Find a reliable appliance technician in South Yarra

As stated, freezer works but the main section is not cooling. Have tried unplugging with doors open for 20 hours but still no good.

Dishwasher needs to be fixed. F11

I need assistance in removing the drawer dishwasher and replacing with a new stand up dishwasher. Probably will need to cut back the skirting board. Would like someone to take the old dishwasher to the dump as well as any of the packing material. It may be the case, I need a plumber afterwards unless you are qualified plumber and can do all of the stuff.

My Fisher and paykal dishwasher drawer is not draining. We removed all components and still isn’t draining. Please let me know if you have the part to fix this if you know what the issue is before hand.

Water cooling generator - the electronics / temp control is not longer working. ?wondering if some water got into it and broke it?. Need someone to have a look and hopefully replace this electrical control screen only

Convert Crossray BBQ from LP to Natural Gas with Conversion Kit and Instructions Provided

I want to add a dishwasher and a washing machine to my kitchen. Under my kitchen sink I have one hot water valve and one cold water valve. They currently feed a single sink mixer tap through braided hoses. There’s one plastic trap connected to a single waste pipe, which also serves as the sink’s drain. I’m after a compliant, low disruption solution rather than a full replumb. Ideally, a setup where I can isolate one appliance (say, to service the dishwasher) without shutting off water to the whole kitchen.

Swapping a broken undermount rangehood in the overhead cupboard above my cooktop. I've already bought the replacement, so this is labour only. The job: - Remove the existing Robinhood powerpack and its face plate. Plug-in unit, unplugs from a GPO inside the cupboard. - Modify the cutout in the cupboard base if required. - Fit and secure the new unit, refit the face plate. - Reconnect the existing 150mm insulated flex duct and seal it. - Test to make sure the installed unit runs. - Take the old unit away. New unit: - Omega ORU70XL, supplied - Manual and dimensions: https://static1.squarespace.com/static/6434bb26a48593544005e14d/t/68f6da7b5eaaed11f74f16fd/1761008251925/ORU52XL_ORU70XL_ORU90XL_UserManual_V3.3+1025+-+web.pdf Old unit: - Robinhood RPA3CI9WH powerpack - Manual: https://www.robertson.co.nz/storage/installation-instructions/RPA3CI6SS-WH%20Install.pdf What's there now: - Cupboard cavity: 820 wide x 360 deep x 345 high, internal - Existing cutout in the cupboard base: 665 x 258 - Ducting: existing 150mm insulated flex, straight up through the top of the cupboard. Staying as is.

Miele dishwasher not draining My Miele dishwasher has the Inlet/Drain light flashing and the water isn’t draining out. I’ve followed the troubleshooting instructions, taken the filters etc. out and found some glass stuck in the little drain pump/propeller. I’ve removed all the glass I can find and put everything back together, but it still isn’t draining and the light comes straight back on. I’ve tried resetting it as well and that hasn’t worked. I think there might now be a blockage in the drain pipe/hose, but I don’t know how to check or fix that myself. Looking for someone who can come and figure out what’s blocked and get it draining again.

My apartment dishwasher has developed a drainage problem. The “Inlet / Drain” warning light is showing red, water is pooling at the bottom of the dishwasher, and the cycle does not seem to finish properly and not dry the dishes. There is also a strong bad smell when the dishwasher is closed, even for half a day. Importantly, the bad smell has been an ongoing issue for quite a while, even before the current drainage problem started, so I would like someone to investigate both issues properly rather than just unblock the current drain. I’m looking for someone experienced with dishwashers to: * Diagnose the Inlet / Drain error * Check and clean the filter and drain area * Check the drain pump and drain hose for blockage or failure * Check the connection to the sink/drainage system * Investigate the long-term bad smell and identify the cause * Repair the issue if possible * Clean/sanitise the affected drainage area if required There is currently water sitting at the bottom of the dishwasher. Please bring appropriate tools and let me know if you have experience repairing dishwasher drainage issues.

I’m looking for someone experienced to install my new Samsung washing machine and dryer. The job includes: * Assemble and install the Samsung stacking kit. * Safely lift and place the dryer on top of the washing machine. * Secure the dryer using the stacking kit. * Connect the washing machine to the hot and cold water pipes. * Connect the drain hose. * Ensure both appliances are level and ready to use. * Run a quick test to confirm everything is working correctly. Please bring any tools required for the installation. Experience installing stacked Samsung washer and dryer units is preferred.

SMEG DWAFI6224-4 Dishwasher presenting with E01 error code. Drainage pump won’t turn off. Tools required to remove kickboard before inbuilt dishwasher can be extracted.

Need help connecting washing machine. Existing washing machine hose is too big for tap connection. Price includes supplying and installing whatever adaptor/fitting is required. Located in South Yarra. Looking for someone available ASAP.

Need to have the rotor blade of fisher and paykel dish drawer replaced and dishwasher back to functioning

Hi, just need a small wall heater attached to the wall so all that needs to be done is take off old brackets and drill in new brackets. South Yarra. No crazy offers considered. Thanks.

I need someone to come and connect my dishwasher and washing machine too hot water. We just moved into a rental and were unable to connect ourselves but it does exist.

I'm looking for an experienced and qualified carpenter to cut and install shelves above the washing machine in my laundry. I will remove current shelving system. Cost is negotiable (honestly no idea how much a job might cost so ignore $ amount). You will need to measure before and source materials for which I will pay for. I'd like solid wooden shelves ideally, yet open to melamine or other material. Each shelf needs to be approximately 600mm x 700mm. As you can see from the photo, it's a brick wall.

E1 warning on Samsung washing machine Clean filters and diagnose / repair Location south yarra

Looking for experienced appliance repair company/person that can fix our dishwasher. It has stopped working and we suspect its because the door handle was broken. It is an integrated dishwasher.

Dishwasher top rack jammed. Unable to fix myself. Need handyman to look at it.