Hire a reliable appliance service in Essex

Dishwasher is bought, it fits in the unit, it just needs connection to water supply and water out pipes.

I need a washing machine fitted the old appliance is already been detached the new one is outside the front door I needs to be bought in and fitted and the old one taken back outside the front door it doesn’t need to be removed or taken down any stairs just put outside the front door I’m happy to help carry it in and out

Belt replacement for my Matrix TF30 Please note that I don't have the belt.

Task Title: Install Washing Machine Plumbing (Cold Water Valve & Waste Spigot) Job Description: Looking for a plumber or experienced handyperson to plumb in a washing machine under a kitchen sink. Photos of the existing under-sink layout are attached. Scope of Work: Cold Water Supply: Cut into an exposed 15mm horizontal copper pipe and fit a 15mm × ¾" washing machine isolation valve (compression or push-fit). Drainage: Fit a 40mm appliance spigot/tee (e.g., McAlpine V33S) into the existing sink waste drop, knock out the internal blanking plug, and secure the washing machine drain hose with a jubilee clip (with a high loop to prevent backflow). Hookup & Testing: Connect both hoses to the washing machine, restore mains water, and run a quick spin/drain cycle to test for leaks under pressure. Details & Requirements: Estimated Time: 1 to 1.5 hours. Required Parts (Compression Route) ​Waste Pipe Spigot: McAlpine V33S Domestic Appliance Tee Connector 40mm – Screwfix Code: 4167P (£4.72) ​Cold Water Supply Valve: Flomasta Compression Washing Machine Valve Tee 15mm × 15mm × ¾" – Screwfix Code: 60723 (£2.79) ​Hose Clamp: Easyfix Zinc-Plated Hose Clips 20–32mm (Pack of 10) – Screwfix Code: 46961 (£2.98)

Had to replace an intergrated washine machine and need the decor door to be drilled to rehang the decor door

Pipe on our dishwasher popped off

I have a commercial NordicTrack 2450 that powers on fine but as soon as I start the running belt it trips my home circuit.

THE MACHINE COMES BUT DOES GET HOT

I have a five burner gas hob fitted into the work top, 3 of the burners has stopped working, when you press the knob it sparks and lights on some of the burner but as soon as you let go the gas cuts off, is there anyone who can help with this, I need it sorted as soon as possible. Also the big burner has stopped working, not sure what the issue is.

My electric recliner sofa just suddenly stopped working after it was extended. It has stayed in that extended position. Upon checking, I can see that there’s something broken behind the chair (picture attached).

My dryer is making about noise when Turing on I am looking for someone to come and check the dryer to see if it’s salvageable or if I need to purchase new.

I need an old integrated 50/50 fridge freezer disconnected and removed , an a new one installed. New appliance already purchased

3 blinds to be cut down to size and put up on the walls in the bracket Extractor fan to be put up also over oven Potentially curtains to be added up also And shower screen- tbc

Electric adjustable bed has stopped reclining.

I would like my hob and oven replaced. I have the new hob and oven so I’d like you to remove the old ones and install the new ones.

I have a new intergrated fridge freezer that needs replacing

I have a treadmill that needs a servics

When I switch on the oven, it then just switches off.

It will not power up, and one fader needs replacing

Please can I have an assistance connecting a hotpoint washing machine.