Find a professional heating and cooling technician in East London

Help set the Salaus thermostat and programme it for morning and evening temperatures. Then check the 5 heaters in the house to make sure working well. One of the heaters does not seem to turn off.

I have two Danfoss TP7001M mains-powered programmable thermostats controlling heating on separate floors of my duplex flat. Both thermostats suddenly stopped working. When I switch the central heating circuit off and back on at the consumer unit, both displays operate normally for approximately two minutes before going completely blank again. The circuit breaker remains ON. The flat uses a Danfoss district heating HIU. Domestic hot water is currently working. I need an experienced electrician or heating-controls specialist to investigate the common electrical supply, wiring, fused connections and thermostat control circuits, identify the cause and repair it.

I recently moved into my new flat, but upon a visit by British Gas, I found out that the boiler didn’t meet compliance regulations. I need this done before I Airbnb it out for a few weeks from 21st Oct. The things that need to be done are 1. Remove the non-heat resistant foam around the pipe at the top going to the vent outside. 2. Cementing around the pipe/vent on inside and outside to seal it 3. Stick the tiles back to the wooden panel under the boiler and make it so it is easy to access the taps when needed (they weren’t accessible before) 4. Remove some of the board around the boiler. You will need to bring your own materials e.g. cement, tile adhesive, grout, saw etc. Thanks

The radiator is not heating up in the bathroom

The next day I'm having the ceilings replaced so I need to go into the loft and remove the insulation and bag it up for storage. The area is approx 40m^2. Not sure how long this will take. I can provide large refuse sacks to put the insulation into. You will need your own PPE.

install shelf below tv.shelf provided, please bring own tools. remantle boiler cupboard.

Replace central heating pipework Looking for a qualified plumber/heating engineer to replace all central-heating pipework in my 3-bed house using 15mm/22mm HEP₂O barrier pipe. Boiler downstairs by the front door. Approximately 7–8 radiators. I will supply and fit the radiators myself along with hep20 22mm and 15mm barrier pipe and fittings so the job is to Install the new 22mm flow/return mains and 15mm branches to each radiator, leaving connections ready for me. Upstairs, pipework only needs to go under the middle/dressing-room floor; elsewhere I want it run above floor level and accessible as itll be boxed in Any joins/tees should be positioned where a discreet access panel can be fitted, rather than buried permanently under floors/walls. Please quote for: Pipework installation only Optional price to connect the radiators, fill, bleed, balance and test the system. I have attached the floor plan

Intermittent Hot Water: The boiler randomly stops delivering hot water. This has been happening off and on for the last few weeks.alsoThe boiler pressure occasionally drops and needs topping up. Its a ideal boiler, logic

Need thermostat fixed please! Heating works fine, the device itself needs fixing in order to help us regulate the heating

We have no hot water. It appears the thermostat needs replacing

The sensor light in my boiler cupboard isnt working properly and keeps going on and off at random times. I need that repaired please.

Move boiler 60mm (24 inches) to the left from its existing position The height is same. All the pipe works will need to be extended by about 50-60 mm under the floorboards, the floor boards are easily accessible. Labour only. Material will be supplied. Experience persons only

Was switching boiler on and off from the switch now it won’t turn on. I’m assuming the fuse blew or something? Need someone to come and fix it

Element needs replacing in Bosch fan oven. It have the part just needs putting in.

Olsen & Smith 12000 BTU 3-in-1 Portable Air Conditioning Unit won't turn on. Was working fine one day, no power the next. No obvious visible damage or flaws.

I need a hetas registered engineer or such to connect a chimney and our pellet burner. Pellet burner in situ but needs connecting to chimney and fresh air feed.

Hello, I need a boiler service certificate for a boiler in my restaurant. I believe the boiler itself is a domestic-type boiler, although it is installed in a commercial property. I have attached a photo of the boiler so you can check. The boiler is working perfectly fine. My main reason for arranging this is that my landlord has asked me to provide a valid boiler service certificate. I would therefore need the inspection/service to be carried out by someone who is properly qualified and authorised to issue a valid certificate. I would prefer not to have unnecessary work carried out on the boiler since it is working fine, but if servicing is required in order to issue the certificate, that is absolutely fine. Could you please let me know if you can do this and how much you would charge? Thank you.

We would want to install a brand new boiler tap near the kitchen sink. Its a first time installation

To check all connections to the boiler/wiring centre and thermostats and commission our underfloor heating.

I would like my boiler to be boxed up from top to bottom, you will need to provide materials