Find experienced local carpenters in Balwyn North

Like get an enclosure built for my pool equipment which is made of slates. Approximate dimensions are Width - 3260mm Height - 1350mm Depth - 1000mm

The space is big the washer is standers 62 inch it’s a small job and will take very little time just to make sure the washer fits securely that’s all !

I need a good cabinet maker to make a space For my dishwasher and if you can plumb and install it with electrical better

Looking to sand and stain at 35 m² deck. Deck wood is in good condition. Need the wood sanded down with a sander, not only with high-pressure water. Once cleaned, stain to be applied

Need a cabinet maker to make a cavity for a dishwasher ASAP

New Architraves and skirting to install in a room. One bifold door and one windows. 3 length of skirting

Need to install a marble fireplace on ground floor, materials provided, open up to suggestions for the adhesives to be used. Experienced stonemasons preferred.

I’m looking for someone skilled in DIY and timber work to build and install a timber slat divider to separate my bathroom from the living room. You’ll need to have experience with custom timber projects and be able to source the necessary materials. If this sounds like something you can help with, please get in touch . Price is negotiable Thank you!

I am looking for a carpenter/ handyman to take the bottom of the hanging cabinet off so the fridge can be fitted in. The hanging cabinet might be glued to the other cabinets on both sides. I need someone to cut 5cm off the hanging cabinet and remove the bottom for me.

The slab adjacent to kitchen sink is broken, need a carpenter/handyman to make a wooden slab then glue the kitchen slab pieces on top of it.

East Shed assembly On site 2.25m wide 4.50m length 2.35 gable height Flat surface

I purchased a loft bed from an online store and when it came it did not have all the accessories to make it strong and stable. I bought it for my niece and I need to get it fixed now for her. This is a carpentry/repair job. You will need to evaluate it and then tell me what needs to be done. You will need to be an experienced carpenter/handy man

Our integrated dishwasher needs to be removed so that it can be repaired, but the kickboard needs to be cut so that it can be removed and reinstalled after the dishwasher repair (acting like a removable piece). Please see photos below, there is currently a gap in the kickboard where the cuts can be made and the piece taken out. This should be a very easy/quick job for a cabinet maker.

- Put support base underneath benchtop in laundry - Plastering - Painting

My 5-meter Extreme Marquis must be moved 1 meter to make room for a second cover so my entire patio is covered. It's 8 posts must also be raised and secured onto concrete blocks so it is 12-18 inches higher. ***My apologies but no photos available right now.***

Sand Polish and Stain/ oil floors. Attached photos are from when the floors were installed. Approximately 52 sq meters

I have a lazyboy recliner on which the spring underneath is broken. This is causing the seat to sag and the stuffing of the cushion to fall out. I need this fixed

I need a gentleman with minimal carpentry skills to make one extra shelf out of shelving material that I have for five kitchen cabinets. The shelves I have for this just need to be trimmed a little so they fit. The kitchen cabinet are standard size if not a little smaller. I'd appreciate it if you would please not ask for pictures. Thank you.

Cladding gaps around sunroom, material photo attached Total gap area Approx 13.5m x 120mm 5.4 m x 250mm 2.7m x 460mm 17mx 100mm between under roof joist Install an entrance door

I have ordered garden shed (easyshed) 1.5x3 meters which is arriving on the 24th April. It needs to be assembled on a concrete slab which is ready.