Find a professional heating and cooling technician in Central London

I need a plumber to re-pressurize my boiler and to tighten the bathroom heater as it’s leaking at 8 AM on the 9th July 2026 please. I have guest staying in my flat and the only time they can do is 8 AM tomorrow morning.

The valves are quite worn out. Can you please help me clean it and tighten it up? Please feel free to text me with other optional solutions for it. It should have been leaking a bit and looks quite rusting now. Thanks

Replace Combi Boiler with same, currently installed Vaillant Ecotec Plus 832. This is a 32kwh unit and I would like to replace it with a similar Vaillant unit Pipe work is in place and should be a fairly east swap with good access. Supply and fit required.

Install 20 square metres of WUNDA 20mm Rapid Response underfloor heating system. Ground floor kitchen, small toilet and landing. Concrete floor, that has been levelled.

This is an American LG air conditioner unit. I have a step down power converter. The fuse keeps blowing after 3 mins of use. It worked well for one summer but now keeps blowing the fuse of the power converter.

a Dreo electronic heater, a foldable clothes airer and a rice cooker

Hot water stopped working consistently. Works every now and then.

The water on my valiant boiler is low so there’s no hot water. It’s something i normally can myself, unfortunately I’m currently out of town and the hit water is needed.

We need someone to check why we have no hot water before 8am every morning & supply/fit new spotlights in house approx 15 new ones

Chase boiler and water pipes.

Chase copper and white plastic pipes in wall. Boiler other side of wall outside. Want to fit fridge freezer in corner where the pipes are.

We have a fully functioning Tado smart heating system around the house. One bedroom Tado thermostat is continuously failing to connect or work, despite completely changing it twice.

Lay 100mm insulation between rafters, and 170mm insulation on top to insulate a cold loft. Small amount of loft boarding to be fitted too. Old insulation to be bagged and removed. New wool insulation and loft board will be on site, so fitting required Loft space is approx 40m2, and low headroom

Mitsubishi inverter air conditioning is leaking. I think there must be some thing blocking the PVC drain pipe from flushing the water outside. Need help fixing the leak possibly by pouring some mixture or sucking it via a vacuum.

Looking for a local mobile mechanic to replace the engine thermostat housing assembly on a 2006 VW Polo. Parts Already On-Site: I have already purchased the brand-new complete Firstline housing assembly (includes the thermostat, new seals/O-rings, and the sensor) and a fresh bottle of G12 pink coolant. The Job: Straightforward unbolt-and-bolt swap on my driveway, followed by a quick cooling system bleed and top-up. Location: North London Payment: £50 flat rate for labour.

You must be a plumber or a heating engineer. Boiler diagnosis completed as follows below and need someone to replace both parts. Parts to be ordered separately and not included in price here. - system pressure was low. I topped up the pressure and reset the boiler; however, the boiler still failed to fire. The appliance was displaying the fault code shown in the photographs provided. I referred to the manufacturer's instructions, which identify this fault as relating to the gas valve. I then contacted the manufacturer directly to confirm, and they advised that the fault is associated with the gas valve and ignition electrodes, with replacement of these components being the recommended course of action. The active fault codes displayed on the front of the boiler provide a clear indication of the fault condition being detected by the appliance, and the manufacturer has confirmed that these codes relate to the gas valve and ignition electrodes.

There’s a gap beneath my boiler that needs to be covered as it’s a possible entry point for mice. The pest control company has asked for a Perspex sheet to built and siliconed in place around the boilers paperwork. Would need to be custom fitted and make w a jigsaw. Thanks

Hi, I’m looking for a professional decorator or handyman to repair and repaint water-damaged walls in the common stairwell area of my apartment in NW3 London. There was previously a leak from my boiler (faulty ball valve), but this has now been fixed and the area is drying out properly. The walls currently have: • Brown water staining • Flaking / bubbling paint • Some minor plaster damage • Light mould in one lower corner I want the job done properly so the staining doesn’t come back through. The job likely requires: • Scraping back all loose paint • Treating any mould • Sealing with stain-blocking primer (e.g. Zinsser) • Filling / patch plaster repair where needed • Sanding smooth • Repainting (white/neutral to match existing) This is in a stairwell so access may require care (not very high ceilings but awkward angles). I’m not looking for a quick paint-over, I want it done properly so the issue doesn’t return. Location: NW3 London Flexible on timing but ideally within the next 1–2 weeks. Thanks!

I would love a quote for a Boiler Timer replacement for my 1 bed flat. The boiler itself works fine, but it has to be turned on and off manually. The existing timer attached to the water heater switch is completely unresponsive - it does not display anything or respond to my attempts to reset. I have been operating the water heater manually since I moved in but would like to install a new digital timer so that I can program water heating automatically and easily. The boiler only affects hot water as my radiator system is electric. I would prefer this job to be completed in one visit so would like the replacement timer to be sourced by yourselves in advance or to be given guidance on which to order in advance so that it is ready to install on the same day as your visit.