Hire a reliable appliance service in Surrey

We would like a old radiator taken off the wall and a new radiator fitted. The new radiator is cast iron so is heavy, it come in two part and I have all the bits to fit it.

We have a gas hob currently fitted on a worktop. This needs to be removed and a new gas hob fitted. We will have the new gas hob here ready to be fitted. We need a Gas Safe registered engineer to do the fitting work. It needs to be done by tomorrow Saturday 14 February.

Ikea VASASTAN 305.234.46 Needs to be installed as a new hob and old hob removed

De’longhi electra coffee machine won’t deliver water to the cup

Replace integrated fridge freezer. Ideally take away old fridge

Water doesn't come out of the group head

Drainage issue with Bosch washing machine

My neff Fridge freezer circuit board is faulty works for while then goes off. No power . After few hours when plugged in again comes on for while then goes off again.

Gas cooker has 5 burners. On one of them, the flame comes on as normal when turned on but the flame doesn’t stay when you release the knob. I believe the thermocouple needs to be replaced for that burner.

Indesit washing machine not working and blinking. It’s PCB might be problem. Also we have integrated fridge whose door is getting broken. 2 out of 3 hinges are broken and needs replacement.

Vacuum cleaner not working

We have been having issues with our tumble dryer. We had someone remove the circuit board and it had some damage. We have had this repaired and now just need the board putting back in. Picture of circuit board attached. Hopefully a very quick job for someone who knows what they are doing! The dryer is a Bosch WTA 74200GB.

The curved treadmill is not working properly. The belt feels like it is on a very high resistance. It is turning but with a lot of effort

I need a cupboard removing/adjusting to make space for a dishwasher and then dishwasher plumbed in

I have an office chair whose gas cylinder was loosing pressure, so I bought a new gas cylinder to replace it. However, whatever I tried (wooden and metal hammer, pliers, plumber pliers, etc) I was unable to remove the old gas cylinder from the base. I am on a budget, as I cannot spend too much on an old chair. It is rather urgent. Thank you.

Treadmill Nordick Track needs a service. Probably just oil I guess. Makes a funny noise when working around the motor area.

The cooker Hood is not working after the cleaner tried to clean it. It starts with delay and only works in the highest speed.

The lightbulb in our microwave has gone out and we need it replaced. However, we aren’t familiar with electrical work so we would like to have a professional do it.

To install a new washing machine

My washing machine has moved and needs to be pushed back so that I can open my door.