Find a reliable appliance technician in Kings Cross

Fisher and paykel 8kg top load washing machine is out of balance - suspension rods need to be replaced. Budget includes price of parts

Need a new seal installed on my LG washing machine

We would like a licensed gas fitter to check where the gas leak is in a commercial kitchen. Please put down your offer and when you can come and inspect.

Looking for a licensed plumber quote to install plumbing and waste for a washing machine in my apartment in Potts Point. The washing machine is currently only sitting in the lounge room and is not connected to any plumbing. Scope of work: Extend existing kitchen water supply and waste plumbing. Run the plumbing through the wall from the kitchen area into the lounge room. Position the washing machine on the right-hand side of the fireplace. Install the required washing machine water connection and waste outlet. Advise on the best concealed route before cabinetry/joinery is installed. Ensure the work is suitable for an older apartment building. Photos and floor plan can be provided. Licensed and insured plumber only please. Location: Potts Point NSW

URGENT – Commercial Oven Technician Needed Today Looking for an experienced technician or electrician to install a new Tecnodom commercial oven arriving today at our restaurant in Potts Point, Sydney. Must have experience with commercial kitchen equipment and preferably 3-phase ovens. Need someone able to connect, test, and ensure everything is running correctly. Please message with your experience, availability today, and installation price. Potential ongoing hospitality equipment work available.

I have a washing machine that was installed and forgot to take the transit bolts out of. The unit is approx 70 kg and will need to be lifted straight upward about 1.5m to get them out.

My built-in Miele dishwasher is showing F78 error and not running properly. I have already: cleaned the filter checked for visible blockages inspected accessible pump area reset power The dishwasher appears clean and drains normally, so I suspect: stuck/seized circulation pump from inactivity or circulation pump issue Looking for someone experienced with Miele dishwashers to: diagnose the issue attempt repair if possible advise whether repair or replacement is more economical Location: Woolloomooloo NSW 2011 Please let me know: your experience with Miele repairs estimated call-out fee availability whether parts can be sourced if required

We need to replace an old washing machine with a new one. The new washing machine needs to be moved downstairs, and the old one needs to be brought upstairs. The stairs have two corners, so this job requires heavy lifting.

Disconnect and remove existing washing machine Install a Fisher & Paykel single drawer dishwasher in the same location Connect dishwasher to existing plumbing and waste Existing setup. Hot and cold water connections located under sink Waste currently connects to sink trap (spigot) Flexible hose connections (not rigid pipe)

I have a few small plumbing jobs to be completed in my apartment. 1. The tap in the laundry is horizontal, but needs to be vertical in order for the washing machine hose to connect 2. There is a leak from the pipe under the kitchen sink, I think this just needs re sealing 3. The Faucet in the bathroom is loose and needs re fixing to the basin

Remove current panel heater from wall & install new panel heater on same spot. Not sure if original bracket can be used. New bracket provided with new heater. Wall is solid brick.

Need NG oven hooked up - need correct hose attachment

My washer is leaking from the hose which stems into the basin - just need to fix this. Also, I have an extension for the ceiling shower head which I want to add (its the arm of the head to make it a little longer)

We need a plumber to remove old tap-ware and install new mixer tap on bench (not wall) and single sink. And plumbing to install a new dishwasher. Dishwasher will be installed by builder where we currently have drawers (see photo) needs to be plumbed in.

Ice-cream machine clean and maintenance program Empty mix, disassemble machine, sanitise Reassemble, place pump back together Lube all o-rings and beater seal Test with water no leaks Add mix Run to production - test ice-cream product Track on I-phone before/after pics Suitable for handyman who is mechanical hands on ability Training provided Prorated $50 per hour. Single 1.25 mins = $70.00 Recurring each 2 weeks, Kings Cross, World Square, Circular Quay Thanks so much

Hook up new winterhalter UC s machine for small restaurant.

Glass fridge is working but not cold.

The filter is broken but I cannot get it out to clean it. I think it is stuck.

I can order and pay for the panels from Sydney doors, however, I need someone to install and provide guidance as to how to make sure best, seamless integration. The current carcass that the fridge sits within wasn’t intended for an integrated appliance. I want to workshop this.

E4 error flashing on 2 out of 3 induction cooktop areas. Brand is Smeg