our bar

A cabinet door has broken/fallen off the hinges and needs to be reattached. Other doors on the cabinet are intact so the mechanism can be copied.

High pressure wash Merbau Deck approx 20 m2. Stain the centre section, topcoat to entire deck. Sikkens oil supplied.

Use this redgum to build shelves under the basin / sink