Hire a reliable appliance service in Surrey

Oven needs wiring into wall today

I have a down draft extractor in my kitchen. De Dietrich. The extractor works fine. However, the movement mechanism which takes it down into the recess in the platform, stuck about 3 inches off from the platform. The movement then comes back to starting position. It is possible there is some dirt or obstruction in the movement mechanism. Needs investigation and fixing. First 2 photos are the extractor in fully open position. The third photo is the lowest level to which it goes into the recess and the point at which it starts going back up again.

There is error on my treadmill... It starts but turns off on its own

Toaster not heating up . Lights come on but no heat .

Treadmill keeps catching not.smooth

Every time we use our washing machine there is a bad eggy smell. We have tried running hot cycles with baking soda and but the issue persists.

When I switched the machine on the treadmill doesn't work.

karcher 110v year 2019 s/n 012246 1.520-965.0 50HZ max 60 deg nozzle 030

Hotpoint dishwasher - error message is: LTF1131 1st Light Only/General Flashing Frequently indicates an overflow or anti-flood switch activation F01

I bought this at an auction and the wiring is complicated. It may be fine but might need some repair

Freezer door wont close. Broken seal or magnet. Rain shower head needs replacing.please provide parts.

We need an electrician to have a look at the fuses in the kitchen and look at what might be causing problems with the dual oven range and the microwave. one of the ovens works but the other oven works sometimes and then goes off making us believe its an electrical problem. The fuse also often trips in the kitchen meaning it needs to be reset at the box.

milky fluid discharge from bottom of the casing- oil water mix leak? Unit still runs

Nordic Tara k c700 Lost my bolts when dismantled for storage. Would like a service too

Need dishwasher installed

ProForm Power 575i Treadmill that requires repairing. In brand new otherwise as we barely used it before it decided to burn out on us. But it's up for grabs if you want it for free and try to repair and re-sell, needs new motor and control board most likely. Otherwise to the dump it must go. Its heavy, circa 75kg I think.

I have a replacement door seal for my washing machine but I am having trouble fitting it myself. I need someone who has done this before to come and fit it

Sole Treadmill F85, power light on to treadmill but main panel not appearing / firing up. This was intermitate at the start and now completely dead.

Treadmill Nordick Track needs a service. Probably just oil I guess. Makes a funny noise when working around the motor area.

To install a new washing machine