Find a professional heating and cooling technician in Central London

The thermostatic valve on a shower needs cleaning or possibly replacing. It was installed to make servicing impossible. The valve 52mm nut cannot be accessed. The water supply to the shower is off. So, the shower unit needs to be unscrewed from inlet hot and cold supplies and outlets in order to access the valve. This is visit one. Then I will sort out the thermostatic valve. Once that is done - visit two, maybe a week or so later, will be reassembly and checking everything works with no leaks! The suggested price is one visit

We would like a kitchen cupboard built to match our other cupboards to cover our boiler.

Installation of hive 3rd gen hub with wifi for a Valliant combi boiler

I need a hole filled with fire retardant around the flue pipe from my boiler. I also need a wire grounded. The photo attached shows the green and yellow cable that needed to be earthed. You can see the corner of the pipe which comes form the boiler and leads outside the house.

Needs service it's a logic boiler I don't know but it comes on and no heating around the house not even in the pipe

My logic boiler showing L2 no heating is happening please need a heating or boiler specialist

The unit is working but control panel buttons are not working.

The red light on my Vokera boiler has come on and it needs fixing please.

The air conditioner is not blowing out cold enough air.

Baxi Duo-tec 40 Combi ErP boiler initially showing E119 low pressure. One of the filling valves appears stuck (might be doing something wrong), so I couldn’t repressurise it. It is now also showing E125. Looking for someone to fix the issue, ideally today. I can share pictures of the boiler, pressure gauge and valves.like to be a 5 minute job or less…

I have a daikin air conditioning system in my bedroom, the unit is second floor up outside wall. It goes in for 5 mins then turns off. No fault code showing might be out of gas?

My portable air conditioner is not cool enough. It is only working as a fan not as conditioners

small leak coming from uncapped pipe off boiler

De Longhi PAC EX130 Probe failure. NE2579 needs testing/replacing

The boiler the filling tap has stopped working. Water comes out of the tap itself, but the pressure gauge doesn't move at all now, so I can't get any pressure into the system. That means no hot water at all now.

Have recently had boiler installed and contractor had to cut out a small hole in ceiling for new flue. Need someone to re plaster the ceiling - also open to offers for those who can re plaster and paint in the same day

I need a plumber to re-pressurize my boiler and to tighten the bathroom heater as it’s leaking at 8 AM on the 9th July 2026 please. I have guest staying in my flat and the only time they can do is 8 AM tomorrow morning.

You must be a plumber or a heating engineer. Boiler diagnosis completed as follows below and need someone to replace both parts. Parts to be ordered separately and not included in price here. - system pressure was low. I topped up the pressure and reset the boiler; however, the boiler still failed to fire. The appliance was displaying the fault code shown in the photographs provided. I referred to the manufacturer's instructions, which identify this fault as relating to the gas valve. I then contacted the manufacturer directly to confirm, and they advised that the fault is associated with the gas valve and ignition electrodes, with replacement of these components being the recommended course of action. The active fault codes displayed on the front of the boiler provide a clear indication of the fault condition being detected by the appliance, and the manufacturer has confirmed that these codes relate to the gas valve and ignition electrodes.

There’s a gap beneath my boiler that needs to be covered as it’s a possible entry point for mice. The pest control company has asked for a Perspex sheet to built and siliconed in place around the boilers paperwork. Would need to be custom fitted and make w a jigsaw. Thanks

Hi, I’m looking for a professional decorator or handyman to repair and repaint water-damaged walls in the common stairwell area of my apartment in NW3 London. There was previously a leak from my boiler (faulty ball valve), but this has now been fixed and the area is drying out properly. The walls currently have: • Brown water staining • Flaking / bubbling paint • Some minor plaster damage • Light mould in one lower corner I want the job done properly so the staining doesn’t come back through. The job likely requires: • Scraping back all loose paint • Treating any mould • Sealing with stain-blocking primer (e.g. Zinsser) • Filling / patch plaster repair where needed • Sanding smooth • Repainting (white/neutral to match existing) This is in a stairwell so access may require care (not very high ceilings but awkward angles). I’m not looking for a quick paint-over, I want it done properly so the issue doesn’t return. Location: NW3 London Flexible on timing but ideally within the next 1–2 weeks. Thanks!