Find a reliable appliance technician in Marrickville

We need a technician/equipment repairer to replace the rubber door seal on our commercial oven. We believe the internal vent/fan panel or surrounding trim may need to be partially removed to access and fit the new seal. We will provide rubber/seal.

Hello! Looking for 1-2 individuals with their own truck and trolley to pick up and install a washing machine for us. Pick up location: TBA but likely within a 15km radius from Marrickville Drop off and installation site: Marrickville. We are a ground level home with only a few steps at the front door. We will also need help uninstalling and moving the old washing machine out of the way for the new one. If you can offer white goods removal for the old washing machine, please let us know how much extra that would cost. We are currently undecided on if we require that too. We look forward to receiving your quotes and talking soon!

Heat Glo gas heater. Pilot light on, gas flow but heater does not ignite. Was serviced last winter for same issue but now won’t turn on.

Omega oven. Oven won’t heat when turned on. Fan still whirling and lights come on. Grill setting does still work as well

Turn off gas to the house. Disconnect old gas / gas free-standing oven / stove top. Install and connect new gas/ gas free-standing oven / stove top. Reconnect gas and confirm safe operations.

commercial under bench not heating and draining. Need commercial dishwasher diagnosis + written report for insurance claim.

Washing machine fault — E1/IE error code (water inlet) Looking for an experienced whitegoods or appliance repair technician to diagnose and repair our washing machine. The issue: Every time we run a cycle, the machine fills with water, cycles a couple of times, then displays an E1 or IE error code, drains completely, and stops without completing the wash. What we’ve already checked: The inlet tap is fully open and the hose has no visible kinks. What we need: Someone to diagnose the root cause — likely the inlet filter, inlet valve, pressure sensor, or related component — and carry out the repair or advise on next steps. Details: • Location: Marrickville, Sydney • Please bring tools and common inlet valve parts if possible • Happy to discuss over message before booking Quotes welcome. Preference for someone with experience in LG machines.

Glem stove potentially leaking gas - needs servicing.

I require a technician who can repair the electrical system of s dog dryer. It looks that a regulator is faulty and needs to be replaced the piece is in the pictures. Please let me know your rate and your availability

Just need my gas cook top looked at a couple the burners turn on then turn off the pilot isn’t staying on at times. Could be a clink or gas blocked

Disconnect Bosch washing machine Move down 15 stairs and into garage Remove dryer from wall brackets

Install Westinghouse dishwasher

Fridge is leaking water and making loud sounds. Please service the fridge and fix the issue

Whipper snipper wont start, suspicions of a spark plus needing a replacement.

Fisher & Paykel E522B fridge. The fridge compartment previously lost cooling and the red temperature alarm began flashing/beeping when the door opens. After a full 24-hour manual defrost, the fridge is now over-cooling and freezing items, but the red alarm still flashes every time the door is opened. The freezer section has remained normal and both compressor and fan appear to run. It seems likely the fridge temperature sensor/thermistor or related control component needs replacement. Looking to diagnose and repair.

Hello! My front loader washing machine is having a drainage issue - I think something might be stuck in the hose or something and not sure how to get it off to have a look, just want someone who is experienced to have a suss and hopefully help fix the issue if there is one. As not sure how big an issue it could potentially be, initially just want someone to check it out and assess and then go from there :) (already cleaned out the filter and flushed out house etc) thank you!

Front loader fisher Paykel stops spinning in middle of cycle.when restarted works sometimes for full cycle

I need someone to retrieve the pump outlet/drain hose that has slipped back inside my Fisher & Paykel WD8560F1 8.5kg/5kg Front Load Washer Dryer Combo. It’s the small hose located at the bottom front of the machine (left hole in the attached photo). The hose itself is not broken — it has just fallen back inside the casing and I can’t reach it. This will likely require: • A torch/endoscope or inspection camera • A grabber tool / long retrieval tool I do NOT need the hose replaced — just safely pulled back out and repositioned. Located in Marrickville. Flexible with timing but would like it done ASAP.

My dryer (Euromaid DM4KG) stops working after a few minutes. I tried the following: Reset the whole machine. Clean the filters. Unfortunately, none of these solutions worked.

Hi, the rangehood fan in my main kitchen stopped working and I need help to replace it with the one from my spare kitchen please. Standard pull-out type range-hood fans with lights, both are identical and bought from Bunnings some years ago. The one in spare kitchen was rarely ever used. Photos attached. I’m located in Marrickville, flexible on times you can attend. I would think this is a relatively simple job for a professional and my budget for this job is $200. Please only respond if you have license and insurance to do this type of job please. Thank you.