Find a reliable appliance technician in Hughesdale

Relocation of Instant GAS water heater unit by 1.8 meters to the right. Preferable to have the electrical out let not modified. The piping to the heater unit has to be re-routed to suit the new location. Quote should include material and labor. Refer attached image from more details.

Need to install a folding washing line on brick wall in backyard Fixing kit is included with washing line

Hi! I need someone to replace the rubber door seal (gasket) on my Samsung front load washing machine (model: WF756UMSAWQ – 7.5kg BubbleWash). The existing seal has a small tear at the bottom and is leaking during wash cycles. I’ve already purchased the correct replacement part — just need it installed properly. You'll need to remove the old one, fit the new one, and make sure both clamps are refitted correctly. The machine is in a laundry space with clear access. Should be a quick job if you're experienced with front loaders. Let me know your availability and price. Thanks!

Need some professional advice on a gas stovetop inspection. Fisher and Paykel 60cm stovetop

LG aircon not working via remote control. Have changed batteries and also bought universal remote control without success. Air-conditioner works if turned manually for cooler not heating

Need someone to program a remote According to you tube it’s a minute job for the right person Located in Hughesdale near Chadstone

My Hisense fridge was left open for a long time, and now it’s not cooling properly. The fridge is running, but it’s not getting cold. I need someone experienced with fridges to check and fix the issue.

reversing camera installed

Remove old cooktop and rangehood and install new one.... Thanks

The dryer drum is not spinning. Looking for someone to check if it can be fixed or to repair it if possible. Dryer Details: Model: Simpson 6kg Dryer (39S600M) Age: Over 8 years

I am putting in a dishwasher beneath this cupboard. As a result, I need the cupboards cut to allow a free-standing dishwasher to slide in. It will require a few cuts. - the kick board, bottom shelf, back piece, and top piece. Also will require one of the cupoboard doors to fit the remaining size of the cupboard.

Need to disconnect gas heater Gass needs to be plugger off usage

I want to take out an old gas heater and need the gas line plugged and disconnected

We are seeking a qualified and experienced technician to repair a Maytronics Dolphin M500 pool robot vacuum. The unit is turning on, and the vacuum function is operational; however, the wheels and belt are not moving, preventing the unit from operating effectively. Requirements: • Expertise in diagnosing and repairing Maytronics Dolphin models, specifically the M500. • Ability to perform the repair on-site. • Experience with troubleshooting wheel and belt movement issues. • Prompt and professional service. If you have the skills and experience to carry out this repair, please submit your offer.

I have a wall mounted cabinet right above my washing machine. I want to shorten the cabinet so that I can put a dryer on top of my washing machine.

I have merlin professional quiet drive 850 model for the garage door which is opening fine but its not closing when the button is pressed from the remote. If I keep the button pressed the shutter would come down. It's steel shutter and a double garage door.

I want to disconnect the gas supply to the stove/oven for disposal. The gas copper pipe (right side of stove 60cm above floor, see attached img) must be cut and safely end capped as close to the wall surface as possible, ideally not protruding from wall by more 3cm, as I would like to install a kitchen cabinet 120cm wide, 80cm high in this space. I require a certificate of the gas disconnection. NB. Gas supply still needed to run the hot water system.

I need to remove a vacuum and an air dryer and a chair from my apt in third floor. You can have them if you want to the chair is broken but the vacuum works fine air dryer doesn’t rotate.

Bosch Washing Machine Serie 4 model. Open door symbol is on even though door is shut. I have turned it off completely and removed power supply but the symbol stays on. Water isn’t going in to machine as well. Water supply from tap has been checked. Cycle runs till completion without water.

The return air hose is too short and not properly sealed, causing the gas heater to draw in insulation pieces and dust. The hose needs to be extended and sealed.