Find experienced local carpenters in Fitzroy North

I have two sheets of 19mm STRUCTAflor Yellow Tongue (3600mm × 600mm) and need each one cut down to 2100mm in length. That’s one straight cross-cut per sheet. The width (600mm) does not need to be changed. The boards are already at my home in Fitzroy North, and the cuts can be done out the front. I don’t have the tools, so you’ll need to bring a circular saw with a guide or a track saw to ensure clean, straight cuts. This is a quick job for someone with the right equipment. Budget: Listed at $50 as a starting point — open to reasonable offers.

Demolish original cupboards in photo and construct a built-in desk and further cupboard space.

5 m back fence both sides (new) Size fence 10m Few m of the other side fence Old fence needs to be washed with hard bristled brush the day prior. Two coats of resene bark to be applied with brush. New fence may need extra 1/2 coat in Order to match the old fence (ie. 2 coats vs 1.5 coats) height 2-2.2m

Unloading wood fire first floor - View all the details of this offer: https://www.airtasker.com/offers/01JY39QS5Z3NAN54N403243P22

I need a wardrobe cabinet carcass built. See design and dimensions attached. Please provide a quote for the carcass only from standard 16mm Melamine panels. Doors are separate and can be discussed later. Thanks, Stephen.

Unloading wood fire upstairs - View all the details of this offer: https://www.airtasker.com/offers/01JXF2Z8MX8MZD7XSJMYVBM61V

Our builder didn’t finish the job properly with our renovations and left gaps in the skirting board around the house and in the tile walls in the kitchen which has given ants a perfect entry into our home. Looking for a handy man (or woman!) to help and fill the gaps in our home. Our home isn’t large (town house) but happy for you to come and see what needs to be done and to quote us. You will need to bring the required gap filler and tools to complete job etc. happy to pay for it if you need to go Bunnings

I have two shelves that need to be hung.

We have the base of laundry and storage built - but it’s not covered. We need space efficient bifold doors to cover shelving and laundry. 3m ish long! Not a task that can be accepted without a site meeting. Will need creative thinking as cannot eat too much into corridor.

Need doors that have been scratched bogged - bathroom wood damaged through leaks prepared and deck seales

We’re hoping to extend our wardrobe. Looking at building it back into the wall space behind. There is a wardrobe in that position in the room next door- we were looking at using that space and then installing a narrower free standing wardrobe (in line with the existing cabinets) in the second room. Open to any suggestions…. Not set on anything in particular. Main aim is a bigger wardrobe in the master bedroom. Budget set for a quote.

I need a cabinet maker to install ikea laundry

Looking for somebody to remove the front panels of plastic and help just put a trim around the door.

I got bleach spots on the floorboards and then tried to cover with hairdye please help

Remove old integrated fridge and install new one. Ventilation ducts need installing in kicker below and above to allow passive air flow (ie, fans not required). Photos show kicker and cupboard above fridge, which has approx 200mm gap behind it. Grills to be extra at cost, once appropriate ones identified.

Looking for an experience carpenter to help install some VJ panelling at home. Super flexible on timing and happy to source materials from Bunnings before you arrive if that’s easier. Entryway - four small sections looking for a half wall with deco rail finish similar to pic 4. Some edging will be required and would love a clean finish. Specs: Panel 1 - 2m long Panel 2 - 1.2m long Panel 3 - 76cm Panel 4 - 46cm Floor to ceiling - 255cm Skirt - 9cm h x 1.2cm d Bedroom headboard wall - final pic. Looking for long panelling skirt to cornice: Floor to cornice - 230cm Width - 330cm Skirt same as above Prefer vertical panelling for both and flexible on rail design for downstairs, I can paint myself after. Thanks

I am looking for someone to build and install a section of open wooden shelving on our kitchen wall. We have recently moved into a new house and had an Ikea kitchen built but have left part of the wall storage to be open to talk back to the side shelf of the island bench as per attached images. The dimensions of the area are 800mmH x 600mmW x 400mmD. Looking for wood panels around 200mm thick as per the island bench side shelf, with two shelves within the frame. I would love to be able to round off the edges and have the outer side open as per the reference image attached if possible.

Seeking an experienced cabinet maker with high attention to detail to assist with the following: - Altering existing cabinetry to create an accurately sized carcass for integrated F&P dishdrawer, following installation guidelines. - Minor tweaking to adjacent cabinets as needed. - Use of existing kitchen cabinet fronts, so ensuring no damage to these panels - Install of dishwasher is a bonus. Plumbing and waste available in adjacent cupboard.

Need a local carpenter (north fitzroy) to install decking, door, door jamb, arc, skirting etc

- Removal of existing glass sliding top hung door system Bedroom 1: - installation of small wall (extension of wall approximately 800mm and installation of 1 x hinge doors to bedrooms - new door frame to bedroom 1 to match existing Bedroom 2: - new door installed in existing opening - Materials (timber, plaster, hardware, paint, etc) ideally organised by one person / trade or can be broken up into carpenter and plasterer Price varies depending on material supply