Find a reliable appliance technician in Surrey Hills

I have a braun care style 5 steam iron that has suddenly stopped steaming. It’s heats up like normal but the steam function doesn’t work. Looking to get it fixed

Replace the plug if dough machine. See pictures

Disassemble my dining table (there are 2 main blocks attached to the table top. You'll need an electric drill to remove the screws ) and disconnect my washing machine ahead of a house move. Dining table task is no more than 10 minutes. Same for the front loader washing machine.

Need licensed plumber to replace thermocouple in Emilia D176GGESIB3 gas oven. The pilot is lighting and flame igniting when knob is held down. As soon as knob is released, the flame extinguishes.

Need a cold water washing machine tap in the laundry replaced as it is leaking slightly when in use. Mains water shut-off is easily accessible outside. Flexible with timing.

coffee machine isn’t working properly - lights are flashing when turned on, potentially needs a clean

Washing machine not draining. I have checked the front filter / impeller and they seem to be fine. I suspect it is blocked in the hose system

we are looking for a licensed electrician to install a 10 amp wall plug onto two domestic ovens. and write a certificate to say the ovens are able to be used.

We’ve just had a new washing machine delivered but they couldn’t connect it to the cold water tap as needed because there’s a second outlet on the tap that just leaks when the valve is opened. They said a new tap would needed. Pictures of the current one will be provided.

Need a handy worker for a quick 15–20 minute job. There are two small tasks: Task 1 (Plumbing): I am disconnecting a coffee machine and have successfully removed 2 of the 3 water connections. The last joint is stuck (the nut and the fitting are spinning together). Task 2 (Dishwasher): Secure a dishwasher by driving 4 screws into the side cabinetry to stabilize it. You will need to bring a power drill/driver. Please don’t send unrealistic quotes.

The door of Smeg oven won't close properly. Door hinge is faulty. Picture attached. Video also available. Model is SA370X or similar

The original lead has been cut through

Both dishwasher drawers are malfunctioning and won't work properly. Picture attached. Video is also available upon request. Specifically they are non-stop making the humming noise with a wrench symbol. The only way to stop it is to turn it off at the power source - no other buttons work when this mode is activated. My understanding is that F1 error means that the Flood Protection Mode has been activated. However - based on my inspection and investigation - it is not flooded anywhere and there are no excess suds. I have cleaned and checked what I could. It then worked for a few days. And now is again doing it. We have it working again after turning it on and off at the main power source.

The oven door does not close properly so we need this fixed so it does close properly The range hood rails are also not working well so when pulled out it sags down toward the oven

Top dishwasher not working, either doesn’t drain properly or doesn’t finish full cycle.

My Miele 90cm oven has already had parts replaced, but it is still tripping the circuit breaker. * Please provide a fixed total price (including labour and any call-out fee) * Let me know if parts are included or extra * If unsure, provide a maximum estimated total cost before starting * No additional charges without my approval

I need a licensed and insured plumber / gas fitter to attend my unit in Surrey Hills to locate a confirmed gas leak. The leak was identified during a compliance check by a plumber using a gas meter test, but the exact location is currently unknown. The gas has already been turned off. Scope of work: Attend property and investigate to locate the source of the gas leak Assess issue and advise what is required to fix it Provide a quote before any repair work is carried out After inspection / works, provide a written report Details: Property type: unit Owner occupied / owner arranging access Easy access to the property and relevant gas points Booking can be arranged for a specific time Requirements: Must be fully licensed and insured Must be qualified to work on gas leaks Please include licence details, availability, and any relevant experience in your offer

I have a Bosch HomeProfessional heat pump dryer (approx. 2015 model) that is no longer drying efficiently. It runs for several hours (e.g. towels for 4+ hours) and clothes are still damp at the end. It also doesn’t seem to be heating properly. I have already: * Cleaned the lint filter * Cleaned the lower filter * Cleaned the drum moisture sensors This helped slightly but the issue persists. Looking for someone experienced with heat pump dryers (preferably Bosch) to: * Diagnose the issue * Perform a proper internal clean (including condenser if needed) * Advise if repair is worthwhile Happy for repair if reasonable, otherwise just need an honest assessment.

Starter pawls fell out of Victa vantage lawn mower. I have reinstalled one but other one too fiddly and can’t get in

Safety gas certificate check for a 2 bedroom rental property .