Hire trusted appliance installation services in Melbourne

I need a qualified appliance technician to service and deep clean two Miele appliances in my apartment. The warranty has expired, and I am experiencing specific issues that require more than a surface wipe down. Appliances:::: Miele Washing Machine (Model WCA 020): Needs a full service, drain pump check, and internal drum clean. Miele Condenser Dryer (Model TCB 140 WP): CRITICAL ISSUE: Lint is escaping into the room during drying cycles, and dust is not being expelled. I suspect the internal condenser unit is clogged or the filter housing seal is compromised. Scope of Work Required:::: Dryer:::: Remove the bottom kickplate and extract the condenser unit. Deep clean the condenser fins (remove packed lint/dust) using a brush or low pressure water. Vacuum the internal fan housing and ducting behind the condenser. Inspect the rubber seal around the lint filter housing for tears or warping. Reassemble and run a test cycle to ensure no lint escapes. Washer:::: Clean the drain pump filter. Run a drum cleaning cycle (I can provide detergent or you can use yours). Check door seal for mold/debris. General:::: Wipe down exterior and check water hoses for leaks. Requirements:::: Must have experience specifically with Miele condenser dryers. Must have tools to safely remove and clean the internal condenser unit. Please provide your own vacuum with a long hose and brush attachments. If any parts (like a filter seal) need replacing, please quote me before purchasing. Location: [Focus Apartment Southbank] "IMPORTANT::: My budget Range: $150 – $350. Please provide a diagnosis and quote before starting any work. If the issue is just a clean, please quote a fixed price (Target: $150-$200). If parts are needed (e.g., seal, pump), please quote the parts cost + labor separately and get my approval before purchasing. If you find a major mechanical failure (motor/PCB) costing over $400, please stop and let me decide whether to repair or replace."

The rangehood needs to be secured to the cabinet as sections have broken off

I need to install a new 60cm slideout kitchen range hood. The old unit was removed and the space is prepared. The power point and the duct hose are already there. The only extra things that need to be done are a new hole in the shelf opening (the new unit has right-hand vent alignment) and trimming of the side panels

Our electric stovetop cracked and needs to be replaced. We have purchased the replaement stovetop plate and need someone to remove the old broken plate and install the new one. This will include connecting the hardwire. Photos of cracked stovetop have been uploaded on this task. Purchased stovetop to be installed is a Bellini 60cm Ceramic Cooktop. Same size and base size. Thank you!

* Appliance: Bamix Gastro 350. I need the appliance fix the problem is the following. The motor is fully functional, but it needs the following drivetrain components replaced. * Rubber Drive Coupling (OEM Part No:76587). * Drive Shaft Rubber Seal. * Drive Pin. I need a quote the includes both parts and labour & I need this done ASAP. Our budget to repair the device is flexible to a degree.

Need a qualified technician or handyman to replace an existing 53cm undermount rangehood in a Docklands apartment (883 Collins St). Current Unit: BLANCO BRU53X-3 (53cm Undermount Rangehood, faulty motor). Supply and install a compatible new 52cm/53cm undermount rangehood (can be different model preferably the same one)

Brand: Electrolux Model/Series: UltimateCare 500 It's a wash and dry combo but the dry function is not working.

The task involves removing an older 60cm Smeg Rangehood (SA480T) and installing a new 60cm Smeg Rangehood (STH600X1). I need to avoid modifications to external cabinetry. Internal adjustment, that is not visible, is okay. I have shown the specification for each rangehood in the pictures. Both rangehoods have the same dimensions, however I am not sure if there will be any issues with the existing duct diameter and duct hole position. See the attached pictures / photos which has dimensions / specifications. Location is an apartment building on St Kilda Road, Melbourne 3004.

I tried to install a microwave oven - unable to get it in properly.

Looking to install a new feed for an electric oven (15 amp) & an induction hob (32 amp) so I can remove gas appliances.

Hi we need to fix current commercial kitchen coving ... water gets into and stays ... so need to fill gaps underneath and put coving again and silicon it so not water goes inside ...

Looking for an experienced commercial kitchen ventilation installer to supply and install a flue connecting my commercial convection oven to the existing exhaust canopy. Job Details: - supply and Install a flue from the top of the oven to the side of the existing canopy (see attached photo). - Flue will need to come vertically from the oven, then bend 90° and run horizontally into the canopy. - Ensure the installation is secure, neat, and professionally finished. - Seal all penetrations and joints appropriately. - Advise if any additional supports or fittings are required. - Remove any rubbish on completion.

I have a toaster that runs on 15amp but requires a repair (see attached)

Replace an old rangehood (Coburg North) and install 2 new bathroom exhaust fans (Fawkner) in Single-floor old houses. The old rangehood is not working anymore. We bought the same one to replace it. Just need to install. The exhaust fan needs to have a hole made; there is a light and switch in the bathroom. You can connect the cable to it. The two houses are only 4 minutes away from each other. Very close.

My appliances are all functioning, but I sense they lack pep and need some technical TLC. The filter for the washing machine needs to be unscrewed and cleaned, the dryer needs a check over and the dishwasher isn’t cleaning the bottom drawer like it used to, though everything seems in order. Brands and models are shown in the photos. I’m only wanting qualified appliance technicians.

Hi, I purchased my washing machine 2 months ago and unfortunately there is already a tear inside the rubber seal. I’ve received a replacement seal but I need someone with the right tools, experience and knowledge of washing machines to install it.

Remove existing and install a pre-purchased oven

My LG washer dryer isn’t draining. Have checked online and done some tests and drain pump needs replacing. Model is WD1402CRD6 Miele integrated dishwasher had a glass break and since then, each time it drains it makes a funny noise. Drain hose needs a clear out.

Hello! Our fridge cable got tugged while moving and the prongs have disconnected, I have reconnected them but then need to be crimped to be secure and the black plastic case needs to be put back on. If you can help please let me know:)

Remove an old electric stovetop and install a new one.