Find a trusted local electrician in Ealing

I need to remove my air condition split A/C unit from wall for plasterboard; skim and than put the unit back in about 7-10 days time

Scope of Works 1) Safely disconnect and terminate existing bathroom extractor fan. 2) Remove and replace existing single kitchen dimmer switch. 3) Remove and replace existing wall socket. Note: replacement dimmer switch and socket to be supplied by homeowner

The old light fitting has already been removed. The ceiling rose has several wires (L, N + extra wires, see photo), while the new light only has 3 wires (Live, Neutral, Earth). The job will involve: • Identifying the live and neutral wires • Safely isolating/capping off the unused wire(s) — possibly a switching wire or a feed to another light point • Connecting and fitting the new light securely to the ceiling I already did the same job in the room next door without issue, since that ceiling had the same number of wires as the new light. This one is just slightly trickier because of the extra wires. Please bring your own tools/materials (wago connectors, screwdriver, voltage tester). Happy to share more photos of the wiring on request.

I have a ceiling light fixture I need swapped. I don’t have a ladder.

Repurpose existing 32A “Oven” circuit in consumer unit for a 7.2kW induction hob. Old oven circuit is no longer required as new oven is 13A plug-in. I want a new cable run from the consumer unit to the hob on the opposite kitchen wall, rather than extending the existing cooker cable from the old oven location. Please include cooker isolation switch/connection point.

Hi, I’m looking for an NICEIC or NAPIT approved electrician to carry out a third-party inspection and certification (TPC) for a full residential rewire. Project details: Full flat + loft rewire Approx. 80 electrical points New consumer unit already installed I need inspection, testing, EIC certificate, and Part P notification Please let me know: Your experience with third-party certification Whether you are NICEIC or NAPIT registered Estimated cost range Earliest availability Thanks

I need a competent roofer/handyman to install 4 × Aiko Neostar 2S 465W solar panels on the SE-facing slated roof of a new-build house in W7. Scope of work: Collect the 4 rigid panels from ground level (each 21 kg, 1757 × 1134 mm – will not fit through Velux window). Carry panels safely up ladder to roof. Fit panels using the mounting kit I will supply (rails, slate hooks, flashing, clamps). Run 4 pairs of MC4 extension cables neatly down the roof and into the top-floor bedroom via Velux or suitable entry point. Secure cables on roof and inside loft/bedroom area. Important: No electrical work required on consumer unit, RCD board, or any wiring. All mounting hardware and cables will be supplied. Just mechanical fixing and cable routing. Please quote for the full job including ladder access and safe handling of panels.

The toilet flush fills very slowly and one of the tap has low flow for hot water. Two electric sockets don't seem to work. I'm looking to hire someone qualified who can do both these jobs.

Install ceiling light in the living room

Remove inbuilt electric oven and connect new one

Buzzing sound when switching on light

See images below of light switches and tv

When I try to press the light button, the light comes on but the button does not stay down

Electric oven installation

I need 2 lights in total put up in each bedroom

Two plug sockets need replacing In the house

I want an electrician to install an electric cooker for me and give me a certificate

I need an Electric cooker installer

New light needs installing

I have a new light fitting which needs to be installed. I have the bulb too. We have a ladder. Ceiling height approx 3 meters. Photo of current and new fitting.